Wearable battery-less wireless sensor network with electromagnetic energy harvesting system

2016 ◽  
Vol 249 ◽  
pp. 77-84 ◽  
Author(s):  
Salar Chamanian ◽  
Hasan Uluşan ◽  
Özge Zorlu ◽  
Sajjad Baghaee ◽  
Elif Uysal-Biyikoglu ◽  
...  
2019 ◽  
Vol 6 (1) ◽  
pp. 918-927 ◽  
Author(s):  
Fang Deng ◽  
Xianghu Yue ◽  
Xinyu Fan ◽  
Shengpan Guan ◽  
Yue Xu ◽  
...  

2019 ◽  
Vol 8 (1) ◽  
pp. 18 ◽  
Author(s):  
Kankan Li ◽  
Xuefeng He ◽  
Xingchang Wang ◽  
Senlin Jiang

The Internet of things requires long-life wireless sensor nodes powered by the harvested energy from environments. This paper proposes a nonlinear electromagnetic energy harvesting system which may be used to construct fully self-powered wireless sensor nodes. Based on a nonlinear electromagnetic energy harvester (EMEH) with high output voltage, the model of a nonlinear interface circuit is derived and a power management circuit (PMC) is designed. The proposed PMC uses a buck–boost direct current-direct current (DC–DC) converter to match the load resistance of the nonlinear interface circuit. It includes two open-loop branches, which is beneficial to the optimization of the impedance matching. The circuit is able to work even if the stored energy is completely drained. The energy harvesting system successfully powered a wireless sensor node. Experimental results show that, under base excitations of 0.3 g and 0.4 g (where 1 g = 9.8 m·s−2) at 8 Hz, the charging efficiencies of the proposed circuit are 172% and 28.5% higher than that of the classic standard energy-harvesting (SEH) circuit. The experimental efficiency of the PMC is 41.7% under an excitation of 0.3 g at 8 Hz.


2018 ◽  
Vol 7 (3) ◽  
pp. 40 ◽  
Author(s):  
Himanshu Sharma ◽  
Ahteshamul Haque ◽  
Zainul Jaffery

The Wireless Sensor Networks (WSN) are the basic building blocks of today’s modern internet of Things (IoT) infrastructure in smart buildings, smart parking, and smart cities. The WSN nodes suffer from a major design constraint in that their battery energy is limited and can only work for a few days depending upon the duty cycle of operation. The main contribution of this research article is to propose an efficient solar energy harvesting solution to the limited battery energy problem of WSN nodes by utilizing ambient solar photovoltaic energy. Ideally, the Optimized Solar Energy Harvesting Wireless Sensor Network (SEH-WSN) nodes should operate for an infinite network lifetime (in years). In this paper, we propose a novel and efficient solar energy harvesting system with pulse width modulation (PWM) and maximum power point tracking (MPPT) for WSN nodes. The research focus is to increase the overall harvesting system efficiency, which further depends upon solar panel efficiency, PWM efficiency, and MPPT efficiency. Several models for solar energy harvester system have been designed and iterative simulations were performed in MATLAB/SIMULINK for solar powered DC-DC converters with PWM and MPPT to achieve optimum results. From the simulation results, it is shown that our designed solar energy harvesting system has 87% efficiency using PWM control and 96% efficiency ( η s y s ) by using the MPPT control technique. Finally, an experiment for PWM controlled SEH-WSN is performed using Scientech 2311 WSN trainer kit and a Generic LM2575 DC-DC buck converter based solar energy harvesting module for validation of simulation results.


Sign in / Sign up

Export Citation Format

Share Document