A study on moment inequalities under a weak dependence

2013 ◽  
Vol 42 (1) ◽  
pp. 133-141 ◽  
Author(s):  
Eunju Hwang ◽  
Dong Wan Shin
1992 ◽  
Vol 57 (7) ◽  
pp. 1419-1423
Author(s):  
Jindřich Weiss

New data on critical holdups of dispersed phase were measured at which the phase inversion took place. The systems studied differed in the ratio of phase viscosities and interfacial tension. A weak dependence was found of critical holdups on the impeller revolutions and on the material contactor; on the contrary, a considerable effect of viscosity was found out as far as the viscosity of continuous phase exceeded that of dispersed phase.


2021 ◽  
pp. 1-24
Author(s):  
Hiroaki Kaido ◽  
Francesca Molinari ◽  
Jörg Stoye

The literature on stochastic programming typically restricts attention to problems that fulfill constraint qualifications. The literature on estimation and inference under partial identification frequently restricts the geometry of identified sets with diverse high-level assumptions. These superficially appear to be different approaches to closely related problems. We extensively analyze their relation. Among other things, we show that for partial identification through pure moment inequalities, numerous assumptions from the literature essentially coincide with the Mangasarian–Fromowitz constraint qualification. This clarifies the relation between well-known contributions, including within econometrics, and elucidates stringency, as well as ease of verification, of some high-level assumptions in seminal papers.


1989 ◽  
Vol 167 ◽  
Author(s):  
M. S. Hu

AbstractSolvent induced damage bands formed in residually strained polyimide thin films on different substrates have been studied. Microscopy studies have shown that these bands resemble crazes. A mechanics approach Is taken to understand the band formation phenomenon.The critical strain for damage formation has been identified. This strain decreases with increase in exposure time, but always exhibits a threshold value. In contrast to the cracking of brittle films, the critical strain has only a weak dependence on the film thickness over a wide range. This behavior obtains because the crazing of the polyimide films is nucleation controlled. Strain-enhanced diffusion of solvent into the films is considered to be responsible for the property degradation that leads to damage formation.


2018 ◽  
Vol 849 ◽  
pp. 498-509
Author(s):  
R. M. Noest ◽  
Z. Jane Wang

It was thought that the wing hinge position can be tuned to stabilize an uncontrolled fly. However here, our Floquet stability analysis shows that the hinge position has a weak dependence on the flight stability. As long as the hinge position is within the fly’s body length, both hovering and ascending flight are unstable. Instead, there is an optimal hinge position, $h^{\ast }$, at which the ascending speed is maximized. $h^{\ast }$ is approximately half way between the centre of mass and the top of the body. We show that the optimal $h^{\ast }$ is associated with the anti-resonance of the body–wing coupling, and is independent of the stroke amplitude. At $h^{\ast }$, the torque due to wing inertia nearly cancels the torque due to aerodynamic lift, minimizing the body oscillation thus maximizing the upward force. Our analysis using a simplified model of two coupled masses further predicts, $h^{\ast }=(m_{t}/2m_{w})(g/\unicode[STIX]{x1D714}^{2})$. These results suggest that the ascending speed, in addition to energetics and stability, is a trait that insects are likely to optimize.


Sign in / Sign up

Export Citation Format

Share Document