During driving of steel piles through soft, sensitive clay into very dense sand and gravel, pore-water pressure responses were monitored. As a result of the large length of the piles and also because of the high sensitivity of the soft clays, the piles were driven in two stages. During the initial stage of driving in the soft clay, only very small pore-water pressure increases were recorded together with very low pile driving resistances; however, during the second stage of driving, high pore-water pressure increases were observed in the clay as soon as the piles penetrated into the underlying very dense sand and gravel. It was concluded that the clay deposit was loaded from below, as the piles were driven into very dense sand. The total stress changes and the resulting pore-water pressure changes in the clay were analyzed, assuming that the pile driving load was equivalent to a flexible load acting on the surface of an elastic half-space, which represents the soft clay deposit. This interpretation of the pore-water pressure increases is important for the assessment of the bearing capacity of engineering structures affected by piles driven through soft soils into very dense deposits. The potential for high pore-water pressure increases in the clay during undrained loading as well as for volume increases in the dense sand due to pile driving can be predicted from piezocone test data. Key words: pile driving, pore-water pressure, piezocone testing, soft sensitive clays, dense sand deposits.
Dynamic measurement and analysis for accurate models
