〈310〉Single-Crystal LaB<sub>6</sub> as Thermal Field Emitter of High Brightness Electron Source

Thermal field emission (T.F.E.) properties of single crystal LaB6 -tips has been investigated by observing emission patterns. Applying field evaporation technique we succeeded to get the clean pattern consisting of <310> spots with very good reproducibility. This investigation has led to conclusion;, the <310> spot is promising electron source of high brightness provided that the tip is operated at tip temperature∽ 1000-1050°C in vacuum of 10−9 Torr region.As a preliminary experiment of brightness-measurement, we mounted the <310> LaB6-tip in a commercial type TEM, JEM-100CX-FEG, attached with an electron gun system for T.F.E. of <100> W-tip, being operated at 10−9 Torr region without Schottky shield electrode. The LaB6-tip, however, can not be operated without the Schottky shield because thermionic emission (T.E.) from the LaB6-tip is considerably high even though the tip is operated at lower than ∽1000 °C. In the present experiment, therefore, we manufactured a Schottky shield electrode as shown in Fig.l and performed the measurement of brightness by setting the Schottky shield electrode, applied the same voltage as the tip since the electron gun system has no extra feed-throughs for bias-voltage.

Download Full-text

An abnormal thermal field emission high brightness and stability point electron source

2014 2nd 2014 2nd International Conference on Emission Electronics (ICEE) ◽

10.1109/emission.2014.6893975 ◽

2014 ◽

Author(s):

Valery E. Ptitsin

Keyword(s):

Field Emission ◽

Thermal Field ◽

Electron Source ◽

High Brightness ◽

Stability Point

Download Full-text

An abnormal thermal field emission high brightness and stability point electron source

2014 Tenth International Vacuum Electron Sources Conference (IVESC) ◽

10.1109/ivesc.2014.6892064 ◽

2014 ◽

Author(s):

V. E. Ptitsin

Keyword(s):

Field Emission ◽

Thermal Field ◽

Electron Source ◽

High Brightness ◽

Stability Point

Download Full-text

An abnormal thermal field emission point electron source with high brightness and stability

2015 28th International Vacuum Nanoelectronics Conference (IVNC) ◽

10.1109/ivnc.2015.7225566 ◽

2015 ◽

Author(s):

V.E. Ptitsin

Keyword(s):

Field Emission ◽

Thermal Field ◽

Electron Source ◽

High Brightness ◽

Emission Point

Download Full-text

Optical Properties of HVEM Accelerators

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100114529 ◽

1975 ◽

Vol 33 ◽

pp. 180-181

Author(s):

A. Strojnik ◽

J.W. Scholl ◽

V. Bevc

Keyword(s):

Optical Properties ◽

Electron Accelerator ◽

Systematic Investigation ◽

Electron Source ◽

High Brightness ◽

The Past ◽

Wide Range ◽

Optical Behavior

The electron accelerator, as inserted between the electron source (injector) and the imaging column of the HVEM, is usually a strong lens and should be optimized in order to ensure high brightness over a wide range of accelerating voltages and illuminating conditions. This is especially true in the case of the STEM where the brightness directly determines the highest resolution attainable. In the past, the optical behavior of accelerators was usually determined for a particular configuration. During the development of the accelerator for the Arizona 1 MEV STEM, systematic investigation was made of the major optical properties for a variety of electrode configurations, number of stages N, accelerating voltages, 1 and 10 MEV, and a range of injection voltages ϕ0 = 1, 3, 10, 30, 100, 300 kV).

Download Full-text

A comparative study on the cold type and thermal type field emission guns used in the same electron microscope

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100107435 ◽

1978 ◽

Vol 36 (1) ◽

pp. 58-59

Author(s):

M. Iwatsuki ◽

Y. Kokubo ◽

Y. Harada

Keyword(s):

Electron Microscope ◽

Field Emission ◽

Signal To Noise Ratio ◽

Electron Source ◽

Resolving Power ◽

Optical Source ◽

Experimental Conditions ◽

High Brightness ◽

Illumination System ◽

Transmission Electron

On accout of its high brightness, small optical source size, and minimal energy spread, the field emission gun (FEG) has the advantage that it provides the conventional transmission electron microscope (TEM) with a highly coherent illumination system and directly improves the resolving power and signal-to-noise ratio of the scanning electron microscope (SEM). The FEG is generally classified into two types; the cold field emission (C-FEG) and thermal field emission gun (T-FEG). The former, in which a field emitter is used at the room temperature, was successfully developed as an electron source for the SEM. The latter, in which the emitter is heated to the temperature range of 1000-1800°K, was also proved to be very suited as an electron source for the TEM, as well as for the SEM. Some characteristics of the two types of the FEG have been studied and reported by many authors. However, the results of the respective types have been obtained separately under different experimental conditions.

Download Full-text