Location of the natural knee axis for internal–external tibial rotation

The Knee ◽  
2016 ◽  
Vol 23 (6) ◽  
pp. 1083-1088 ◽  
Author(s):  
Daniel V. Boguszewski ◽  
Nirav B. Joshi ◽  
Paul R. Yang ◽  
Keith L. Markolf ◽  
Frank A. Petrigliano ◽  
...  
Keyword(s):  
Author(s):  
Alexander J. Nedopil ◽  
Peter J. Thadani ◽  
Thomas H. McCoy ◽  
Stephen M. Howell ◽  
Maury L. Hull

AbstractMost medial stabilized (MS) total knee arthroplasty (TKA) implants recommend excision of the posterior cruciate ligament (PCL), which eliminates the ligament's tension effect on the tibia that drives tibial rotation and compromises passive internal tibial rotation in flexion. Whether increasing the insert thickness and reducing the posterior tibial slope corrects the loss of rotation without extension loss and undesirable anterior lift-off of the insert is unknown. In 10 fresh-frozen cadaveric knees, an MS design with a medial ball-in-socket (i.e., spherical joint) and lateral flat insert was implanted with unrestricted calipered kinematic alignment (KA) and PCL retention. Trial inserts with goniometric markings measured the internal–external orientation relative to the femoral component's medial condyle at maximum extension and 90 degrees of flexion. After PCL excision, these measurements were repeated with the same insert, a 1 mm thicker insert, and a 2- and 4-mm shim under the posterior tibial baseplate to reduce the tibial slope. Internal tibial rotation from maximum extension and 90 degrees of flexion was 15 degrees with PCL retention and 7 degrees with PCL excision (p < 0.000). With a 1 mm thicker insert, internal rotation was 8 degrees (p < 0.000), and four TKAs lost extension. With a 2 mm shim, internal rotation was 9 degrees (p = 0.001) and two TKAs lost extension. With a 4 mm shim, internal rotation was 10 degrees (p = 0.002) and five TKAs lost extension and three had anterior lift-off. The methods of inserting a 1 mm thicker insert and reducing the posterior slope did not correct the loss of internal tibial rotation after PCL excision and caused extension loss and anterior lift-off in several knees. PCL retention should be considered when using unrestricted calipered KA and implanting a medial ball-in-socket and lateral flat insert TKA design, so the progression of internal tibial rotation and coupled reduction in Q-angle throughout flexion matches the native knee, optimizing the retinacular ligaments' tension and patellofemoral tracking.


2017 ◽  
Vol 5 (7_suppl6) ◽  
pp. 2325967117S0030
Author(s):  
Elmar Herbst ◽  
Tom Gale ◽  
Kanto Nagai ◽  
Yasutaka Tashiro ◽  
James J. Irrgang ◽  
...  

2018 ◽  
Vol 6 (4_suppl2) ◽  
pp. 2325967118S0003
Author(s):  
Elmar Herbst ◽  
Andreas Imhoff ◽  
James Irrgang ◽  
William Anderst ◽  
Freddie Fu

The objective of this study was to investigate the effect of lateral and medial posterior tibial slope (PTS) and meniscal slope (PMS) on in-vivo anterior tibial translation (ATT) and internal tibial rotation (IR) during downhill running on the healthy contralateral knee twenty-four months after ACL reconstruction. Forty-two individuals (twenty-six males; mean age 21.2 ± 6.9 years) who underwent unilateral ACL reconstruction were included in this study. Morphologic parameters were measured on 3 T magnetic resonance images (MRI) using the 3D DESS sequence on the ACL reconstructed and healthy contralateral knee. Lateral and medial PTS and PMS were measured according to the method described by Hudek et al. Briefly, the tibial shaft axis was determined by connecting the centroids of two circles fitting the tibial shaft on the central sagittal MRI slice. The PTS and PMS were determined by the angle between the tibial shaft axis and the line connecting the two most proximal anterior and posterior subchondral bone and meniscal points in the center of each joint compartment. Three-dimensional in-vivo kinematics data were acquired using dynamic stereo x-ray during downhill running (3.0 m/s, 10° slope) at 150 Hz twenty-four months after unilateral ACL reconstruction. A multiple regression analysis was performed (p < .05). The lateral and medial PTS and PMS as well as the differences between the medial and lateral compartment slopes were not significantly related to ATT in the healthy contralateral knees twenty-four months after ACL reconstruction (p > .05). The lateral and medial PTS and PMS were not significantly related to peak internal tibial rotation (p > .05). However, the difference between the medial and lateral PTS as well as PMS was associated with greater internal tibial rotation (PTS: b=1.55, p < .001; PMS: b = .71, p = .02). The most important finding of the present study is that the difference between the medial and lateral posterior tibial and meniscal slope are related to in-vivo internal tibial rotation during downhill running. ATT was not significantly influenced by the tibial bony and meniscal morphology. Taking into account the results of the present study, the difference between the medial and the lateral PTS and PMS may contribute to IR when an ACL injury occurs. However, the analyzed movement was a straight-ahead run without any cutting or pivoting maneuvers commonly related to ACL tears. In such motion patterns, the correlations may be even stronger compared to the results of this study.


