IN VIVO FORCE-DISPLACEMENT RESPONSE OF THE HEALTHY GLENOHUMERAL JOINT

2001 ◽  
Vol 33 (5) ◽  
pp. S53
Author(s):  
P A. Borsa ◽  
E L. Sauers ◽  
D E. Herling
2021 ◽  
pp. 875529302199483
Author(s):  
Eyitayo A Opabola ◽  
Kenneth J Elwood

Existing reinforced concrete (RC) columns with short splices in older-type frame structures are prone to either a shear or bond mechanism. Experimental results have shown that the force–displacement response of columns exhibiting these failure modes are different from flexure-critical columns and typically have lower deformation capacity. This article presents a failure mode-based approach for seismic assessment of RC columns with short splices. In this approach, first, the probable failure mode of the component is evaluated. Subsequently, based on the failure mode, the force–displacement response of the component can be predicted. In this article, recommendations are proposed for evaluating the probable failure mode, elastic rotation, drift at lateral failure, and drift at axial failure for columns with short splices experiencing shear, flexure, or bond failures.


2015 ◽  
Vol 43 (11) ◽  
pp. 2800-2808 ◽  
Author(s):  
Cathryn D. Peltz ◽  
Timothy G. Baumer ◽  
Veronica Mende ◽  
Nicole Ramo ◽  
Nima Mehran ◽  
...  

2018 ◽  
Vol 140 (7) ◽  
Author(s):  
Quental Carlos ◽  
Azevedo Margarida ◽  
Ambrósio Jorge ◽  
Gonçalves S. B. ◽  
Folgado João

Abstract Most dynamic simulations are based on inverse dynamics, being the time-dependent physiological nature of the muscle properties rarely considered due to numerical challenges. Since the influence of muscle physiology on the consistency of inverse dynamics simulations remains unclear, the purpose of the present study is to evaluate the computational efficiency and biological validity of four musculotendon models that differ in the simulation of the muscle activation and contraction dynamics. Inverse dynamic analyses are performed using a spatial musculoskeletal model of the upper limb. The muscle force-sharing problem is solved for five repetitions of unloaded and loaded motions of shoulder abduction and shoulder flexion. The performance of the musculotendon models is evaluated by comparing muscle activation predictions with electromyography (EMG) signals, measured synchronously with motion for 11 muscles, and the glenohumeral joint reaction forces estimated numerically with those measured in vivo. The results show similar muscle activations for all muscle models. Overall, high cross-correlations are computed between muscle activations and the EMG signals measured for all movements analyzed, which provides confidence in the results. The glenohumeral joint reaction forces estimated compare well with those measured in vivo, but the influence of the muscle dynamics is found to be negligible. In conclusion, for slow-speed, standard movements of the upper limb, as those studied here, the activation and musculotendon contraction dynamics can be neglected in inverse dynamic analyses without compromising the prediction of muscle and joint reaction forces.


Author(s):  
Hippolite O. Amadi

Advanced surgical planning techniques often require modeling the functional characteristics of the affected body region. Most patient-specific modeling in vivo relies on medical image scans that are expensive and may also allow patient’s exposure to ionizing radiation. This poses a challenge for the modeling of the kinematics of the glenohumeral joint (GHJ) based on the tissue geometries of the affected patients. The humeral morphology uniquely presents its canal (HC) and epicondyle (EC) axes as the two longest axes that are nearly orthogonal. This gives them the mathematical advantages as best axes for the definition of humeral coordinate system (HCS), especially from 2D radiographic images. This is however limited in 3D in vivo kinematics as minimization of radiation exposure may not allow medical imaging of the whole volume of interest all the way down to the distal epicondyles. It is therefore necessary that landmarks for use are captured within the field of view (FOV) of standard shoulder scans. This would avoid extra radiation exposure to patients and imaging cost as the scan might have been used earlier for traditional diagnosis. The aims of this study were to (1) confirm that HC-axis quantified from a ‘stack of discs (SOD)’ technique was the most reliable and consistent (2) identify the most closely oriented or most inter-subject related axis to the EC-axis for its replacement or prediction respectively from 3D proximal humeral scan and (3) use these to propose a HCS definition procedure that can be applied to a standard shoulder scan.


Sign in / Sign up

Export Citation Format

Share Document