Abstract
When the enameled wire is winded onto the poles of the motor stator or rotor, the winding quality hugely relies on the control precision of the tension. Therefore, it is necessary to control the tension of the enameled wire in winding process. A tension control system is built with single chip microcomputer, the encoder and the servo motor. The PID feedback controller and feedforward controller are combined to form feedforward feedback controller, which using feedback information of swing angle deviation and feedforward information of wire frame position to adjust the pay off speed dynamically and control tension of enameled wire further. A procedural experimental modelling method is discussed in order to identify the feedforward model. The experiment is performed, it is found that in the typical situation of setting tension 1500 g, the tension fluctuation rate of the PID controller with feedforward model is only 2%, which is far better than that of pure PID controller with a fluctuation rate of 14%. The result shows that the proposed experimental modelling method hosts the characteristics of good accuracy, universality and applicability.
Research on Tension Control System of Reciprocating Winding
