Tonian deltaic and storm-influenced marine sedimentation on the edge of Laurentia: the Veteranen Group of northeastern Spitsbergen, Svalbard

Geragai graben is located in the South Sumatera Basin. It was formed by mega sequence tectonic process with various stratigraphic sequence from land and marine sedimentation. One of the overpressure indication zones in the Geragai graben is in the Gumai Formation, where the sedimentation is dominated by fine grained sand and shale with low porosity and permeability. The aim of the study is to localize the overpressure zone and to analyze the overpressure mechanism on the Gumai Formation. The Eaton method was used to determine pore pressure value using wireline log data, pressure data (RFT/FIT), and well report. The significant reversal of sonic and porosity log is indicating an overpressure presence. The cross-plot analysis of velocity vs density and fluid type data from well reports were used to analyze the causes of overpressure in the Gumai Formation. The overpressure in Gumai Formation of Geragai graben is divided into two zones, they are in the upper level and lower level of the Gumai Formation. Low overpressure have occurred in the Upper Gumai Formation and mild overpressure on the Lower Gumai Formation. Based on the analyzed data, it could be predicted, that the overpressure mechanism in the Upper Gumai Formation might have been caused by a hydrocarbon buoyancy, whereas in the Lower Gumai Formation, might have been caused by disequilibrium compaction as a result of massive shale sequence.

Download Full-text

Relative Geological Importance of Continental, Littoral, and Marine Sedimentation

The American Naturalist ◽

10.1086/278756 ◽

1907 ◽

Vol 41 (484) ◽

pp. 277-278

Keyword(s):

Marine Sedimentation

Download Full-text

PARAGUAY BELT LITHOSTRATIGRAPHIC AND TECTONIC CHARACTERIZATION: IMPLICATIONS IN THE EVOLUTION OF THE OROGEN (MATO GROSSO-BRAZIL) / CARACTERIZAÇÃO LITOESTRATIGRÁFICA E TECTÔNICA DO CINTURÃO PARAGUAY : IMPLICAÇÕES NA EVOLUÇÃO DO ORÓGENO (MATO GROSSO-BRASIL)

Journal of Sedimentary Environments ◽

10.12957/jse.2018.34219 ◽

2018 ◽

Vol 3 (2) ◽

pp. 54-73

Author(s):

Elzio Da Silva Barboza ◽

Anderson Costa dos Santos ◽

Carlos José Fernandes ◽

Mauro César Geraldes

Keyword(s):

Gold Content ◽

Mato Grosso ◽

Quartz Veins ◽

Marine Sedimentation ◽

Amazonian Craton ◽

Gondwana Supercontinent ◽

Surrounding Areas ◽

Shelf Region ◽

High Gold Content

The Paraguay Belt is composed by sediments deposited due to extensional events followed by inversion with deformation and magmatism and lastly collision of the Amazonian Craton and Paranapanema Block. The marine sedimentation, with Neoproterozoic ages, should have occurred in a continental shelf region, at about 800-550 Ma, when the closing of many oceans gave place to the amalgamation of the Gondwana supercontinent. Three areas were selected for this study which configuration define the perpendicular profile of the Paraguay Belt and allow the characterization of the main regional structures.The structural analysis in the sites here reported and surrounding areas allow suggesting that three deformational events are recorded in the rocks of this region. The sedimentary bedding S0, marked by alternations of dark gray and whitish coloration in the seritic phyllites is folded and the axial plane (Sn) is marked by a cleavage of ardosian. These surfaces are cut by two other deformations, Sn + 1 surface that plunges at high angles to SE as fracture cleavage and Sn + 2 that is orthogonal to the previous deformations and has NW-SE direction with vertical dips, where sometimes occurs quartz veins with high gold content. The Paraguay Belt fan geometry observed in the Sn foliation was developed during the closing of a Brazilian ocean that evolved between the Paranapanema Block and the Amazonian Craton. ResumoO Cinturão Paraguai é composto por sedimentos depositados durante eventos extencionais seguidos de inversão com deformação e magmatismo e, por último, colisão do Craton Amazônico e do Bloco Paranapanema. A sedimentação marinha, com idades Neoproterozóicas, ocorreu em uma região de plataforma continental, entre 800-550 Ma, quando o fechamento de muitos oceanos deu lugar à fusão do supercontinente Gondwana. Três áreas foram selecionadas para este estudo cuja configuração define um perfil perpendicular do Cinturão do Paraguai e permite a caracterização das principais estruturas regionais.A análise estrutural nos locais aqui relatados e áreas adjacentes permite sugerir que as rochas do orógeno passou por três eventos deformacionais. O acamamento sedimentar S0, marcado por alternâncias de coloração cinza-escura e esbranquiçada nos filitos e siltitos, é dobrado e o plano axial (Sn) é marcado por uma clivagem ardosiana. Estas superfícies são cortadas por outras duas deformações, Sn + 1 que mergulha em ângulos elevados para SE como clivagem de fratura e Sn + 2 que é ortogonal às deformações anteriores e tem direção NW-SE com mergulhos verticais, onde às vezes ocorrem veios de quartzo com alto teor de ouro. A geometria em leque do Cinturão Paraguay observada na foliação de Sn foi desenvolvida durante o fechamento de um oceano brasileiro que evoluiu entre o Bloco Paranapanema e o Craton Amazônico.

