Coupling-Routing-Diagram Model of Non-Reciprocal Bandpass Filter With Single-Band-Forward and Dual-Band-Backward Behavior

Author(s):  
Roberto Gomez-Garcia ◽  
Jose-Maria Munoz-Ferreras ◽  
Li Yang ◽  
Dimitra Psychogiou
2019 ◽  
Vol 61 (11) ◽  
pp. 2586-2590
Author(s):  
Ali Kursad Gorur ◽  
Pinar Ozturk Ozdemir ◽  
Ceyhun Karpuz ◽  
Adnan Gorur

2017 ◽  
Vol 14 (19) ◽  
pp. 20170832-20170832 ◽  
Author(s):  
Sheng Zhang ◽  
Jia-Yu Rao ◽  
Jun-Jie Cheng ◽  
Xue-Dong Fu ◽  
Fa-Lin Liu ◽  
...  

2020 ◽  
Vol 35 (10) ◽  
pp. 1217-1221
Author(s):  
Chen Liang ◽  
Yun Liu ◽  
Fanbin Tai

Folded quad-mode stub-loaded loop resonators (QMSLLRs) are proposed for realizing both bandpass and dual-band bandpass filters with compact dimensions. The QMSLLR is a folded square loop loaded with four short stubs, providing structure symmetry in both transversal and longitudinal directions. Determined by the lengths of the loaded stubs, the four resonant frequencies as analyzed with even-odd mode method can be either distributed in one passband with equal space, or in two passbands with a guard band in between, for realizing a single-band bandpass filter or a dual-band bandpass filter, respectively. For both the input and output couplings, two perpendicular feeding lines are parallel coupled to the QMSLLR at one corner. The measure results prove that the structure is suitable for the design of a medium band or even narrow band bandpass filters with compact dimensions.


2012 ◽  
Vol 198-199 ◽  
pp. 1720-1725
Author(s):  
Guo Gao Liu ◽  
Li Tian

A novel microstrip bandpass filter using stepped impedance resonators (SIRs) with asymmetric open stub-loaded is proposed in this paper. The filter uses asymmetric open stubs as capacitive loads, resulting in higher-order spurious frequencies suppression and wider upper stopband. Compared with the traditional filter based on stepped impedance resonators at the same design frequency of 2.4 GHz, the proposed filter can significantly reduce the circuit size of 45 %. By changing the geometric dimensions of the asymmetric open stub-loaded SIRs, which can achieve single-band bandpass filter at the centre frequency of 3.5 GHz and dual-band bandpass filter at the centre frequency of 2.4/3.5 GHz.


Author(s):  
Imane Halkhams ◽  
Said Mazer ◽  
Mahmoud Mehdi ◽  
Moulhime El Bekkali ◽  
Wafae El Hamdani

Electronics ◽  
2021 ◽  
Vol 10 (11) ◽  
pp. 1321
Author(s):  
Wahaj Abbas Awan ◽  
Syeda Iffat Naqvi ◽  
Wael Abd Ellatif Ali ◽  
Niamat Hussain ◽  
Amjad Iqbal ◽  
...  

This paper presents a compact and simple reconfigurable antenna with wide-band, dual-band, and single-band operating modes. Initially, a co-planar waveguide-fed triangular monopole antenna is obtained with a wide operational frequency band ranging from 4.0 GHz to 7.8 GHz. Then, two additional stubs are connected to the triangular monopole through two p-i-n diodes. By electrically switching these p-i-n diodes ON and OFF, different operating frequency bands can be attained. When turning ON only one diode, the antenna offers dual-band operations of 3.3–4.2 GHz and 5.8–7.2 GHz. Meanwhile, the antenna with single-band operation from 3.3 GHz to 4.2 GHz can be realized when both of the p-i-n diodes are switched to ON states. The proposed compact size antenna with dimensions of 0.27λ0 × 0.16λ0 × 0.017λ0 at the lower operating frequency (3.3 GHz) can be used for several wireless applications such as worldwide interoperability for microwave access (WiMAX), wireless access in the vehicular environment (WAVE), and wireless local area network (WLAN). A comparative analysis with state-of-the-art works exhibits that the presented design possesses advantages of compact size and multiple operating modes.


Sign in / Sign up

Export Citation Format

Share Document