“Metal-Reservoir” Carbon-Based Nanocomposite Coating for Green Tribology

2015 ◽  
Vol 59 (2) ◽  
Author(s):  
Xiaoli Wei ◽  
Guangan Zhang ◽  
Liping Wang
2004 ◽  
Vol 03 (04n05) ◽  
pp. 571-578 ◽  
Author(s):  
S. ZHANG ◽  
X. L. BUI ◽  
Y. FU ◽  
H. DU

Metallic Al was doped into amorphous carbon (a-C) to form a matrix of a-C(Al) of very low residual stress and high toughness at the expense of some hardness. Nanocrystallites of TiC (nc-TiC) of a few nanometers in size were embedded in this matrix to bring back the hardness. The nanocomposite coating of nc-TiC/a-C(Al) was deposited via co-sputtering of graphite, Ti , and Al targets. Although the nanocomposite coating exhibited a moderately high hardness (about 20 GPa), it possessed extremely high toughness (about 55% of plasticity during indentation deformation) and low residual stress (less than 0.4 GPa), smooth (Ra=5.5 nm ), and hydrophobic surface (contact angle with water reaches 100°).


2014 ◽  
Vol 57 (2) ◽  
pp. 267-274 ◽  
Author(s):  
Hao Chen ◽  
Shengguo Zhou ◽  
Liqiu Ma ◽  
Liping Wang

Author(s):  
B. K. Kirchoff ◽  
L.F. Allard ◽  
W.C. Bigelow

In attempting to use the SEM to investigate the transition from the vegetative to the floral state in oat (Avena sativa L.) it was discovered that the procedures of fixation and critical point drying (CPD), and fresh tissue examination of the specimens gave unsatisfactory results. In most cases, by using these techniques, cells of the tissue were collapsed or otherwise visibly distorted. Figure 1 shows the results of fixation with 4.5% formaldehyde-gluteraldehyde followed by CPD. Almost all cellular detail has been obscured by the resulting shrinkage distortions. The larger cracks seen on the left of the picture may be due to dissection damage, rather than CPD. The results of observation of fresh tissue are seen in Fig. 2. Although there is a substantial improvement over CPD, some cell collapse still occurs.Due to these difficulties, it was decided to experiment with cold stage techniques. The specimens to be observed were dissected out and attached to the sample stub using a carbon based conductive paint in acetone.


2020 ◽  
Author(s):  
Idoia Hita ◽  
Tomas Cordero-Lanzac ◽  
Francisco J. Garcia-Mateos ◽  
Jose Rodriguez-Mirasol ◽  
Tomas Cordero ◽  
...  

2020 ◽  
Author(s):  
Idoia Hita ◽  
Tomas Cordero-Lanzac ◽  
Francisco J. Garcia-Mateos ◽  
Jose Rodriguez-Mirasol ◽  
Tomas Cordero ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document