Correlation between local lattice environment and upconversion emission in Ho3+-doped CaHfO3 in terms of substitution site dependence

2021 ◽  
Vol 114 ◽  
pp. 110991
Author(s):  
Hyeontae Lim ◽  
Sojeong Lee ◽  
Sangwon Wi ◽  
Soyeong Jang ◽  
Byeong-Seok Moon ◽  
...  
2021 ◽  
Vol 22 ◽  
pp. 55-60
Author(s):  
B.S. Shin ◽  
Hyeontae Lim ◽  
Soyoung Jang ◽  
D.J. Lee ◽  
Y.S. Lee

2020 ◽  
Vol 76 (2) ◽  
pp. 155-161
Author(s):  
Hyeontae Lim ◽  
Soyeong Jang ◽  
Y. S. Lee

Author(s):  
S. Hillyard ◽  
Y.-P. Chen ◽  
J.D. Reed ◽  
W.J. Schaff ◽  
L.F. Eastman ◽  
...  

The positions of high-order Laue zone (HOLZ) lines in the zero order disc of convergent beam electron diffraction (CBED) patterns are extremely sensitive to local lattice parameters. With proper care, these can be measured to a level of one part in 104 in nanometer sized areas. Recent upgrades to the Cornell UHV STEM have made energy filtered CBED possible with a slow scan CCD, and this technique has been applied to the measurement of strain in In0.2Ga0.8 As wires.Semiconductor quantum wire structures have attracted much interest for potential device applications. For example, semiconductor lasers with quantum wires should exhibit an improvement in performance over quantum well counterparts. Strained quantum wires are expected to have even better performance. However, not much is known about the true behavior of strain in actual structures, a parameter critical to their performance.


Author(s):  
Hamish L. Fraser

The topic of strain and lattice parameter measurements using CBED is discussed by reference to several examples. In this paper, only one of these examples is referenced because of the limitation of length. In this technique, scattering in the higher order Laue zones is used to determine local lattice parameters. Work (e.g. 1) has concentrated on a model strained-layer superlattice, namely Si/Gex-Si1-x. In bulk samples, the strain is expected to be tetragonal in nature with the unique axis parallel to [100], the growth direction. When CBED patterns are recorded from the alloy epi-layers, the symmetries exhibited by the patterns are not tetragonal, but are in fact distorted from this to lower symmetries. The spatial variation of the distortion close to a strained-layer interface has been assessed. This is most readily noted by consideration of Fig. 1(a-c), which show enlargements of CBED patterns for various locations and compositions of Ge. Thus, Fig. 1(a) was obtained with the electron beam positioned in the center of a 5Ge epilayer and the distortion is consistent with an orthorhombic distortion. When the beam is situated at about 150 nm from the interface, the same part of the CBED pattern is shown in Fig. 1(b); clearly, the symmetry exhibited by the mirror planes in Fig. 1 is broken. Finally, when the electron beam is positioned in the center of a 10Ge epilayer, the CBED pattern yields the result shown in Fig. 1(c). In this case, the break in the mirror symmetry is independent of distance form the heterointerface, as might be expected from the increase in the mismatch between 5 and 10%Ge, i.e. 0.2 to 0.4%, respectively. From computer simulation, Fig.2, the apparent monocline distortion corresponding to the 5Ge epilayer is quantified as a100 = 0.5443 nm, a010 = 0.5429 nm and a001 = 0.5440 nm (all ± 0.0001 nm), and α = β = 90°, γ = 89.96 ± 0.02°. These local symmetry changes are most likely due to surface relaxation phenomena.


2020 ◽  
Author(s):  
Yuan-Yuan Tan ◽  
Ming-Yao Su ◽  
Zhou-Can Xie ◽  
Zhong-Jun Chen ◽  
Yu Gong ◽  
...  

2021 ◽  
Vol 127 (7) ◽  
Author(s):  
Dongdong Li ◽  
Jianye Mo ◽  
Chong Wang ◽  
Zhiwei Wu ◽  
Aihua Hao ◽  
...  

2021 ◽  
Vol 12 (1) ◽  
Author(s):  
Meng Meng ◽  
Yuanwei Sun ◽  
Yuehui Li ◽  
Qichang An ◽  
Zhenzhen Wang ◽  
...  

AbstractThe d-band-filling of transition metals in complex oxides plays an essential role in determining their structural, electronic and magnetic properties. Traditionally, at the oxide heterointerface, band-filling control has been achieved via electrostatic modification in the structure of field-effect transistors or electron transfer, which is limited to the quasi-two-dimension at the interface. Here we report a three-dimensional (3D) band-filling control by changing the local lattice coordination in a designed oxide heterostructure. At the LaCoO3/LaTiO3 heterointerface, due to the Fermi level mismatch, electrons transfer from LaTiO3 to LaCoO3. This triggers destabilisation of the CoO6 octahedrons, i.e. the formation of lattice configurations with a reduced Co valence. The associated oxygen migration results in the 3D topotactic phase transition of LaCoO3. Tuned by the thickness of LaTiO3, different crystalline phases and band-fillings of Co occur, leading to the emergence of different magnetic ground states.


2021 ◽  
pp. 130786
Author(s):  
Yufeng Zhou ◽  
Jing Ding ◽  
Ze Wang ◽  
Yao Tong ◽  
Xiaojuan Liang ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document