Utilization of poly (4-styrenesulfonic acid) doped polyaniline as a hole transport layer of organic solar cell for indoor applications

2020 ◽  
Vol 700 ◽  
pp. 137921 ◽  
Author(s):  
Swarup Biswas ◽  
Young-Jun You ◽  
Jae Won Shim ◽  
Hyeok Kim
Keyword(s):  
Solar Cell ◽  
Organic Solar Cell ◽  
Hole Transport ◽  
Transport Layer ◽  
Hole Transport Layer ◽  
Doped Polyaniline

Device modeling of non-fullerene organic solar cell by incorporating CuSCN as a hole transport layer using SCAPS

Optik ◽  
2021 ◽  
pp. 168457
Author(s):  
Bharti Sharma ◽  
A S Mathur ◽  
V K Rajput ◽  
I K Singh ◽  
B P Singh
Keyword(s):  
Solar Cell ◽  
Organic Solar Cell ◽  
Hole Transport ◽  
Transport Layer ◽  
Hole Transport Layer ◽  
Device Modeling

Effect of doped polyaniline/graphene oxide ratio as a hole transport layer on the performance of perovskite solar cell

2020 ◽  
Vol 31 (21) ◽  
pp. 18870-18882
Author(s):  
M. Habib ◽  
M. Feteha ◽  
M. Soliman ◽  
A. Abdel Motagaly ◽  
S. El-Sheikh ◽  
...  
Keyword(s):  
Graphene Oxide ◽  
Solar Cell ◽  
Perovskite Solar Cell ◽  
Hole Transport ◽  
Transport Layer ◽  
Hole Transport Layer ◽  
Oxide Ratio ◽  
Doped Polyaniline

Reliability improvement of bulk-heterojunction organic solar cell by using reduced graphene oxide as hole-transport layer

2014 ◽  
Vol 211 (8) ◽  
pp. 1873-1876 ◽  
Author(s):  
Nhu Thuy Ho ◽  
V. Senthilkumar ◽  
Hak-Soon Cho ◽  
Sung Ho Nho ◽  
Shinuk Cho ◽  
...  
Keyword(s):  
Graphene Oxide ◽  
Solar Cell ◽  
Reduced Graphene Oxide ◽  
Organic Solar Cell ◽  
Bulk Heterojunction ◽  
Hole Transport ◽  
Transport Layer ◽  
Hole Transport Layer ◽  
Reliability Improvement ◽  
Reduced Graphene

Single Step Blending of PEDOT:PSS/SPGO Nanocomposite via Low Temperature Solid Phase Addition of Graphene Oxide for Effective Hole Transport Layer in Organic Solar Cells

2020 ◽  
Vol 20 (6) ◽  
pp. 3888-3895 ◽  
Author(s):  
Sandeep Pandey ◽  
Manoj Karakoti ◽  
Neeraj Chaudhary ◽  
Sonal Gupta ◽  
Amit Kumar ◽  
...  
Keyword(s):  
Graphene Oxide ◽  
Solar Cell ◽  
Low Temperature ◽  
Organic Solar Cell ◽  
Solid Phase ◽  
Hole Transport ◽  
Oxide Powder ◽  
Transport Layer ◽  
Hole Transport Layer ◽  
Spray Dryer

