Structure- and Sampling-Adaptive Gait Balance Symmetry Estimation Using Footstep-Induced Structural Floor Vibrations

2021 ◽  
Vol 147 (2) ◽  
pp. 04020151
Author(s):  
Jonathon Fagert ◽  
Mostafa Mirshekari ◽  
Shijia Pan ◽  
Linda Lowes ◽  
Megan Iammarino ◽  
...  
2008 ◽  
Author(s):  
Paul V. Cavallaro ◽  
Melvin Jee ◽  
James Cullinane ◽  
Thomas Reynolds ◽  
John Roche

2013 ◽  
Vol 10 (1) ◽  
pp. 98 ◽  
Author(s):  
John G Buckley ◽  
Alan R De Asha ◽  
Louise Johnson ◽  
Clive B Beggs

1977 ◽  
Vol 4 (4) ◽  
pp. 405-411
Author(s):  
A. Farah ◽  
I. M. Ibrahim ◽  
R. Green

Formulations are presented for enhancing the serviceability of one-way floor systems subjected to dynamic loading through the use of constrained viscoelastic layers. The constrained layers are combined with the floors and the resulting systems are analyzed as sandwich structures using a double Fourier series approach. Results indicate that the damping of the resulting sandwich beams is governed by factors related to the elastic and geometric properties of the constrained layer and the constraining system (i.e. cover plates and beams) and the loss modulus of the viscoelastic material, and is highly influenced by the location of the viscoelastic layer in the sandwich beams. Optimum designs of the sandwich beams are obtained using the box algorithm optimization technique.


2009 ◽  
Vol 21 (1) ◽  
pp. 12-19 ◽  
Author(s):  
Shuro Nakajima ◽  
◽  
Eiji Nakano

A leg-wheel robot has mechanically separated four legs and two wheels, and it performs high mobility and stability on rough terrains. The adaptive gait for large rough terrains of the leg-wheel robot is composed of three gait strategies. In this paper, the step-down gait, which is one part of the adaptive gait, is described. The point of the flow of the step-down gait is described. When the robot approaches a downward step, a forefoot touches the surface deeply. It forecasts the existence of the downward step by the information on the forefoot's touch point. After that, the robot does the step edge searching operation. This searching operation is the point for going down the step, since the robot fell under the step if it has walked without knowing the step. When the body goes down the step a little, the load sharing ratio of legs increases so that the load of the body rests upon legs. Therefore, the robot finds the edge of it, and it changes footsteps for preparation of going down the step. After the preparation, it can lower the body from the step supported by all legs and wheels. To lower the body, the following items are needed similar to the case of an upward step: 1. Acquisition of target value of lowering the body. 2. Correspondence to difference between target depth and actual depth. This paper is the full translation from the transactions of JSME Vol.72, No.721.


Sign in / Sign up

Export Citation Format

Share Document