2018 ◽  
Vol 3 (3) ◽  
pp. 2473011418S0003
Author(s):  
Arne Burssens ◽  
Alexej Barg ◽  
Timothy Leenders ◽  
Stefan Clockaerts ◽  
Peter Burssens ◽  
...  

Category: Hindfoot Introduction/Purpose: An adult acquired flat foot (AAFD) is a complex 3D deformity. A medializing calcaneal osteotomy (MCO) is a surgical procedure frequently performed to correct the valgus alignment of the hindfoot in a stage II AAFD, when conservative measurements fail. However currently little is known on its accurate influence regarding the hindfoot alignment (HA). The aim is therefore to assess the influence of a MCO on the 3D HA using computer aided software analysis of the images retrieved from a weightbearing cone beam CT (WBCT). Methods: Twelve patients with a mean age of 49,4 years (range 18-67yrs) were prospectively included in a pre-post study design. Indications for surgical correction by a MCO with a solitary translation consisted of an AAFD stage II (N=10) and a posttraumatic valgus deformity (N=2). Fixation of the osteotomy was performed by a step-plate or double screw. WBCT was obtained pre- and post-operative. Images were subsequently segmented to allow a HA calculation in 3D(HA3D) by an angle between the anatomical tibia axis and the axis connecting the computed inferior calcaneuspoint and the centroid of the talus in the coronal plane based on a Cartesian coordinatesystem(Fig 1A, C). The tibia in the HA3D was separately assessed by the anatomical tibia axis (TAx 3D) and the axis to determine the tibial rotation(TR 3D) in the axial plane by connecting the computed most outer point of the anterior and posterior tubercle of the incisura fibularis(Fig 2A, D). Results: The mean medial translation of the calcaneal osteotomy during surgery was 5.72 mm (SD = 3.9). The mean HA3D pre-operatively equaled 18.21 degrees of valgus (SD = 6.6) and post-operatively 9.31 degrees of valgus (SD = 6.18). The Paired Student’s t-test showed a significant correction of 8.89 degrees (95%CI [5.99, 11.80], P<0.001). The mean TAX 3D pre-operatively was 6.80 degrees of valgus (SD = 3.38) and post-operatively 4.11 degrees of valgus (SD = 2.77), with a significant difference of 2.69 degrees (95%CI [1.79, 3.59], P <0.001). The mean TR3D pre-operatively was -27.11 degrees (SD = 4.77) and post-operatively - 28.80 degrees (SD = 5.98) and showed a significant difference of 1.69 degrees (95%CI [0.41, 2.97], P = 0,016). Conclusion: This study shows an effective correction of the valgus hindfoot in an AAFD. It appears that the correction is not only situated in the calcaneus but also to a lesser extent in the tibia and this resulted in 15% of the achieved HA correction. The novelty is the 3D weightbearing assessment of a hindfoot correction and the shown influence on the tibia. This information could be of use to take in to account when performing a pre-operative planning of a hindfoot deformity.


2017 ◽  
Vol 12 (1) ◽  
Author(s):  
Guoan Li ◽  
Ali Hosseini ◽  
Hemanth Gadikota ◽  
Thomas Gill

This study evaluated the biomechanical efficacy of single-tunnel double-bundle anterior cruciate ligament (ACL) reconstruction technique. The graft construct is achieved using a novel fixation device that splits an ACL (SPACL) graft into two bundles, recreating the anteromedial (AM) and posterolateral (PL) bundles for ACL reconstruction. A pullout strength test of the SPACL was performed using a 7-mm bovine digital extensor tendon graft. The capability in restoration of knee kinematics after SPACL reconstruction was investigated using cadaveric human knees on a robotic testing system under an anterior tibial load of 134 N and a simulated quadriceps load of 400 N. The data indicated that the SPACL graft has a pullout strength of 823.7±172.3 N. Under the 134 N anterior tibial load, the anteroposterior joint laxity had increased constraint using the SPACL reconstruction but not significantly (p > 0.05) at all selected flexion angles. Under the 400 N quadriceps load, no significant differences were observed between the anterior tibial translation of intact knee and SPACL conditions at all selected flexion angles, but the SPACL graft induced a significant increase in external tibial rotation compared to the intact knee condition at all selected flexion angles with a maximal external rotation of −3.20 deg ±3.6 deg at 90 deg flexion. These data showed that the SPACL technique is equivalent or superior to existing ACL reconstruction techniques in restoration of knee laxity and kinematics. The new SPACL reconstruction technique could provide a valuable alternation to contemporary ACL reconstruction surgery by more closely recreating native ACL kinematics.


Sign in / Sign up

Export Citation Format

Share Document