Herein, we report the modification of PEDOT:PSS by in-situ direct addition of graphene oxide powder processed by spray dryer (SPGO) for the enhancement in the performance of organic solar cell. The preparation of PEDOT:PSS/SPGO composite was done by direct incorporation of graphene oxide powder at lower temperature i.e., below 5 °C. Raman spectroscopy of the prepared PEDOT:PSS/SPGO nanocomposites at low temperature suggested that low temperature plays a vital role to improve the ability of these composite as hole transport layer by improving adhesive properties of the composite. Atomic force microscopy (AFM) analysis suggested that the adhesive ability of these composite decreased surface roughness and thus providing smoother path for the hole transportation. After the successful synthesis of PEDOT:PSS/SPGO nanocomposites, ITO/PEDOT:PSS/SPGO/PTB7:PC71BM/Al based organic solar cell was fabricated. The J–V curves under AM 1.5G illumination (100 mW/cm2) of the PTB7:PC71BM based OSCs using PEDOT:PSS/SPGO as a HTL exhibit Voc = 0.67 V, Jsc = 17.3 mA, FF = 41.5%, PCE = 4.82%, and device with PEDOT:PSS as HTL exhibit Voc = 0.68 V, Jsc = 16.0 mA/cm2, FF = 38.7% and PCE = 4.04%. The enhance PCE in case of PEDOT:PSS/SPGO based devices depicted that the direct inclusion of graphene oxide in PEDOT:PSS increased the PCE almost 16%, which arises due the high conductivity and stable pi–pi stacking of the spray dryer processed graphene sheets with PEDOT:PSS which ease the charge carrier mobility, thus providing feasible path for charge transportation.

Examining the effect of additives and thicknesses of hole transport layer for efficient organic solar cell devices

2013 ◽  
Vol 9 (4) ◽  
pp. 399-403 ◽  
Author(s):  
Shizuyasu Ochiai ◽  
Palanisamy Kumar ◽  
Kannappan Santhakumar ◽  
Paik-Kyun Shin
Keyword(s):  
Solar Cell ◽  
Organic Solar Cell ◽  
Hole Transport ◽  
Transport Layer ◽  
Hole Transport Layer ◽  
Effect Of Additives

Functionalized and reduced graphene oxide as hole transport layer and for use in ternary organic solar cell

2019 ◽  
Vol 98 ◽  
pp. 109434 ◽  
Author(s):  
Juan Nicasio-Collazo ◽  
José-Luis Maldonado ◽  
Julio Salinas-Cruz ◽  
Denisse Barreiro-Argüelles ◽  
Irving Caballero-Quintana ◽  
...  
Keyword(s):  
Graphene Oxide ◽  
Solar Cell ◽  
Reduced Graphene Oxide ◽  
Organic Solar Cell ◽  
Hole Transport ◽  
Transport Layer ◽  
Hole Transport Layer ◽  
Reduced Graphene

scholarly journals Construction and Characterization of Organic Solar Cell and Study the Operational Properties

2018 ◽  
Vol 14 (3) ◽  
pp. 12-19
Author(s):  
Majid H. Majeed ◽  
Mohamed Abdul Kareem ◽  
Esraa H. Ali
Keyword(s):  
Solar Cell ◽  
Indium Tin Oxide ◽  
Organic Solar Cell ◽  
Spectral Response ◽  
Transparent Electrode ◽  
Hole Transport ◽  
Transport Layer ◽  
Hole Transport Layer ◽  
Ambient Atmosphere ◽  
Poly Styrene Sulfonate

This article reviews the construction of organic solar cell (OSC) and characterized their optical and electrical properties, where indium tin oxide (ITO) used as a transparent electrode, “Poly (3-hexylthiophene- 2,5-diyl) P3HT / Poly (9,9-dioctylfluorene-alt-benzothiadiazole) F8BT” as an active layer and “Poly(3,4-ethylenedioxythiophene)-poly (styrene sulfonate)” PEDOT: PSS which is referred to the hole transport layer. Spin coating technique was used to prepared polymers thin film layers under ambient atmosphere to make OSC.  The prepared samples were characterized after annealing process at (80 ͦ C) for (30 min) under non-isolated circumference. The results show a value of filling factor (FF) of (2.888), (0.233) and (0.28) and power conversion efficiency (PCE) of (0.0055), (3.333  10-6) and (0.0004), where these results were obtained by Keithley Electrometer Model 6517B, while spectral response is being utilized by LEOI-94 Monochromator and Keithley 6517B Electrometer.

Sign in / Sign up

Export Citation Format

Share Document