scholarly journals Bis-tridentate Ru(ii) sensitizers with a spatially encumbered 2,6-dipyrazolylpyridine ancillary ligand for dye-sensitized solar cells

RSC Advances ◽  
2017 ◽  
Vol 7 (67) ◽  
pp. 42013-42023 ◽  
Author(s):  
Ting-Kuang Chang ◽  
Yun Chi
Keyword(s):  
Solar Cells ◽  
Dye Sensitized Solar Cells ◽  
Charge Recombination ◽  
Ancillary Ligand ◽  
Dye Sensitized ◽  
Dye Loading ◽  
Sensitized Solar Cells

The sensitizer TF-tBu_C3F7 has shown the highest overall efficiencies of JSC = 18.47 mA cm−2, VOC = 767 mV, FF = 0.71 and PCE = 10.05% under simulated one sun irradiation, due to the fine balance between dye loading and reduced charge recombination.

Using Orbital Symmetry to Minimize Charge Recombination in Dye-Sensitized Solar Cells

2012 ◽  
Vol 125 (3) ◽  
pp. 1007-1009 ◽  
Author(s):  
Emanuele Maggio ◽  
Natalia Martsinovich ◽  
Alessandro Troisi
Keyword(s):  
Solar Cells ◽  
Dye Sensitized Solar Cells ◽  
Charge Recombination ◽  
Orbital Symmetry ◽  
Dye Sensitized ◽  
Sensitized Solar Cells

New insights into electrolyte-component biased and transfer- and transport-limited charge recombination in dye-sensitized solar cells

RSC Advances ◽  
2015 ◽  
Vol 5 (103) ◽  
pp. 84959-84966 ◽  
Author(s):  
Dong-Li Gao ◽  
Yi Wang ◽  
Ping Zhang ◽  
Li-Min Fu ◽  
Xi-Cheng Ai ◽  
...  
Keyword(s):  
Solar Cells ◽  
Electron Density ◽  
Dye Sensitized Solar Cells ◽  
Charge Recombination ◽  
High Electron ◽  
High Electron Density ◽  
Dye Sensitized ◽  
Electrolyte Component ◽  
Sensitized Solar Cells

Charge recombination takes place, respectively, within the frameworks of transfer- and transport-limited recombination mechanisms, at low and high electron density.

Effect of TiO2 surface treatment on electron transfer in dye-sensitized solar cells

2022 ◽  
Author(s):  
Suping Jia ◽  
Tong Cheng ◽  
Huinian Zhang ◽  
Hao Wang ◽  
Caihong Hao
Keyword(s):  
Solar Cells ◽  
Electron Transport ◽  
High Efficiency ◽  
Surface Defects ◽  
Dye Sensitized Solar Cells ◽  
Charge Recombination ◽  
Defect States ◽  
Transport Pathway ◽  
Dye Sensitized ◽  
Sensitized Solar Cells

Defect states in the TiO2 nanoparticles can cause severe charge recombination and poor electron-transport efficiency when used as a photoanode in dye-sensitized solar cells (DSSCs). Herein, we report a simple and practical way to passivate the surface defects of TiO2 through hydrothermal treating with acetic acid and H2SO4, introducing a high percentage of 101 facets and sulfonic acid functional groups on the TiO2 surface. A high efficiency of 8.12% has been achieved, which is 14% higher than that of untreated TiO2 under the same condition. EIS results prove that the multiacid-treated TiO2 can promote electron transport and reduce charge recombination at the interface of the TiO2 and electrolyte. This work provides an efficient approach to engineer the electron-transport pathway in DSSCs.

A2 and A2B2 Benzoporphyrins as sensitizers for dye-sensitized solar cells

2019 ◽  
Vol 23 (04n05) ◽  
pp. 599-610 ◽  
Author(s):  
Siddhartha Kumar ◽  
Whitney Webre ◽  
Jacob Schaffner ◽  
Sheikh M. S. Islam ◽  
Francis D’Souza ◽  
...  
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Dye Sensitized Solar Cells ◽  
Acid Group ◽  
Dye Sensitized ◽  
Dye Loading ◽  
Two Factors ◽  
Homo And Lumo ◽  
Anchoring Group ◽  
Sensitized Solar Cells

The first example of A2B2 tetrabenzoporphyrin (KW-4) was synthesized, characterized and evaluated as a sensitizer for dye-sensitized solar cells. UV-vis and fluorescence spectroscopy revealed red-shifted and broadened absorption spectra of A2B2 tetrabenzoporphyrin as compared with its A2 dibenzo- and A2B2 dibenzoporphyrin analogues, which is a desired feature of dyes for dye-sensitized solar cells. DFT calculations also indicate favorable electron density distribution on the HOMO and LUMO of KW-4. However, the power conversion efficiency of the solar cell based on tetrabenzoporphyrin KW-4 displayed inferior performance than that of the solar cell based on A2 dibenzoporphyrin KW-2. The lower performance of the KW-4 cell was ascribed to two factors: the low lying LUMO energy level leading to less efficient electron injection and the “flat geometry” of the dye on TiO2surface facilitating charge recombination and decreasing dye loading. The investigation of anchoring group effect suggests that the acrylic acid group is a better anchoring group than pentadienyl carboxylic acid.

