scholarly journals Effects of working fluids on cryogenic power generation through two stages organic Rankine cycle

2020 ◽  
Author(s):  
Alkifli Adnan ◽  
Sutrasno Kartohardjono
2015 ◽  
Vol 36 (2) ◽  
pp. 75-84
Author(s):  
Yan-Na Liu ◽  
Song Xiao

AbstractIn this paper, the thermodynamic investigation on the use of geothermal water (130 °C as maximum) for power generation through a basic Rankine has been presented together with obtained main results. Six typical organic working fluids (i.e., R245fa, R141b, R290, R600, R152a, and 134a) were studied with modifying the input pressure and temperature to the turbine. The results show that there are no significant changes taking place in the efficiency for these working fluids with overheating the inlet fluid to the turbine, i.e., efficiency is a weak function of temperature. However, with the increasing of pressure ratio in the turbine, the efficiency rises more sharply. The technical viability is shown of implementing this type of process for recovering low temperature heat resource.


2019 ◽  
Vol 2019 ◽  
pp. 1-15 ◽  
Author(s):  
Suresh Baral

The current research study focuses on the feasibility of stand-alone hybrid solar-geothermal organic Rankine cycle (ORC) technology for power generation from hot springs of Bhurung Tatopani, Myagdi, Nepal. For the study, the temperature of the hot spring was measured on the particular site of the heat source of the hot spring. The measured temperature could be used for operating the ORC system. Temperature of hot spring can also further be increased by adopting the solar collector for rising the temperature. This hybrid type of the system can have a high-temperature heat source which could power more energy from ORC technology. There are various types of organic working fluids available on the market, but R134a and R245fa are environmentally friendly and have low global warming potential candidates. The thermodynamic models have been developed for predicting the performance analysis of the system. The input parameter for the model is the temperature which was measured experimentally. The maximum temperature of the hot spring was found to be 69.7°C. Expander power output, thermal efficiency, heat of evaporation, solar collector area, and hybrid solar ORC system power output and efficiency are the outputs from the developed model. From the simulation, it was found that 1 kg/s of working fluid could produce 17.5 kW and 22.5 kW power output for R134a and R245fa, respectively, when the geothermal source temperature was around 70°C. Later when the hot spring was heated with a solar collector, the power output produced were 25 kW and 30 kW for R134a and R245fa, respectively, when the heat source was 99°C. The study also further determines the cost of electricity generation for the system with working fluids R134a and R245fa to be $0.17/kWh and $0.14/kWh, respectively. The levelised cost of the electricity (LCOE) was $0.38/kWh in order to be highly feasible investment. The payback period for such hybrid system was found to have 7.5 years and 10.5 years for R245fa and R134a, respectively.


Energy ◽  
2014 ◽  
Vol 67 ◽  
pp. 106-116 ◽  
Author(s):  
Wei Liu ◽  
Dominik Meinel ◽  
Christoph Wieland ◽  
Hartmut Spliethoff

2012 ◽  
Vol 614-615 ◽  
pp. 195-199
Author(s):  
Guang Lin Liu ◽  
Jin Liang Xu ◽  
Bing Zhang

In the current paper, under the condition of different flue gas temperatures and constant flue gas thermal power, the influence of different organic working fluids on the efficiency of sub-critical organic Rankine cycle system were studied. The efficiency and other parameters of the simple system were calculated. The results show that the efficiency of sub-critical organic Rankine cycle system could reach maximum when the parameters of the working fluids in the expander inlet are dry-saturation. Flammability, toxicity, ozone depletion and other factors of the working fluids should be considered in the organic Rankine cycles. R245fa is considered a better choice for low-temperature heat source power generation, and the efficiency of the system is about 10.2%; for the high-temperature heat source, R601a can be considered; however, due to its high flammability, novel working fluids should be further discovered for power generation.


2018 ◽  
Vol 10 (8) ◽  
pp. 168781401879407 ◽  
Author(s):  
Wei Liu ◽  
Xiaoyun Zhang ◽  
Ningbo Zhao ◽  
Chunying Shu ◽  
Shanke Zhang ◽  
...  

Intercooled cycle gas turbine has great potential in improving the output power because of the low energy consumption of high-pressure compressor. In order to more efficiently recovery and utilize the waste heat of the intercooled system, an organic Rankine cycle power generation system is developed to replace the traditional intercooled system in this study. Considering the effects of different kinds of organic working fluids, the thermodynamic performance of organic Rankine cycle power generation system is investigated in detail. On this basis, the sensitivity analyses of some key parameters are conducted to study the operating improvements of organic Rankine cycle power generation system. The results indicate that the integration of organic Rankine cycle and intercooled cycle gas turbine not only can be used for waste heat power generation but also increases the output power and efficiency of intercooled cycle gas turbine by selecting the organic working fluids of n-butane (R600), n-pentane (R601), toluene, and n-heptane. And compared to the others, organic Rankine cycle power generation system with toluene exhibits the best performance. The maximum enhancements of output power and thermal efficiency are 6.08% and 2.14%, respectively. Moreover, it is also concluded that both ambient temperatures and intercooled cycle gas turbine operating conditions are very important factors affecting the operating performances of organic Rankine cycle power generation system.


Sign in / Sign up

Export Citation Format

Share Document