scholarly journals Analysis and evaluation of distributed photovoltaic generation in electrical energy production and related regulations of Turkey

Author(s):  
Mehmet Çeçen ◽  
Cenk Yavuz ◽  
Ceyda Aksoy Tırmıkçı ◽  
Sinan Sarıkaya ◽  
Ertan Yanıkoğlu
2016 ◽  
Vol 13 (05) ◽  
pp. 134-141
Author(s):  
Moussaoui Abdeljabar ◽  
Mebarki Brahim ◽  
Sakhri Nasreddine ◽  
Draoui Belkacem ◽  
Rahmani Lakhdar

2019 ◽  
Vol 113 ◽  
pp. 03005
Author(s):  
Enrico Valditerra ◽  
Massimo Rivarolo ◽  
Aristide F. Massardo ◽  
Marco Gualco

Wind turbine installation worldwide has increased at unrested pace, as it represents a 100% clean energy with zero CO2 and pollutant emissions. However, visual and acoustic impact of wind turbines is still a drawback, in particular in urban areas. This paper focuses on the performance evaluation of an innovative horizontal axis ducted wind turbine, installed in the harbour of Genova (Italy) in 2018: the turbine was designed in order to minimize visual and acoustic impacts and maximize electrical energy production, also during low wind speed periods. The preliminary study and experimental analyses, performed by the authors in a previous study, showed promising results in terms of energy production, compared to a traditional generator ( factor >2.5 on power output). In the present paper, the test campaign on a scaled-up prototype, installed in the urban area of Genova, is performed, with a twofold objective: (i) comparison of the ducted innovative turbine with a standard one, in order to verify the increase in energy production; (ii) analysis of the innovative turbine for different wind speeds and directions, evaluating the influence of ambient conditions on performance. Finally, based on the obtained results, an improved setup is proposed for the ducted wind turbine, in order to further increase energy production mitigating its visual impact.


1988 ◽  
Vol 110 (2) ◽  
pp. 107-112 ◽  
Author(s):  
J. H. Morehouse

Two thermodynamic power cycles are analytically examined for future engineering feasibility. These power cycles use a hydrogen-oxygen fuel cell for electrical energy production and use the thermal dissociation of water for regeneration of the hydrogen and oxygen. The first cycle uses a thermal energy input at over 2000K to thermally dissociate the water. The second cycle dissociates the water using an electrolyzer operating at high temperature (1300K) which receives both thermal and electrical energy as inputs. The results show that while the processes and devices of the 2000K thermal system exceed current technology limits, the high temperature electrolyzer system appears to be a state-of-the-art technology development, with the requirements for very high electrolyzer and fuel cell efficiencies seen as determining the feasibility of this system.


2019 ◽  
Vol 116 ◽  
pp. 00023
Author(s):  
Andrzej Gajewski

To limit greenhouse gases emissions caused by energy production European Union (EU) prompts heat pump as heat generator which should decrease CO2 emissions to the atmosphere. Because of the climatic conditions and low efficiency of electrical energy production and transfer in Poland it could be possible a condensing gas boiler would emit less CO2. The analysis includes ten-year temperature measurements in Białystok where is more severe climate in Poland. Due to relatively high seasonal coefficient of performance (SCOP) value heat pumps can emit less CO2 than condensing gas boiler and can be applied as ecological heat generators.


2016 ◽  
Vol 318 ◽  
pp. 283-290 ◽  
Author(s):  
Guillermo R. Iglesias ◽  
Silvia Ahualli ◽  
María M. Fernández ◽  
María L. Jiménez ◽  
Ángel V. Delgado

2021 ◽  
Vol 13 (9) ◽  
pp. 4881
Author(s):  
Fariha Kanwal ◽  
Ashfaq Ahmed ◽  
Farrukh Jamil ◽  
Sikander Rafiq ◽  
H. M. Uzair Ayub ◽  
...  

This study investigated the co-combustion of the blends of coal and biomass residues from poplar sawdust, rice husk, pine nut shells, and sunflower residues for ecofriendly energy production. Proximate and ultimate analyses and calorific values of the coal and biomass residues were also carried out to evaluate the properties of the coal and biomass residues. The volatile matter in coal was reported as 43.38 wt% and ranged from 56.76 wt% to 80.95 wt% in the biomass residues. The ultimate analysis reported the carbon and sulfur content of coal as 68.7 wt% and 5.5 wt%, respectively. The coal and biomass blends were prepared using different ratios on the thermal basis of coal and biomass given as 100:0, 90:10, 80:20, 70:30, 60:40, and 50:50 by weight percentage. The consequent stoichiometric air requirements for all the blends were also calculated. The results revealed that the combustion of 60:40 of coal and sunflower residue blend was the most efficient blend, resulting in less emission of NOx, SOx, and CO2 in the flue gas compared to the combustion of pure coal. The study revealed a great perspective of the selected biomass residues to blend with coal for environmentally friendly and sustainable energy production.


Sign in / Sign up

Export Citation Format

Share Document