Thermal and electrical experimental characterization of Ethylene Glycol and water mixture nanofluids for a 400w Proton Exchange Membrane Fuel Cell

2014 ◽  
Author(s):  
Irnie Azlin Zakaria ◽  
Zeno Michael ◽  
Aman Mohd Ihsan Mamat ◽  
Wan Ahmad Najmi Wan Mohamed
Keyword(s):  
Fuel Cell ◽  
Ethylene Glycol ◽  
Proton Exchange Membrane ◽  
Proton Exchange ◽  
Water Mixture ◽  
Experimental Characterization ◽  
Exchange Membrane

Thermal and Electrical Experimental Characterization of Ethylene Glycol and Water Mixture Coolants for a 400 W Proton Exchange Membrane Fuel

2014 ◽  
Vol 660 ◽  
pp. 391-396 ◽  
Author(s):  
Irnie Azlin Zakaria ◽  
Zeno Michael ◽  
Suhadiyana Hanapi ◽  
Wan Ahmad Najmi Wan Mohamed
Keyword(s):  
Heat Transfer ◽  
Ethylene Glycol ◽  
Transfer Rate ◽  
Proton Exchange Membrane ◽  
Proton Exchange ◽  
Water Mixture ◽  
Experimental Characterization ◽  
Exchange Membrane ◽  
Transfer Study

Nanofluid is an emerging technology in heat transfer study. The effect of nanofluids as a cooling medium in Proton Exchange Membrane Fuel Cell (PEMFC) is studied. Nanofluids with 0.1% and 0.5% of Al2O3 dispersed in base fluid of 50:50 mixture of Ethylene Glycol and water were analyzed experimentally. A 400 W liquid cooled PEMFC was used to verify the findings. The result showed that insignificant improvement in performance of PEMFC with nanofluids, perhaps due to the lower wattage of PEMFC used. However, the thermal performance is improved through the heat transfer rate increment of 68.5 % and 46 % for both 0.5 % of Al2O3 nanofluid and 0.1 % of Al2O3 nanofluid respectively.

Experimental characterization of internal currents during the start-up of a proton exchange membrane fuel cell

2011 ◽  
Vol 196 (22) ◽  
pp. 9451-9458 ◽  
Author(s):  
A. Lamibrac ◽  
G. Maranzana ◽  
O. Lottin ◽  
J. Dillet ◽  
J. Mainka ◽  
...  
Keyword(s):  
Fuel Cell ◽  
Proton Exchange Membrane ◽  
Proton Exchange ◽  
Experimental Characterization ◽  
Start Up ◽  
Exchange Membrane

scholarly journals PEMBUATAN DAN KARAKTERISASI MEMBRAN KOMPOSIT KITOSAN-SODIUM ALGINAT TERFOSFORILASI SEBAGAI PROTON EXCHANGE MEMBRANE FUEL CELL (PEMFC)

2016 ◽  
Vol 1 (1) ◽  
pp. 14
Author(s):  
Siti Wafiroh ◽  
Suyanto Suyanto ◽  
Yuliana Yuliana
Keyword(s):  
Fuel Cell ◽  
Sodium Alginate ◽  
Proton Conductivity ◽  
Composite Membrane ◽  
Proton Exchange Membrane ◽  
Proton Exchange ◽  
Methanol Permeability ◽  
Water Swelling ◽  
Exchange Membrane

