Study of the transient performance of Electronic Current Transformer based on printed circuit board rogowski coil

Author(s):  
Chengyuan Wang ◽  
Chunyan Gao ◽  
Gang Zhang ◽  
Youping Chen
Sensors ◽  
2019 ◽  
Vol 19 (19) ◽  
pp. 4176 ◽  
Author(s):  
Chaoqun Jiao ◽  
Juan Zhang ◽  
Zhibin Zhao ◽  
Zuoming Zhang ◽  
Yuanliang Fan

With the development of China’s electric power, power electronics devices such as insulated-gate bipolar transistors (IGBTs) have been widely used in the field of high voltages and large currents. However, the currents in these power electronic devices are transient. For example, the uneven currents and internal chip currents overshoot, which may occur when turning on and off, and could have a great impact on the device. In order to study the reliability of these power electronics devices, this paper proposes a miniature printed circuit board (PCB) Rogowski coil that measures the current of these power electronics devices without changing their internal structures, which provides a reference for the subsequent reliability of their designs.


2014 ◽  
Vol 21 (1) ◽  
pp. 121-132 ◽  
Author(s):  
Ming Zhang ◽  
Kaicheng Li ◽  
Shunfan He ◽  
Jun Wang

Abstract This paper describes the design and test of a new high-current electronic current transformer based on a Rogowski coil. For better performances, electronic current transformers are used to replace conventional electro-magnetic inductive current transformers based on ferromagnetic cores and windings to measure high-current on the high voltage distribution grids. The design of a new high-current electronic current transformer is described in this paper. The principal schemes of the prototype and partial evaluation results are presented. Through relative tests it is known that the prototype has a wide dynamic range and frequency band, and it can allow high accuracy measurements.


2014 ◽  
Vol 1070-1072 ◽  
pp. 1085-1091
Author(s):  
Xiao Bin Liang ◽  
Fan Tang ◽  
Jie Wu ◽  
Wei Zhen

Electronic current transformer is one of the key equipment of intelligent substation and has a direct impact to the correct operation of relay protection devices. In order to accurately establish the dynamic response model of electronic current transformer, it is needed to extract electromagnetic parameters of Rogowski coil, which is the electromagnetic coupling part of electronic current transformer. This paper builds the electromagnetic parameters model and extracts the electromagnetic distribution parameters of Rogowski coil based on the finite element method, then we use the equivalent method to calculate the lumped electromagnetic parameter. At last, comparing with the experimental results, a good accuracy of the simulation results based on finite element method is presented.


Sign in / Sign up

Export Citation Format

Share Document