Simulations of high-gain shock-ignited inertial-confinement-fusion implosions using less than 1MJ of direct KrF-laser energy

2010 ◽  
Vol 6 (2) ◽  
pp. 128-134 ◽  
Author(s):  
Jason W. Bates ◽  
Andrew J. Schmitt ◽  
David E. Fyfe ◽  
Steve P. Obenschain ◽  
Steve T. Zalesak
Author(s):  
J. L. Kline ◽  
S. A. Yi ◽  
A. N. Simakov ◽  
R. E. Olson ◽  
D. C. Wilson ◽  
...  

Experiments on the National Ignition Facility show that multi-dimensional effects currently dominate the implosion performance. Low mode implosion symmetry and hydrodynamic instabilities seeded by capsule mounting features appear to be two key limiting factors for implosion performance. One reason these factors have a large impact on the performance of inertial confinement fusion implosions is the high convergence required to achieve high fusion gains. To tackle these problems, a predictable implosion platform is needed meaning experiments must trade-off high gain for performance. LANL has adopted three main approaches to develop a one-dimensional (1D) implosion platform where 1D means measured yield over the 1D clean calculation. A high adiabat, low convergence platform is being developed using beryllium capsules enabling larger case-to-capsule ratios to improve symmetry. The second approach is liquid fuel layers using wetted foam targets. With liquid fuel layers, the implosion convergence can be controlled via the initial vapor pressure set by the target fielding temperature. The last method is double shell targets. For double shells, the smaller inner shell houses the DT fuel and the convergence of this cavity is relatively small compared to hot spot ignition. However, double shell targets have a different set of trade-off versus advantages. Details for each of these approaches are described.


Author(s):  
R. W. Paddock ◽  
H. Martin ◽  
R. T. Ruskov ◽  
R. H. H. Scott ◽  
W. Garbett ◽  
...  

Indirect drive inertial confinement fusion experiments with convergence ratios below 17 have been previously shown to be less susceptible to Rayleigh–Taylor hydrodynamic instabilities, making this regime highly interesting for fusion science. Additional limitations imposed on the implosion velocity, in-flight aspect ratio and applied laser power aim to further reduce instability growth, resulting in a new regime where performance can be well represented by one-dimensional (1D) hydrodynamic simulations. A simulation campaign was performed using the 1D radiation-hydrodynamics code HYADES to investigate the performance that could be achieved using direct-drive implosions of liquid layer capsules, over a range of relevant energies. Results include potential gains of 0.19 on LMJ-scale systems and 0.75 on NIF-scale systems, and a reactor-level gain of 54 for an 8.5 MJ implosion. While the use of 1D simulations limits the accuracy of these results, they indicate a sufficiently high level of performance to warrant further investigations and verification of this new low-instability regime. This potentially suggests an attractive new approach to fusion energy. This article is part of a discussion meeting issue ‘Prospects for high gain inertial fusion energy (part 2)’.


1990 ◽  
Vol 8 (1-2) ◽  
pp. 3-17 ◽  
Author(s):  
C. Yamanaka

Inertial confinement fusion (ICF) has made great progress. In fact several significant scientific firsts have been achieved in the last year. These developments have presented the ICF community with an opportunity to embark on a new phase in ICF research. The key issues of laser fusion are to attain a high absorption of laser light in a plasma, to prevent preheating of fuel during the compression, and to achieve highly efficient implosion by uniform compression of fuel due to the homogeneous deposition of laser energy on the pellet surface. Direct drive and indirect drive have been investigated. The progress in both schemes is remarkable. The neutron yield by the stagnation free compression of the LHART target has attained 1013 which corresponds to a pellet gain of 1/500. The plastic shell target has reached a fuel density as large as 600 times the liquid density which is measured by the Si activation method as well as the D knockon method. A cryogenic foam target is now under investigation.


Author(s):  
P. A. Norreys ◽  
C. Ridgers ◽  
K. Lancaster ◽  
M. Koepke ◽  
G. Tynan

A European consortium of 15 laboratories across nine nations have worked together under the EUROFusion Enabling Research grants for the past decade with three principle objectives. These are: (a) investigating obstacles to ignition on megaJoule-class laser facilities; (b) investigating novel alternative approaches to ignition, including basic studies for fast ignition (both electron and ion-driven), auxiliary heating, shock ignition etc.; and (c) developing technologies that will be required in the future for a fusion reactor. The Hooke discussion meeting in March 2020 provided an opportunity to reflect on the progress made in inertial confinement fusion research world-wide to date. This first edition of two special issues seeks to identify paths forward to achieve high fusion energy gain. This article is part of a discussion meeting issue ‘Prospects for high gain inertial fusion energy (part 1)’.


2019 ◽  
Vol 26 (6) ◽  
pp. 062702 ◽  
Author(s):  
T. R. Joshi ◽  
S. C. Hsu ◽  
P. Hakel ◽  
N. M. Hoffman ◽  
H. Sio ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document