Numerical simulations of water spray on flame deflector during the four-engine rocket launching

The great spray area of a Super Large-Scale Natural Draft Cooling Tower (SLNDWCT) makes it difficult to achieve an uniform wind field, and non-uniform water spray distributions are adopted in engineering. In this paper, to improve the cooling performance, optimized non-uniform water spray distributions are designed by utilizing network hydraulic calculations and numerical simulations. In the network calculations, the node-formula is applied to figure out the water pressure and flow rate of each spray nozzle, providing more precise data in simulations for the heat and mass transfer. Simulations for operating in summer, Spring/Autumn and winter seasons, which are different in water spray density, have been presented. In the operating in summer, the spray zone is divided into two regions (inner and outer regions), and by adjusting the water spray density and areas of the two regions, an improved water distribution is achieved.

Download Full-text

Direct Numerical Simulations of Gas–Liquid Multiphase Flows

10.1017/cbo9780511975264 ◽

2001 ◽

Cited By ~ 151

Author(s):

Grétar Tryggvason ◽

Ruben Scardovelli ◽

Stéphane Zaleski

Keyword(s):

Numerical Simulations ◽

Multiphase Flows ◽

Direct Numerical Simulations

Download Full-text

Saturation mechanism and generated viscosity in gravito-turbulent accretion disks

Astronomy and Astrophysics ◽

10.1051/0004-6361/202038023 ◽

2020 ◽

Vol 640 ◽

pp. A53

Author(s):

L. Löhnert ◽

S. Krätschmer ◽

A. G. Peeters

Keyword(s):

Growth Rate ◽

Numerical Simulations ◽

Accretion Disks ◽

Gravitational Instability ◽

Turbulent Viscosity ◽

Radial Distance ◽

Maximum Growth ◽

Wave Number ◽

Radiative Cooling ◽

Mixing Length

Here, we address the turbulent dynamics of the gravitational instability in accretion disks, retaining both radiative cooling and irradiation. Due to radiative cooling, the disk is unstable for all values of the Toomre parameter, and an accurate estimate of the maximum growth rate is derived analytically. A detailed study of the turbulent spectra shows a rapid decay with an azimuthal wave number stronger than ky−3, whereas the spectrum is more broad in the radial direction and shows a scaling in the range kx−3 to kx−2. The radial component of the radial velocity profile consists of a superposition of shocks of different heights, and is similar to that found in Burgers’ turbulence. Assuming saturation occurs through nonlinear wave steepening leading to shock formation, we developed a mixing-length model in which the typical length scale is related to the average radial distance between shocks. Furthermore, since the numerical simulations show that linear drive is necessary in order to sustain turbulence, we used the growth rate of the most unstable mode to estimate the typical timescale. The mixing-length model that was obtained agrees well with numerical simulations. The model gives an analytic expression for the turbulent viscosity as a function of the Toomre parameter and cooling time. It predicts that relevant values of α = 10−3 can be obtained in disks that have a Toomre parameter as high as Q ≈ 10.

Download Full-text