2015 ◽  
Vol 33 (5) ◽  
pp. 1132-1141 ◽  
Author(s):  
Zhongbiao Chen ◽  
Biao Zhang ◽  
Yijun He ◽  
Zhongfeng Qiu ◽  
William Perrie

1982 ◽  
Author(s):  
F. Jackson ◽  
W. Walton ◽  
P. Baker
Keyword(s):  

1969 ◽  
Vol 95 (4) ◽  
pp. 437-448
Author(s):  
Thorbjorn Karlsson
Keyword(s):  

1963 ◽  
Vol 53 (1) ◽  
pp. 27-37
Author(s):  
R. A. Haubrich ◽  
W. H. Munk ◽  
F. E. Snodgrass

Abstract Spectra of seismic and ocean wave recordings near San Diego, California, show closely related features. The wave spectra consist of a sharp peak whose frequency, f(t), increases linearly with time and consistent with the expected dispersive behaviour from a source at 6150 nautical miles (presumably a storm in the Ross Sea). The seismic spectra show peaks at f(t) and at 2 f(t); the double frequency peak contains 100 times the energy of the peak at the primary frequency. A comparison between the peak frequencies and band widths of the seismic and ocean wave spectra, and an estimate of the direction and beam width of the seismic radiation, leads to the following conclusions: that the microseismic generation area is predominantly local, being confined to a distance of 100 miles up or down the coast. For the primary frequencies the generative strip is presumably confined to shallow water; for the double frequencies it extends 200 miles seaward.


1976 ◽  
Vol 1 (15) ◽  
pp. 6
Author(s):  
Davidson T. Chen ◽  
Benjamin S. Yaplee ◽  
Donald L. Hammond ◽  
Paul Bey

The ability to measure the wave spectra in the open ocean from a moving vessel has met with varying degrees of success. Each sensor to date has suffered in its performance due to environmental conditions or due to its physical placement aboard the vessel for measuring the unperturbed sea. This paper will discuss the utilization of a microwave sensor on a moving vessel for measuring the open ocean wave spectra. Employing microwaves, some of the limitations of other sensors are not experienced. Tucker [1] developed the Tuckermeter for measuring the wave spectra from a moving ship by sensing changes in water pressure due to surface wave conditions. The Tuckermeter is placed below the water line and thus requires calibration for each wave frequency, ship speed, and depth. Since the sensor operates on pressure, it performs as a low pass filter and will not sense the higher frequencies. A microwave shipboard wave height radar sensor for measuring the ocean wave spectra was developed by the Naval Research Laboratory (NRL) and was installed on the S.S. McLean in February 1975 and its performance, design, and analysis of data for one data run will be discussed.


Sign in / Sign up

Export Citation Format

Share Document