AbstrakDi era globalisasi ini, kebutuhan bahan bakar fosil semakin meningkat dan ketersediannya semakin menipis. Oleh karena itu, dibutuhkan bahan bakar alternatif seperti Proton Exchange Membrane Fuel Cell (PEMFC). Tujuan dari penelitian ini adalah membuat dan mengkarakterisasi membran komposit kitosan-sodium alginat dari rumput laut coklat (Sargassum sp.) terfosforilasi sebagai Proton Exchange Membrane Fuel Cell (PEMFC). PEM dibuat dengan 4 variasi perbandingan konsentrasi antara kitosan dengan sodium alginat 8:0, 8:1, 8:2, dan 8:4 (b/b). Membran komposit kitosan-sodium alginat difosforilasi dengan STPP 2N. Karakterisasi PEM meliputi: uji tarik, swelling air, kapasitas penukar ion, FTIR, SEM, permeabilitas metanol, dan konduktivitas proton. Berdasarkan hasil analisis tersebut, membran yang optimal adalah perbandingan 8:1 (b/b) dengan nilai modulus young sebesar 0,0901 kN/cm2, swelling air sebesar 19,14 %, permeabilitas metanol sebesar 72,7 x 10-7, dan konduktivitas proton sebesar 4,7 x 10-5 S/cm. Membran komposit kitosan-sodium alginat terfosforilasi memiliki kemampuan yang cukup baik untuk bisa diaplikasikan sebagai membran polimer elektrolit dalam PEMFC. Kata kunci: kitosan, sodium alginat, terfosforilasi, PEMFC  AbstractIn this globalization era, the needs of fossil fuel certainly increases, but its providence decreases. Therefore, we need alternative fuels such as Proton Exchange Membrane Fuel Cell (PEMFC). The purpose of this study is preparationand characterization of phosphorylated chitosan-sodium alginate composite membrane from brown seaweed (Sargassum sp.) as Proton Exchange Membrane Fuel Cell (PEMFC). PEM is produced with 4 variations of concentration ratio between chitosan and sodium alginate 8:0, 8:1, 8:2, and 8:4 (w/w). Chitosan-sodium alginate composite membrane phosphorylated with 2 N STPP. The characterization of PEM include: tensile test, water swelling, ion exchange capacity, FTIR, SEM, methanol permeability, and proton conductivity. Based on the analysis result, the optimal membrane is ratio of 8:1 (w/w) with the value of Young’s modulus about 0.0901 kN/cm2, water swelling at 19.14%, methanol permeability about 72.7 x 10-7, and proton conductivity about 4.7 x 10-5 S/cm. The phosphorylated chitosan-sodium alginate composite membrane has good potentials for the application of the polymer electrolyte membrane in PEMFC. Keywords: chitosan, sodium alginate, phosphorylated, PEMFC

scholarly journals Evaluation on Thermo-Electrical Characteristics of Sio2 Nanofluids for Fuel Cell Cooling Application in Automobiles

2018 ◽  
Vol 7 (3.17) ◽  
pp. 137
Author(s):  
Suleiman Akilu ◽  
Aklilu Tesfamichael Baheta ◽  
K V. Sharma
Keyword(s):  
Fuel Cell ◽  
Ethylene Glycol ◽  
Proton Exchange Membrane ◽  
Membrane System ◽  
Proton Exchange ◽  
Electrical Performance ◽  
Particle Volume ◽  
System A ◽  
Critical Requirement ◽  
Exchange Membrane

Effective thermal management is critical requirement in fuel cell technologies to avoid the performance degradation during operation. Nanofluids offer the potential to address this cooling challenge in fuel cells better than pure fluids. However, due to the electrochemical changes associated with the proton exchange membrane system, a strict limit on thermal and electrical properties of coolant needs to comply. In this study, the thermal and electrical conductivities of silicon dioxide (SiO2) dispersion of ethylene glycol (EG), glycerol (G), and 40:60 by mass ethylene glycol-glycerol (EG/G) was investigated experimentally. Measurements were carried for particle volume concentrations of 0.25–2.0% at a temperature of 30 °C. The thermal and electrical conductivity of the nanofluids significantly increases with SiO2 loading. Maximum enhancements of ∼4.0% and ∼198% at a volume concentration of 2.0% were obtained with SiO2-EG/G, respectively. Further, analysis of the results reveals that SiO2/G exhibited the greatest thermo-electrical performance, followed by SiO2-EG/G and EG. Therefore, SiO2-EG/G nanofluid is best-suited coolant for PEM fuel cell thermal applications.  

Sign in / Sign up

Export Citation Format

Share Document