Performance degradation diagnosis of thermal power plants: A method based on advanced exergy analysis

2016 ◽  
Vol 130 ◽  
pp. 219-229 ◽  
Author(s):  
Peng Fu ◽  
Ningling Wang ◽  
Ligang Wang ◽  
Tatiana Morosuk ◽  
Yongping Yang ◽  
...  
2011 ◽  
Vol 148-149 ◽  
pp. 1131-1136
Author(s):  
Zhi Li ◽  
Zhong Min Li ◽  
Zhan Liang Yan

The paper shows the comparison of energy and exergy analysis of thermal power plants based on advanced steam parameters in China climatic conditions. The research contains coal-based thermal power plants using sub-critical, super-critical, and ultra-supercritical steam conditions. The design configurations of 500 MW unit size were considered. The research contains the effect of condenser pressure on plant and exergy efficiency. The effect of high grade coal on performance parameters as compared to typical China low grade coal was also studied. The major exergy loss took place in coal combustion followed by the steam generator. Due to condenser pressure limitation, the maximum possible overall energy efficiency was found to be about 44.4% with the ultra-supercritical power plant. Installing coal-based thermal power plants based on advanced steam parameters in China will be a prospective option aiding energy self-sufficiency.


2010 ◽  
Vol 01 (03) ◽  
pp. 143-152 ◽  
Author(s):  
Vundela Siva Reddy ◽  
Subash Chndra Kaushik ◽  
Sudhir Kumar Tyagi ◽  
Narayanlal Panwar

2019 ◽  
Vol 12 (1) ◽  
pp. 22-28
Author(s):  
V. Ye. Mikhailov ◽  
S. P. Kolpakov ◽  
L. A. Khomenok ◽  
N. S. Shestakov

One of the most important issues for modern domestic power industry is the creation and further widespread introduction of solid propellant energy units for super-critical steam parameters with high efficiency (43–46%) and improved environmental parameters. This will significantly reduce the use of natural gas.At the same time, one of the major drawbacks of the operation of pulverized coal power units is the need to use a significant amount of fuel oil during start-up and shutdown of boilers to stabilize the burning of the coal torch in the variable boiler operating modes.In this regard, solid fuel TPPs need to be provided with fuel oil facilities, with all the associated problems to ensure the performance (heating of fuel oil in winter), reliability and safety. All of the above problems increase both the TPP capital construction costs, and the electricity generating cost.A practical solution to the above problems at present is the use of a plasma technology for coal torch ignition based on thermochemical preparation of fuel for combustion. The materials of the developments of JSC “NPO CKTI” on application of plasmatrons in boilers of thermal power plants at metallurgical complexes of the Russian Federation are also considered.Plasma ignition systems for solid fuels in boilers were developed by Russian specialists and were introduced at a number of coal-fi red power plants in the Russian Federation, Mongolia, North Korea, and Kazakhstan. Plasma ignition of solid fuels is widely used in China for almost 30% of power boilers.The introduction of plasma-energy technologies will improve the energy efficiency of domestic solid-fuel thermal power plants and can be widely implemented in the modernization of boilers.During the construction of new TPPs, the construction of fuel oil facilities can be abandoned altogether, which will reduce the capital costs of the construction of thermal power plants, reduce the construction footprint, and increase the TPP safety.


Sign in / Sign up

Export Citation Format

Share Document