Indirect Measurement of Left-atrial Pressure in Surgical Patients– Pulmonary-capillary Wedge and Pulmonary-artery Diastolic Pressures Compared with Left-atrial Pressure

1973 ◽  
Vol 38 (4) ◽  
pp. 394-397 ◽  
Author(s):  
Demetriuos Lappas ◽  
William A. Lell ◽  
Joseph C. Gabel ◽  
Joseph M. Civetta ◽  
Edward Lowenstein
Author(s):  
Patrick Magee ◽  
Mark Tooley

The pulmonary artery catheter was the mainstay of clinical cardiac output measurement for many years, but because of its relatively invasive nature and the lack of improvement of clinical outcome with its use, it is now seldom used in a modern clinical environment. Any perceived accuracy of the technique is now considered unnecessary in the face of the risks of its use, and with the introduction of newer non-invasive techniques. Nevertheless, it is worth describing, partly because of its historical interest, and partly because of the technologies involved. A catheter passed into the right atrium from an easily accessible central vein can be passed through the right ventricle and out into the pulmonary arterial tree while the vascular waveforms are visualised. Figure 13.1 shows the waveforms as they appear to the user. A small balloon at the tip of the catheter allows it to be flow directed and wedged in a pulmonary arterial vessel. At this point the pulsatile waveform is lost and the tip of the catheter is looking ahead, down the pulmonary arterial tree towards the left atrium, a system with a relatively low pressure drop from one end to the other, the flow in that vessel having been brought temporarily to a standstill. Thus the pulmonary artery occlusion pressure (PAOP) or pulmonary capillary wedge pressure (PCWP) can be considered a reasonably accurate representation of left atrial pressure or left ventricular filling pressure. This assumes that there is no pulmonary vascular disease, such as pulmonary hypertension, or mitral valve disease, in which case PAOP would not be an accurate representation of left atrial pressure. If the catheter is placed in the apical region of the pulmonary vascular tree, the excess of the alveolar pressure in inspiration over pulmonary capillary pressure becomes significant, and the latter is a less accurate reflection of left atrial pressure. The balloon should not be over-inflated for fear of rupturing the pulmonary artery, and this is one of its perceived risks that has led to less usage. Once the measurement has been made, the balloon should be deflated so that the pulmonary arterial waveform is once again visible, if necessary withdrawing the catheter a bit to achieve this; failure to do so would result in regional lack of perfusion and may result in ischaemia.


2014 ◽  
Vol 167 (6) ◽  
pp. 876-883 ◽  
Author(s):  
Anikó I. Nagy ◽  
Ashwin Venkateshvaran ◽  
Pravat Kumar Dash ◽  
Banajit Barooah ◽  
Béla Merkely ◽  
...  

1991 ◽  
Vol 19 (3) ◽  
pp. 399-404
Author(s):  
REINHOLD FRETSCHNER ◽  
THOMAS KLÖSS ◽  
HEINZ GUGGENBERGER ◽  
DIETER HEUSER ◽  
HANS-JÖRG SCHMID

1994 ◽  
Vol 77 (5) ◽  
pp. 2093-2103 ◽  
Author(s):  
R. M. Effros ◽  
A. Hacker ◽  
E. Jacobs ◽  
S. Audi ◽  
C. Murphy

The impact of physiological and pathological processes on metabolism and transport of a variety of substances traversing the pulmonary vasculature depends in part on the capillary surface area available for exchange, and a reliable method for detecting changes in this parameter is needed. In this study, a continuous-infusion approach was used to investigate the response of the pulmonary capillary surface area to increases in flow and left atrial pressure. Isolated rat lungs were perfused with an acellular perfusion solution containing 125I-labeled albumin (an intravascular indicator) and 201Tl, a K+ analogue which is concentrated within lung cells. The extraction of 201Tl from the perfusate was 61% greater at low flow (8.5 ml/min) than at high flow (26 ml/min), and rapid changes in extraction were observed when flow was altered. In contrast, the permeability-surface area product was 76% greater when lungs were perfused at high flow than at low flow, suggesting comparable increases in pulmonary capillary surface area in these zone 2 lungs (airway pressure = 5 cmH2O, left atrial pressure < 0 cmH2O). In a second group of experiments, increases in left atrial pressure to 14 cmH2O (zone 3 lungs) at a constant flow of 8.5 ml/min increased the permeability-surface area product by only 18% despite increases in average intravascular pressure that were at least as high as those associated with high perfusion rates. 201Tl infusions provide a useful method for detecting and quantifying changes in pulmonary capillary surface area.


Sign in / Sign up

Export Citation Format

Share Document