scholarly journals Turbulent Transport atthe Thermal Internal Boundary-Layer top:Wavelet Analysis of Aircraft Measurements

2000 ◽  
Vol 94 (2) ◽  
pp. 175-196 ◽  
Author(s):  
S. Galmarini ◽  
J. L. Attié
Keyword(s):  
Boundary Layer ◽  
Turbulent Transport ◽  
Internal Boundary Layer ◽  
Internal Boundary ◽  
Aircraft Measurements ◽  
Thermal Internal Boundary Layer

Wind-Tunnel and Numerical Simulations of the Coastal Thermal Internal Boundary Layer

2009 ◽  
Vol 130 (3) ◽  
pp. 365-381 ◽  
Author(s):  
Tomohiro Hara ◽  
Yuji Ohya ◽  
Takanori Uchida ◽  
Ryohji Ohba
Keyword(s):  
Boundary Layer ◽  
Wind Tunnel ◽  
Numerical Simulations ◽  
Internal Boundary Layer ◽  
Internal Boundary ◽  
Thermal Internal Boundary Layer

scholarly journals Study of the Thermal Internal Boundary Layer in Sea Breeze Conditions Using Different Parameterizations: Application of the WRF Model in the Greater Vitória Region

2016 ◽  
Vol 31 (4 suppl 1) ◽  
pp. 593-609 ◽  
Author(s):  
Nadir Salvador ◽  
◽  
Ayres G. Loriato ◽  
Alexandre Santiago ◽  
Taciana T.A. Albuquerque ◽  
...  
Keyword(s):  
Boundary Layer ◽  
Land Surface ◽  
Wrf Model ◽  
Coastal Region ◽  
Sea Breeze ◽  
Internal Boundary Layer ◽  
Internal Boundary ◽  
Surface Model ◽  
Thermal Internal Boundary Layer ◽  
Local Closure

Abstract In the present study, the physical parameterizations of the Weather Research and Forecasting (WRF) model are verified for making accurate inferences about the dynamics of the Thermal Internal Boundary Layer (TIBL) generated by sea breeze in an urban center with an island in a bay along a coastal region with rugged topography. The simulations were performed using parameterizations from Yonsei University (YSU), Mellor-Yamada-Janjic (MYJ) and Asymmetric Convective Model version 2 (ACM2) for the atmospheric boundary layer (ABL) and Noah and Rapid Update Cycle (RUC) for the Land Surface Model (LSM). The data inferred by the WRF model were compared with those obtained by a Surface Meteorological Station (SMS) and by measurements generated using Light Detection and Ranging (LIDAR), Sonic Detection and Ranging (SODAR) and radiosonde. The simulations showed that although the object of this research was a region with high geographical complexity, the YSU parameterization set (non-local closure) for the ABL and the Noah parameterization for the LSM presented satisfactory results in determining ABL height generated by the sea breeze on the day in question.

scholarly journals Thermal Internal Boundary Layer Height by Numerical Simulation of the Fumigation

2017 ◽  
pp. 766-779
Author(s):  
M.R. Sahebnasagh ◽  
V. Esfahanian ◽  
KH. Ashrafi ◽  
M. Khakshour
Keyword(s):  
Boundary Layer ◽  
Reynolds Stress ◽  
Wind Direction ◽  
Stable Condition ◽  
Internal Boundary Layer ◽  
Height Velocity ◽  
Internal Boundary ◽  
Sharp Change ◽  
Neutral Atmosphere ◽  
Thermal Internal Boundary Layer

Fumigation is an important subject in air pollution. In a neutral atmosphere, temperature decreases with the height. However, when there is a transient condition of climate like sunrise in the morning which leads to increase the land surface temperature, temperature profile of stable condition will change. In these conditions, convection of air near the ground surface increases the turbulence and dispersion coefficient. In coastal area, there will be a temperature difference between the sea and land. This condition make the pollutants to fumigate when enters to the layer above the ground named as Thermal Internal Boundary Layer (TIBL). The height of TIBL which defines the extent of fumigation is important. Researchers suggested several formulas for estimating the TIBL height based on practical works. In this paper, computational fluid dynamic (CFD) provides discrete phase model (DPM) of dispersion using Reynolds stress transport model of turbulence (RSM) applied for estimating the TIBL height. Study domain is two dimensional, 2500 m in wind direction (sea to land) by 800 m height. Velocity profiles of the neutral atmosphere are forced to the model in neutral steady state atmospheric conditions. Resulted profiles in downwind of the inlet are compared with the forced profiles to evaluate the accuracy of the model. To simulate the fumigation, land temperature fixed to a higher temperature than the sea by 5°c. Resulted velocity profile andgradient of Reynolds stress parameters u ' u ' and u ' v ' in different elevations is used to estimate the TIBL height. The location of sharp change in the Reynolds stress specified as theTIBL height at each elevation. A formula covering the coordination of these locations fitted to define the TIBL height and its growing from coastline towards wind direction. Experimentalformula which is used can be substituted by the determined formula this study.

Seasonal characteristics of sea breeze and thermal internal boundary layer over Indian east coast region

2020 ◽  
Author(s):  
T. V. Ramesh Reddy ◽  
Sanjay Kumar Mehta ◽  
Aravindhavel Ananthavel ◽  
Saleem Ali ◽  
Vanmathi Annamalai ◽  
...  
Keyword(s):  
Boundary Layer ◽  
East Coast ◽  
Sea Breeze ◽  
Internal Boundary Layer ◽  
Internal Boundary ◽  
Thermal Internal Boundary Layer ◽  
Seasonal Characteristics ◽  
Coast Region

The Kwinana Coastal Fumigation Study: II – Growth of the Thermal Internal Boundary Layer

1998 ◽  
Vol 89 (3) ◽  
pp. 385-405 ◽  
Author(s):  
A. K. Luhar ◽  
B. L. Sawford ◽  
J. M. Hacker ◽  
K. N. Rayner
Keyword(s):  
Boundary Layer ◽  
Internal Boundary Layer ◽  
Internal Boundary ◽  
Thermal Internal Boundary Layer
Sign in / Sign up

Export Citation Format

Share Document