Reliability of a dynamic calibration approach to 3DMA and comparison to standard methods

2020 ◽  
Vol 81 ◽  
pp. 54-55
Author(s):  
A. Carman
Keyword(s):  
Dynamic Calibration ◽  
Standard Methods ◽  
Calibration Approach

scholarly journals An Investigation on a Plane-Based Dynamic Calibration Method for the Handheld LiDAR Scanner

Sensors ◽  
2022 ◽  
Vol 22 (1) ◽  
pp. 369
Author(s):  
Shih-Hong Chio
Keyword(s):  
Preliminary Test ◽  
Calibration Method ◽  
Unit Weight ◽  
Dynamic Calibration ◽  
Calibration Data ◽  
Mean Square ◽  
Highly Correlated ◽  
Dynamic Calibration Method ◽  
Calibration Approach

A plane-based dynamic calibration method had been proposed by the previous study for the GeoSLAM ZEB Horizon handheld LiDAR scanner. Only one preliminary test was presented. Therefore, three datasets in a calibration field were collected in this study on different dates and at different times on the same date to investigate the efficiency of the proposed calibration approach and calibration results. The calibration results for these three datasets showed that all average residuals were closer to 0, and all a posterior unit weight standard deviations of the adjustment were also significantly reduced after calibration. Moreover, the RMSE (root mean square error) of the check planes was improved by about an average of 32.61%, 28.44%, and 14.7%, respectively, for the three datasets. The improvement was highly correlated with the quality of the calibration data. The RMSE differences of all check planes using calibration data collected on different dates and at different times on the same date for calibration was about 1–2 cm and less than 1 mm, respectively. There was no difference in the calibration results, demonstrating the efficiency of the proposed calibration approach and the calibration results during the two different dates.

3-D reconstruction of molecular shape from microcrystal thin sections

1983 ◽  
Vol 41 ◽  
pp. 748-749
Author(s):  
S. Cusack ◽  
J.-C. Jésior
Keyword(s):  
Three Dimensional ◽  
Molecular Shape ◽  
Biological Molecules ◽  
Fourier Space ◽  
Single Particles ◽  
Thin Sections ◽  
Standard Methods ◽  
X Ray ◽  
X Ray Crystallography ◽  
Dimensional Reconstruction

Three-dimensional reconstruction techniques using electron microscopy have been principally developed for application to 2-D arrays (i.e. monolayers) of biological molecules and symmetrical single particles (e.g. helical viruses). However many biological molecules that crystallise form multilayered microcrystals which are unsuitable for study by either the standard methods of 3-D reconstruction or, because of their size, by X-ray crystallography. The grid sectioning technique enables a number of different projections of such microcrystals to be obtained in well defined directions (e.g. parallel to crystal axes) and poses the problem of how best these projections can be used to reconstruct the packing and shape of the molecules forming the microcrystal.Given sufficient projections there may be enough information to do a crystallographic reconstruction in Fourier space. We however have considered the situation where only a limited number of projections are available, as for example in the case of catalase platelets where three orthogonal and two diagonal projections have been obtained (Fig. 1).

Ultrastructural Localization of Phycocyanin in the Acidophilic, Thermophilic Alga, Cyanidium Caldarium

1973 ◽  
Vol 31 ◽  
pp. 462-463
Author(s):  
M. R. Edwards ◽  
J. D. Mainwaring
Keyword(s):  
Yellowstone National Park ◽  
National Park ◽  
Ultrastructural Localization ◽  
Review Of Literature ◽  
Cyanidium Caldarium ◽  
Taxonomic Rank ◽  
Thin Sections ◽  
Standard Methods ◽  
Laboratory Cultures

Although the general ultrastructure of Cyanidium caldarium, an acidophilic, thermophilic alga of questionable taxonomic rank, has been extensively studied (see review of literature in reference 1), some peculiar ultrastructural features of the chloroplast of this alga have not been noted by other investigators.Cells were collected and prepared for thin sections at the Yellowstone National Park and were also grown in laboratory cultures (45-52°C; pH 2-5). Fixation (glutaraldehyde-osmium), dehydration (ethanol), and embedding (Epon 812) were accomplished by standard methods. Replicas of frozenfracture d- etched cells were obtained in a Balzers apparatus. In addition, cells were examined after disruption in a French Press.