Download Full-text

Tectono-Sedimentary Evolution of the Cenozoic Basins in the Eastern External Betic Zone (SE Spain)

Geosciences ◽

10.3390/geosciences10100394 ◽

2020 ◽

Vol 10 (10) ◽

pp. 394

Author(s):

Manuel Martín-Martín ◽

Francesco Guerrera ◽

Mario Tramontana

Keyword(s):

Strike Slip ◽

Alluvial Fan ◽

Tectonic Activity ◽

Time Interval ◽

Se Spain ◽

The Third ◽

Sedimentary Evolution ◽

Marine Sedimentation ◽

Geodynamic Processes ◽

Early Paleocene

Four main unconformities (1–4) were recognized in the sedimentary record of the Cenozoic basins of the eastern External Betic Zone (SE, Spain). They are located at different stratigraphic levels, as follows: (1) Cretaceous-Paleogene boundary, even if this unconformity was also recorded at the early Paleocene (Murcia sector) and early Eocene (Alicante sector), (2) Eocene-Oligocene boundary, quite synchronous, in the whole considered area, (3) early Burdigalian, quite synchronous (recognized in the Murcia sector) and (4) Middle Tortonian (recognized in Murcia and Alicante sectors). These unconformities correspond to stratigraphic gaps of different temporal extensions and with different controls (tectonic or eustatic), which allowed recognizing minor sedimentary cycles in the Paleocene–Miocene time span. The Cenozoic marine sedimentation started over the oldest unconformity (i.e., the principal one), above the Mesozoic marine deposits. Paleocene-Eocene sedimentation shows numerous tectofacies (such as: turbidites, slumps, olistostromes, mega-olistostromes and pillow-beds) interpreted as related to an early, blind and deep-seated tectonic activity, acting in the more internal subdomains of the External Betic Zone as a result of the geodynamic processes related to the evolution of the westernmost branch of the Tethys. The second unconformity resulted from an Oligocene to Aquitanian sedimentary evolution in the Murcia Sector from marine realms to continental environments. This last time interval is characterized as the previous one by a gentle tectonic activity. On the other hand, the Miocene sedimentation was totally controlled by the development of superficial thrusts and/or strike-slip faults zones, both related to the regional geodynamic evolutionary framework linked to the Mediterranean opening. These strike-slip faults zones created subsidence areas (pull-apart basin-type) and affected the sedimentation lying above the third unconformity. By contrast, the subsidence areas were bounded by structural highs affected by thrusts and folds. After the third unconformity, the Burdigalian-Serravallian sedimentation occurred mainly in shallow- to deep-water marine environments (Tap Fm). During the Late Miocene, after the fourth unconformity, the activation of the strike-slip faults zones caused a shallow marine environment sedimentation in the Murcia sector and a continental (lacustrine and fluvial) deposition in the Alicante sector represented the latter, resulting in alluvial fan deposits. Furthermore, the location of these fans changed over time according to the activation of faults responsible for the tectonic rising of Triassic salt deposits, which fed the fan themselves.

Download Full-text

Implications for the age of South African Devonian rocks in which Tropidoleptus (Brachiopoda) has been found

Geological Magazine ◽

10.1017/s0016756800025024 ◽

1983 ◽

Vol 120 (1) ◽

pp. 51-58 ◽

Cited By ~ 22

Author(s):

A. J. Boucot ◽

C. H. C. Brunton ◽

J. N. Theron

Keyword(s):

South Africa ◽

North America ◽

South African ◽

Early Carboniferous ◽

Fossil Plants ◽

Geological Time ◽

Marine Sedimentation ◽

History Of ◽

Near Shore ◽

First Time

SummaryThe Devonian brachiopod Tropidoleptus is recognized for the first time in South Africa. It is present in the lower part of the Witteberg Group at four widely separated localities. Data regarding the stratigraphical range of the genus elsewhere, combined with information on recently described fossil plants and vertebrates from underlying strata of the upper Bokkeveld Group, suggest that a Frasnian or even Givetian age is reasonable for the lower part of the Witteberg Group. The recognition of Tropidoleptus in a shallow water, near-shore, molluscan association, at the top of the South African marine Devonian sequence, is similar to its occurrence in Bolivia, and suggests a common Malvinokaffric Realm history of shallowing, prior to later Devonian or early Carboniferous non-marine sedimentation. It is noteworthy that Tropidoleptus is now known to occur in ecologically suitable environments around the Atlantic, but is absent from these same environments in Asia and Australia. Tropidoleptus is an excellent example of dispersal in geological time — first appearing in northern Europe and Nova Scotia, then elsewhere in eastern North America and North Africa, followed by South America and South Africa, while continuing in North America.

Download Full-text