Theoretical and Experimental Study of the Structure, Vibrational Frequencies, and Strain Energy of Tricyclo[3.1.0.02,6]hexane

1994 ◽  
Vol 98 (47) ◽  
pp. 12236-12241 ◽  
Author(s):  
Steven R. Davis ◽  
Puei L. Tan
2003 ◽  
Vol 36 (5-6) ◽  
pp. 537-550
Author(s):  
C. Bruyneel ◽  
Nguyen‐Nguyen Pham‐Tran ◽  
Minh Tho Nguyen ◽  
Thérèse Zeegers‐Huyskens

1983 ◽  
Vol 105 (2) ◽  
pp. 213-217
Author(s):  
M. Holland ◽  
M. A. Keavey

The complex variable method is applied to the analysis of a traditional constant-depth reinforcing ring as used on a pressurized single discontinuous bend (Fig. 1). It is shown that there is a “cross-over” point where complex variable theory and bending strain energy theory take over one from the other. This condition occurs when ring depth divided by the cylinders’ mean radius is approximately equal to 0.3. This criterion is of special interest since it falls within the range of factors used in industrial designs, i.e., the Mackenzie and Beattie bend [1] has a ratio of 0.29. Limitations of the complex variable theory are investigated with a detailed theoretical and experimental study of an internally pressurized prismatic elliptic cylinder having a circular bore (Fig. 2). Three bore sizes are investigated to gain knowledge of the convergent/divergent characteristics of the theory. For the largest bore size, numerical results show a definite divergence.


Author(s):  
Norio Baba ◽  
Norihiko Ichise ◽  
Syunya Watanabe

The tilted beam illumination method is used to improve the resolution comparing with the axial illumination mode. Using this advantage, a restoration method of several tilted beam images covering the full azimuthal range was proposed by Saxton, and experimentally examined. To make this technique more reliable it seems that some practical problems still remain. In this report the restoration was attempted and the problems were considered. In our study, four problems were pointed out for the experiment of the restoration. (1) Accurate beam tilt adjustment to fit the incident beam to the coma-free axis for the symmetrical beam tilting over the full azimuthal range. (2) Accurate measurements of the optical parameters which are necessary to design the restoration filter. Even if the spherical aberration coefficient Cs is known with accuracy and the axial astigmatism is sufficiently compensated, at least the defocus value must be measured. (3) Accurate alignment of the tilt-azimuth series images.


Author(s):  
S.R. Summerfelt ◽  
C.B. Carter

The wustite-spinel interface can be viewed as a model interface because the wustite and spinel can share a common f.c.c. oxygen sublattice such that only the cations distribution changes on crossing the interface. In this study, the interface has been formed by a solid state reaction involving either external or internal oxidation. In systems with very small lattice misfit, very large particles (>lμm) with coherent interfaces have been observed. Previously, the wustite-spinel interface had been observed to facet on {111} planes for MgFe2C4 and along {100} planes for MgAl2C4 and MgCr2O4, the spinel then grows preferentially in the <001> direction. Reasons for these experimental observations have been discussed by Henriksen and Kingery by considering the strain energy. The point-defect chemistry of such solid state reactions has been examined by Schmalzried. Although MgO has been the principal matrix material examined, others such as NiO have also been studied.


1962 ◽  
Vol 5 (4) ◽  
pp. 387-394 ◽  
Author(s):  
Bruce Quarrington ◽  
Jerome Conway ◽  
Nathan Siegel
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document