Behavior and aquatic plants as factors affecting predation by three species of larval predaceous diving beetles (Coleoptera: Dytiscidae)

Hydrobiologia ◽  
2009 ◽  
Vol 637 (1) ◽  
pp. 33-43 ◽  
Author(s):  
Donald A. Yee
Hydrobiologia ◽  
1964 ◽  
Vol 23 (3-4) ◽  
pp. 533-543 ◽  
Author(s):  
M. Owens ◽  
P. J. Maris

Weed Science ◽  
1970 ◽  
Vol 18 (1) ◽  
pp. 7-9 ◽  
Author(s):  
W. H. Peltier ◽  
E. B. Welch

Water samples were taken from Pickwick Reservoir from 1965 through 1968 and the nitrogen and phosphorus content determined. The nitrogen and phosphorus content over a period of 3 years was not related to the year-to-year plant growth. Physical and climatic data were obtained from 1961 through 1968, and it was found that available light was controlled by the amount of rainfall and ensuing reservoir elevation during the critical plant growth period in April and May. Available light was correlated with the 2 years of severe infestations.


2020 ◽  
Vol 17 (35) ◽  
pp. 227-238
Author(s):  
Neran A. AL NAQEEB ◽  
Fouad K. MASHEE ◽  
Jinan S. AL HASSANY

Epiphytic algae adherent to aquatic plants are an essential link in the composition of the food chain of any ecosystem. Epiphytic algae act as primary producers of the food chain in the aquatic ecosystem and as natural food for herbivorous zooplankton and fish. This study aimed to detect the presence of algae colonies through remote sensing and to analyze factors that affect the growth of algae through field survey and visual interpretation of satellite images in Lake Um El-Naaj. Samples were collected from six locations on Lake Um El-Naaj from November 2018 to June 2019. The algae samples were collected from submerged parts of emerging aquatic plants (aquatic macrophytes Phragmites australis) and stored in plastic bags with little ambient water and solutions for preservation in the field and the laboratory. Water samples were collected to study the nutritional factors that influence the growth of algae, including the concentration of Phosphate, Nitrate, and Silica (silicon dioxide). The results showed that the values of total phosphorus increased by 1.0, 0.9, and 0.8 mg/L, in January, in places 2, 5, and 6, respectively. The highest nitrate value was 11.2 mg/L in December at site 5, while the lowest concentration values were in November (2.2 mg/L at site 6 and 3.7 mg/L at site 4). Besides, the lowest silicate concentration was 0.4 mg/L in November at site 2, while the highest was 2.4 mg/L in June 2019 at site 6. Based on the findings, it is possible to conclude that, during the winter, the water level increased due to the rain. For this reason, nutrient concentrations were low during the last period. Also, with the use of maps and remote sensing techniques, it is possible to determine the expected values around the station's location as future predictive readings that compensate for the difficulty of reaching these areas.


Author(s):  
F. A. Heckman ◽  
E. Redman ◽  
J.E. Connolly

In our initial publication on this subject1) we reported results demonstrating that contrast is the most important factor in producing the high image quality required for reliable image analysis. We also listed the factors which enhance contrast in order of the experimentally determined magnitude of their effect. The two most powerful factors affecting image contrast attainable with sheet film are beam intensity and KV. At that time we had only qualitative evidence for the ranking of enhancing factors. Later we carried out the densitometric measurements which led to the results outlined below.Meaningful evaluations of the cause-effect relationships among the considerable number of variables in preparing EM negatives depend on doing things in a systematic way, varying only one parameter at a time. Unless otherwise noted, we adhered to the following procedure evolved during our comprehensive study:Philips EM-300; 30μ objective aperature; magnification 7000- 12000X, exposure time 1 second, anti-contamination device operating.


Author(s):  
Christine M. Dannels ◽  
Christopher Viney

Processing polymers from the liquid crystalline state offers several advantages compared to processing from conventional fluids. These include: better axial strength and stiffness in fibers, better planar orientation in films, lower viscosity during processing, low solidification shrinkage of injection moldings (thermotropic processing), and low thermal expansion coefficients. However, the compressive strength of the solid is disappointing. Previous efforts to improve this property have focussed on synthesizing stiffer molecules. The effect of microstructural scale has been overlooked, even though its relevance to the mechanical and physical properties of more traditional materials is well established. By analogy with the behavior of metals and ceramics, one would expect a fine microstructure (i..e. a high density of orientational defects) to be desirable.Also, because much microstructural detail in liquid crystalline polymers occurs on a scale close to the wavelength of light, light is scattered on passing through these materials.


1990 ◽  
Vol 54 (11) ◽  
pp. 638-643 ◽  
Author(s):  
PC Damiano ◽  
ER Brown ◽  
JD Johnson ◽  
JP Scheetz

Sign in / Sign up

Export Citation Format

Share Document