scholarly journals Photovoltaic Performance of Dye-Sensitized Solar Cells Containing ZnO Microrods

Nanomaterials ◽  
2019 ◽  
Vol 9 (12) ◽  
pp. 1645 ◽  
Author(s):  
Seong Il Cho ◽  
Hye Kyeong Sung ◽  
Sang-Ju Lee ◽  
Wook Hyun Kim ◽  
Dae-Hwan Kim ◽  
...  
Keyword(s):  
Solar Cells ◽  
Surface Area ◽  
Electrochemical Impedance ◽  
Collection Efficiency ◽  
Photovoltaic Performance ◽  
Dye Sensitized Solar Cells ◽  
Charge Recombination ◽  
Growth Time ◽  
Dye Sensitized ◽  
Sensitized Solar Cells

At an elevated temperature of 90 °C, a chemical bath deposition using an aqueous solution of Zn(NO3)2·6H2O and (CH2)6N4 resulted in the formation of both nanoflowers and microrods of ZnO on F-doped SnO2 glass with a seed layer. The nanoflowers and microrods were sensitized with dyes for application to the photoelectrodes of dye-sensitized solar cells (DSSCs). By extending the growth time of ZnO, the formation of nanoflowers was reduced and the formation of microrods favored. As the growth time was increased from 4 to 6 and then to 8 h, the open circuit voltage (Voc) values of the DSSCs were increased, whilst the short circuit current (Jsc) values varied only slightly. Changes in the dye-loading amount, dark current, and electrochemical impedance were monitored and they revealed that the increase in Voc was found to be due to a retardation of the charge recombination between photoinjected electrons and I3− ions and resulted from a reduction in the surface area of ZnO microrods. A reduced surface area decreased the dye contents adsorbed on the ZnO microrods, and thereby decreased the light harvesting efficiency (LHE). An increase in the electron collection efficiency attributed to the suppressed charge recombination counteracted the decreased LHE, resulting in comparable Jsc values regardless of the growth time.

Imine–carbene-based ruthenium complexes for dye-sensitized solar cells: the effect of isomeric mixture on the photovoltaic performance

2020 ◽  
Vol 44 (47) ◽  
pp. 20568-20573
Author(s):  
Yogesh S. Tingare ◽  
Chaochin Su ◽  
Ming-Tai Shen ◽  
Sheng-Han Tsai ◽  
Shih-Yu Ho ◽  
...  
Keyword(s):  
Solar Cells ◽  
Photovoltaic Performance ◽  
Dye Sensitized Solar Cells ◽  
Ruthenium Complexes ◽  
Ancillary Ligand ◽  
Isomeric Mixture ◽  
Dye Sensitized ◽  
Sensitized Solar Cells

New isomeric sensitizers containing an imine–carbene (IC)-based ancillary ligand, isomers IC101 and IC102, were designed for application in dye-sensitized solar cells (DSSCs).

Tungsten doped titanium dioxide nanowires for high efficiency dye-sensitized solar cells

2014 ◽  
Vol 16 (16) ◽  
pp. 7448-7454 ◽  
Author(s):  
P. S. Archana ◽  
Arunava Gupta ◽  
Mashitah M. Yusoff ◽  
Rajan Jose
Keyword(s):  
Titanium Dioxide ◽  
Solar Cells ◽  
High Efficiency ◽  
Dye Sensitized Solar Cells ◽  
Photocurrent Density ◽  
Niobium Doping ◽  
Dye Sensitized ◽  
Dye Loading ◽  
Doped Titanium Dioxide ◽  
Sensitized Solar Cells

Tungsten doping in TiO2 nanowires led to increased photocurrent density resulting from increased lifetime and dye-loading compared to niobium doping.

Thiocyanate-free ruthenium(ii) sensitizers with a bi-imidazole ligand in dye-sensitized solar cells (DSSCs)

2017 ◽  
Vol 41 (14) ◽  
pp. 6272-6277 ◽  
Author(s):  
Saba Ashraf ◽  
Javeed Akhtar ◽  
Humaira M. Siddiqi ◽  
Ahmed El-Shafei
Keyword(s):  
Solar Cells ◽  
Dye Sensitized Solar Cells ◽  
Ancillary Ligand ◽  
Dye Sensitized ◽  
Imidazole Ligand ◽  
Sensitized Solar Cells

In this study, tris-heteroleptic Ru(ii) sensitizers denoted as SD-15 and SD-16 with a 4,4′,5,5′-tetramethyl-1H,1′H-2,2′-bis-imidazole moiety as the ancillary ligand were designed, synthesized and characterized.

Sign in / Sign up

Export Citation Format

Share Document