Mining Subsidence Calculation System

Author(s):  
Lailiang Cai ◽  
Kan Wu ◽  
Ruyu Zheng ◽  
Ru Li
2011 ◽  
Vol 308-310 ◽  
pp. 1683-1687
Author(s):  
Fei Hong Xie ◽  
Zhi Yong Kou ◽  
Yong Mou Zhang

In this paper, In order to reasonably determine the mining width and reserves length of strip mining, reliable simulation subsidence due to strip mining under earth,according to the cavity environment of the engineering measure, the protected object's space position and the mining rock strata's circumstance, and the relevant mining subsidence mechanic, calculation model are chosen in order to predicting the designing mining area transform and data sorting after mining. Its function and perform is put into practice for all various aspects of subsidence calculation in visual analysis system of own developed software package. It is applicable to all mining geological conditions and mining methods. Based on the condition of strip and pillar practice of Matigou colliery of Huating Mining Group, It is also applicable to this calculation system to guide successfully mining under river and architectural complex, the accurate estimate forecast had been attained.


2020 ◽  
Vol 140 (11) ◽  
pp. 1286-1294
Author(s):  
Fumiya Shimizu ◽  
Masataka Tanaka ◽  
Kohei Haruta ◽  
Motonobu Saito
Keyword(s):  

2018 ◽  
Vol 11 (48) ◽  
pp. 132-141
Author(s):  
Kutepov Yu.I. ◽  
◽  
Gusev V.N. ◽  
Kutepov Yu.Yu. ◽  
Borger E.B. ◽  
...  

Author(s):  
I. Statham ◽  
C. Golightly ◽  
G. Treharne

AbstractThe Department of the Environment and the Welsh Office jointly sponsored a South Wales Desk Study into the feasibility of producing thematic maps of the Mining subsidence risk for planners. A method was to be developed and tested for a 25 km2 Pilot Area centred on Ebbw Vale.The study was started by collecting geological and mining data for the Pilot Area and compiling this information on a map. It was then intended to prepare the mining subsidence map from this map by back analysing subsidence incidents to determine the hazardous areas. This simple approach could not be followed for two reasons. First, the record of mining was incomplete and it was therefore necessary to define ‘worked’ seams and areas from the total historical record and not only from the surviving mine plans. Secondly, insufficient subsidence incidents were discovered in the Pilot Area to carry out meaningful back analysis.The study was extended to collect all readily available records of subsidence incidents throughout the Coalfield. A total of 388 were traced, mainly dating from 1960. About threequarters were collapses through superficial materials and were either close to the outcrop or above mine entries, the remaining 25% propagated to the ground surface through rock. The upper limit of migration was typically 8 times the extracted height where the dip was shallow, incrasing to as much as 18 times for steep dips. Selected grout contracts and opencast mining sites were also examined to gain information on the present condition of old workings and to study the ‘reputations’ of the various seams for voids.The results of the coalfield study were applied to the Pilot Area to produce a 1:10 000 scale Development Advice Map, ‘Mining Subsidence for use by developers and planners’. The map is zoned to show areas where specialist advice is necessary to support a planning application and it also shows all mine entries traced by the desk study. The method of production is general for the South Wales Coalfield and further maps could be prepared, using the Coalfield Study, quickly and cheaply.


Sign in / Sign up

Export Citation Format

Share Document