Evaluation of Sodar methods for the determination of the atmospheric boundary layer mixing height

2003 ◽  
Vol 85 (1-3) ◽  
Author(s):  
D. N. Asimakopoulos ◽  
C. G. Helmis ◽  
J. Michopoulos
Atmosphere ◽  
2019 ◽  
Vol 10 (11) ◽  
pp. 711 ◽  
Author(s):  
Odintsov ◽  
Gladkikh ◽  
Kamardin ◽  
Nevzorova

The structural characteristic of the refractive index of optical waves was calculated from experimental data on the microstructure of the temperature turbulence in the atmospheric boundary layer. The experimental data were obtained with an acoustic meteorological radar (sodar), ultrasonic anemometer–thermometer, and meteorological temperature profilometer. Estimates of the structural characteristics for different conditions in the atmospheric boundary layer are presented and were compared with model profiles.


2006 ◽  
Vol 49 (3) ◽  
pp. 556-566
Author(s):  
Lionel ELLIOTT ◽  
Derek Binns INGHAM ◽  
Stephen David WRIGHT

2011 ◽  
Vol 4 (2) ◽  
pp. 143-149 ◽  
Author(s):  
C. A. Keller ◽  
H. Huwald ◽  
M. K. Vollmer ◽  
A. Wenger ◽  
M. Hill ◽  
...  

Abstract. A new method for measuring air temperature profiles in the atmospheric boundary layer at high spatial and temporal resolution is presented. The measurements are based on Raman scattering distributed temperature sensing (DTS) with a fiber optic cable attached to a tethered balloon. These data were used to estimate the height of the stable nocturnal boundary layer. The experiment was successfully deployed during a two-day campaign in September 2009, providing evidence that DTS is well suited for this atmospheric application. Observed stable temperature profiles exhibit an exponential shape confirming similarity concepts of the temperature inversion close to the surface. The atmospheric mixing height (MH) was estimated to vary between 5 m and 50 m as a result of the nocturnal boundary layer evolution. This value is in good agreement with the MH derived from concurrent Radon-222 (222Rn) measurements and in previous studies.


2010 ◽  
Vol 10 (2) ◽  
pp. 341-364 ◽  
Author(s):  
A. Jeričević ◽  
L. Kraljević ◽  
B. Grisogono ◽  
H. Fagerli ◽  
Ž. Večenaj

Abstract. This paper introduces two changes of the turbulence parameterization for the EMEP (European Monitoring and Evaluation Programme) Eulerian air pollution model: the replacement of the Blackadar in stable and O'Brien in unstable turbulence formulations with an analytical vertical diffusion profile (K(z)) called Grisogono, and a different mixing height determination, based on a bulk Richardson number formulation (RiB). The operational or standard (STD) and proposed new parameterization for eddy diffusivity have been validated in all stability conditions against the observed daily surface nitrogen dioxide (NO2), sulphur dioxide (SO2) and sulphate (SO42−) concentrations at different EMEP stations during the year 2001. A moderate improvement in the correlation coefficient and bias for NO2 and SO2 and a slight improvement for sulphate is found for the most of the analyzed stations with the Grisogono K(z) scheme, which is recommended for further application due to its scientific and technical advantages. The newly extended approach for the mechanical eddy diffusivity is applied to the Large Eddy Simulation data focusing at the bulk properties of the neutral and stable atmospheric boundary layer. A summary and extension of the previous work on the empirical coefficients in neutral and stable conditions is provided with the recommendations to the further model development. Special emphasis is given to the representation of the ABL in order to capture the vertical transport and dispersion of the atmospheric air pollution. Two different schemes for the ABL height determination are evaluated against the radiosounding data in January and July 2001, and against the data from the Cabauw tower, the Netherlands, for the same year. The validation of the ABL parameterizations has shown that the EMEP model is able to reproduce spatial and temporal mixing height variability. Improvements are identified especially in stable conditions with the new ABL height scheme based on the RiB number.


1996 ◽  
Author(s):  
Christian Werner ◽  
Friedrich Koepp ◽  
Rolf Heilmann ◽  
Stephan Rahm ◽  
Juergen Streicher

Sign in / Sign up

Export Citation Format

Share Document