A Device for Magnification Measurement

1972 ◽  
Vol 30 ◽  
pp. 622-623
Author(s):  
J.A. Eades ◽  
A. van Dun
Keyword(s):  
Electron Microscope ◽  
Small Displacement ◽  
Private Communication ◽  
Piezoelectric Crystal ◽  
Double Exposure ◽  
Standard Methods ◽  
Elegant Method ◽  
The Right ◽  
Piezo Electric

The measurement of magnification in the electron microscope is always troublesome especially when a goniometer stage is in use, since there can be wide variations from calibrated values. One elegant method (L.M.Brown, private communication) of avoiding the difficulties of standard methods would be to fit a device which displaces the specimen a small but known distance and recording the displacement by a double exposure. Such a device would obviate the need for changing the specimen and guarantee that the magnification was measured under precisely the conditions used.Such a small displacement could be produced by any suitable transducer mounted in one of the specimen translation mechanisms. In the present case a piezoelectric crystal was used. Modern synthetic piezo electric ceramics readily give reproducible displacements in the right range for quite modest voltages (for example: Joyce and Wilson, 1969).

The Repair and Healing of Two Traumatic Ilial Body Fractures Adjacent to Cemented Total Hip Acetabular Components

1992 ◽  
Vol 05 (02) ◽  
pp. 85-89
Author(s):  
P. K. Shires ◽  
T. L. Dew
Keyword(s):  
Internal Fixation ◽  
Cancellous Bone ◽  
Surgical Techniques ◽  
Autogenous Bone ◽  
Cancellous Bone Graft ◽  
Standard Methods ◽  
Intravenous Antibiotics ◽  
Prophylactic Use ◽  
Acetabular Components ◽  
Autogenous Bone Grafts

SummaryThis report has documented the repair and healing of two ilial fractures in dogs which were compounded by the presence of a cemented acetabular prosthesis. While specific recommendations can not be made from such a small number of cases, the information presented herein suggests that such fractures will heal without complication if aseptic surgical techniques and standard methods of internal fixation are employed. The authors strongly recommend the prophylactic use of intravenous antibiotics and the placement of cancellous bone graft when the repair of such fractures is attempted.Two traumatic ilial fractures involving the cement/bone interface of acetabular prostheses were repaired using lag screws, cerclage wires, and autogenous bone grafts. The fractures healed and ambulatory function was regained.

Kinetic Aspects of the Interaction of Blood Clotting Enzymes

1965 ◽  
Vol 13 (01) ◽  
pp. 155-175 ◽  
Author(s):  
H. C Hemker ◽  
P.W Hemker ◽  
E. A Loeliger
Keyword(s):  
Kinetic Analysis ◽  
Enzyme Kinetics ◽  
Blood Clotting ◽  
Enzyme System ◽  
Enzyme Kinetic ◽  
Clotting Time ◽  
Standard Methods

SummaryApplication of the methods of enzyme-kinetic analysis to the results of clotting tests is feasible and can yield useful results. However, the standard methods of enzyme kinetics are not applicable without modifications imposed by the peculiarities of the blood-clotting enzyme system. The influence of the following complicating circumstances is calculated :1. Substrate is not present in excess.2. Only relative measures exist for concentrations of substrate or enzymes.3. Enzymes and substrates are often added together.4. Reagents are not pure.5. Clotting-time is our only measure for clotting-velocity.Formulas are deduced, which makes it possible to recognize the effect of these complications.

Sign in / Sign up

Export Citation Format

Share Document