Inertia- and shear-induced inhomogeneities in non-Brownian mono and bidisperse suspensions under wall-bounded linear shear flow

2021 ◽  
Vol 33 (5) ◽  
pp. 053318
Author(s):  
Byoungjin Chun ◽  
Hyun Wook Jung
2021 ◽  
Vol 6 (10) ◽  
Author(s):  
Pengyu Shi ◽  
Roland Rzehak ◽  
Dirk Lucas ◽  
Jacques Magnaudet

2010 ◽  
Vol 657 ◽  
pp. 89-125 ◽  
Author(s):  
HYUNGOO LEE ◽  
S. BALACHANDAR

Recent research (Zeng, PhD thesis, 2007; Zeng et al., Phys. Fluids, vol. 21, 2009, art. no. 033302) has shown that both the shear- and wall-induced lift contributions on a particle sharply increase as the gap between the wall and the particle is decreased. Explicit expressions that are valid over a range of finite Re were obtained for the drag and lift forces in the limiting cases of a stationary particle in wall-bounded linear flow and of a particle translating parallel to a wall in a quiescent ambient. Here we consider the more general case of a translating and rotating particle in a wall-bounded linear shear flow where shear, translational and rotational effects superpose. We have considered a modest Reynolds number range of 1–100. Direct numerical simulations using immersed boundary method were performed to systematically figure out the characteristics of hydrodynamic forces on a finite-sized particle moving while almost in contact with a wall. We present composite correlation for the hydrodynamic forces which are in agreement with all the available low-Reynolds-number theories.


1993 ◽  
Vol 246 ◽  
pp. 249-265 ◽  
Author(s):  
John B. McLaughlin

This paper presents a closed-form solution for the inertial lift force acting on a small rigid sphere that translates parallel to a flat wall in a linear shear flow. The results provide connections between results derived by other workers for various limiting cases. An analytical form for the lift force is derived in the limit of large separations. Some new results are presented for the disturbance flow created by a small rigid sphere translating through an unbounded linear shear flow.


2020 ◽  
Vol 5 (7) ◽  
Author(s):  
Pengyu Shi ◽  
Roland Rzehak ◽  
Dirk Lucas ◽  
Jacques Magnaudet

2006 ◽  
Vol 18 (12) ◽  
pp. 121504 ◽  
Author(s):  
Micheline Abbas ◽  
Eric Climent ◽  
Olivier Simonin ◽  
Martin R. Maxey

Author(s):  
Remi Bourguet ◽  
Michael S. Triantafyllou ◽  
Michael Tognarelli ◽  
Pierre Beynet

The fluid-structure energy transfer of a tensioned beam of length to diameter ratio 200, subject to vortex-induced vibrations in linear shear flow, is investigated by means of direct numerical simulation at three Reynolds numbers, from 110 to 1,100. In both the in-line and cross-flow directions, the high-wavenumber structural responses are characterized by mixed standing-traveling wave patterns. The spanwise zones where the flow provides energy to excite the structural vibrations are located mainly within the region of high current where the lock-in condition is established, i.e. where vortex shedding and cross-flow vibration frequencies coincide. However, the energy input is not uniform across the entire lock-in region. This can be related to observed changes from counterclockwise to clockwise structural orbits. The energy transfer is also impacted by the possible occurrence of multi-frequency vibrations.


Sign in / Sign up

Export Citation Format

Share Document