Orbital reconstruction using standardized 3D titanium orbital mesh implants in combination with intraoperative quality control by cone beam CT scan

2011 ◽  
Vol 40 (10) ◽  
pp. 1018
Author(s):  
R. Schoen ◽  
M. Metzger ◽  
R. Schmelzeisen
2020 ◽  
pp. 107110072096131
Author(s):  
Peter Kvarda ◽  
Lukas Heisler ◽  
Nicola Krähenbühl ◽  
Caspar Samuel Steiner ◽  
Roxa Ruiz ◽  
...  

Introduction: Auto-generated 3-dimensional (3D) measurements based on weightbearing cone-beam computed tomography (CT) scan technology may allow for a more accurate hind- and midfoot assessment. The current study evaluated the reliability and clinical relevance of such measurements in patients with posttraumatic end-stage ankle osteoarthritis. Methods: Seventy-two patients treated at our institution for posttraumatic end-stage ankle osteoarthritis, with available weightbearing conventional radiographs and a cone-beam CT scan, were analyzed. Twenty healthy individuals aged between 40 and 70 years served as controls. Seven variables were measured on weightbearing conventional radiographs (2D) and compared to 3D measurements that were based on reconstructions from weightbearing cone-beam CT scans. The reliability of each measurement was calculated and subgroups formed according to commonly observed deformities. Results: Inter- and intraobserver reliability was superior for 3D compared to 2D measurements. The accuracy of 3D measurements performed on osteoarthritic ankles was similar to 3D measurements performed on healthy individuals. Thirty-three of the 72 included patients (46%) evidenced an inframalleolar compensation of a supramalleolar/intra-articular ankle deformity (78% = varus compensation; 22% = valgus compensation), whereas 24 of those 72 patients (33%) showed no compensation or a further increase of a supramalleolar/intra-articular ankle deformity (67% = varus deformity; 33% = valgus deformity). Conclusion: Auto-generated 3D measurements of the hind- and midfoot were found to be reliable in both healthy individuals and patients with posttraumatic end-stage ankle osteoarthritis. Such measurements may be crucial for a detailed understanding of the location and extent of hindfoot deformities, possibly impacting decision making in the treatment of end-stage ankle osteoarthritis. Level of Evidence: Level III, comparative study.


2018 ◽  
Vol 3 (3) ◽  
pp. 2473011418S0015
Author(s):  
Daniel Bohl ◽  
Blaine Manning ◽  
George Holmes ◽  
Simon Lee ◽  
Johnny Lin ◽  
...  

Category: Other Introduction/Purpose: Foot and ankle surgeons routinely prescribe diagnostic imaging that exposes patients to potentially harmful ionizing radiation. The purpose of this study is to characterize patients’ knowledge regarding radiation exposure associated with common forms of foot and ankle imaging. Methods: A survey was administered to all new patients prior to their first foot and ankle clinic appointments. Patients were asked to compare the amount of harmful radiation associated with chest x-rays to that associated with various types of foot and ankle imaging. Results were tabulated and compared to actual values of radiation exposure from the published literature. Results: A total of 890 patients were invited to participate, of whom 791 (88.9%) completed the survey. The majority of patients believed that a foot x-ray, an ankle x-ray, a “low dose” CT scan of the foot and ankle (alluding to cone-beam CT), and a traditional CT scan of the foot and ankle all contain similar amounts of harmful ionizing radiation to a chest x-ray (Table 1). This is in contrast to the published literature, which suggests that foot x-rays, ankle x-rays, cone beam CT scans of the foot and ankle, and traditional CT scans of the foot and ankle expose patients to 0.006, 0.006, 0.127, and 0.833 chest x-rays worth of radiation. Conclusion: The results of the present study suggest that patients greatly over-estimate the amount of harmful ionizing radiation associated with plain film and cone-beam CT scans of the foot and ankle. Interestingly, their estimates of radiation associated with traditional CT scans of the foot and ankle were relatively accurate. Results suggest that patients may benefit from increased counseling by surgeons regarding the relatively low risk of radiation exposure associated with plain film and cone-beam CT imaging of the foot and ankle.


Author(s):  
Carsten Schroeder ◽  
Jane M. Chung ◽  
Andrew B. Mitchell ◽  
Thomas A. Dillard ◽  
Alessandro G. Radaelli ◽  
...  

We describe the integration of the hybrid operation room cone-beam computed tomography (CT) scan technology into the practice of general thoracic surgery. The combination of the following three techniques: (1) cone-beam CT scan augmented navigational bronchoscopy, (2) cone-beam CT-guided percutaneous biopsy and/or fiducial placement, and (3) fiducial or image-guided video-assisted thoracic surgery resection, into a single-stage, single-provider procedure allows for diagnosis and treatment in one setting. Rapid on-site evaluation of cytological or pathology specimens is key to this “all-in-one” approach. The time from diagnosis to curative treatment can significantly be reduced using the hybrid operation room technology, leading to decreased upstaging, increased survival and facilitating the otherwise difficult intraoperative detection and resection of small and deeper lesions. Not only does this benefit the overall thoracic healthcare of the community but also provides a cost-effective paradigm for the institution.


2018 ◽  
Vol 127 ◽  
pp. S1241
Author(s):  
A. Antón-Jiménez ◽  
C. Delgado-Soler ◽  
D. Sánchez-Artuñedo

2010 ◽  
Vol 49 (2) ◽  
pp. 225-229 ◽  
Author(s):  
Jonas Westberg ◽  
Henrik R. Jensen ◽  
Anders Bertelsen ◽  
Carsten Brink

2014 ◽  
Vol 38 (1) ◽  
pp. 167-176 ◽  
Author(s):  
Lambros Tselikas ◽  
Julien Joskin ◽  
Florian Roquet ◽  
Geoffroy Farouil ◽  
Serge Dreuil ◽  
...  

2002 ◽  
Vol 13 (6) ◽  
pp. 651-656 ◽  
Author(s):  
Thomas Fortin ◽  
Guillaume Champleboux ◽  
Silvio Bianchi ◽  
Hervé Buatois ◽  
Jean-Loup Coudert

2018 ◽  
Vol 39 (7) ◽  
pp. 850-857 ◽  
Author(s):  
Mark C. Lawlor ◽  
Melissa A. Kluczynski ◽  
John M. Marzo

Background: The utility of computed tomography (CT) for measuring medial clear space (MCS) for determination of the stability of supination external rotation (SER) ankle fractures and in comparison to standard radiographs is unknown. We compared MCS on gravity stress (GS) radiographs to GS and weight bearing (WB) cone-beam CT (CBCT). Methods: An AO SER 44B3.1 ankle fracture was simulated in 10 human cadavers, also serving as controls. MCS was measured on GS radiographs, GS CBCT, and a simulated WB CBCT scan. Specimens were stable if MCS was <5 mm and unstable if MCS was ≥5 mm. Paired t tests were used to compare MCS from each imaging modality for controls versus SER injuries and stable versus unstable specimens. Results: Compared with controls assessed by GS radiographs, MCS was greater for an SER injury when assessed by GS radiograph and GS CBCT scan within the stable group. Compared with controls assessed by GS radiographs, MCS was greater for SER injuries when assessed by GS radiograph, GS CBCT scan, and WB CBCT within the unstable group. MCS was reduced for stable versus unstable SER injuries assessed by WB CBCT. Conclusion: In a cadaveric model of SER ankle fracture, the medial clear space was statistically significantly greater for the experimental condition when assessed by gravity stress radiograph and gravity stress CBCT scan. Under weight-bearing conditions, the cone-beam CT scanner distinguished between stable and unstable ankles in the experimental condition. Clinical Relevance: This study suggests that a WB cone-beam CT scan may be able to distinguish between stable and unstable SER ankle fractures and influence operative decision making.


Sign in / Sign up

Export Citation Format

Share Document