A Three-Phase PM Generator with Double Rotors for Low-Head Hydropower – Trial Structure and Basic Characteristics

In this paper the system improvements of PV-inverters with SiC-transistors are demonstrated. The basic characteristics of engineering prototypes of normally-off SiC-JFETs and SiC-MOSFETs were measured and their differences in the application are considered. To demonstrate the improvement in PV-inverter performance, a 5 kW single-phase and a three-phase full bridge inverter with normally-off SiC-JFETs were developed at Fraunhofer ISE. Different switching frequencies up to 144 kHz were applied and the impact on production costs and inverter performance was rated under the aspects of an industrial product development. This means, the influences on the efficiency and power density. In this work, a world record in PV-inverter efficiency of 99 % was achieved in a single-phase inverter and for the three-pase inverter, the power density was tripled with respect to commercially available state of the art PV-inverters.

Download Full-text

Basic Characteristics of 18-leg Three-Phase Laminated-Core Variable Inductor

Journal of the Magnetics Society of Japan ◽

10.3379/msjmag.1205r015 ◽

2012 ◽

Vol 36 (3) ◽

pp. 253-257

Author(s):

Mariko Nagao ◽

Kenji Nakamura ◽

Takashi Ohinata ◽

Kenji Arimatsu ◽

Kunio Sakamoto ◽

...

Keyword(s):

Three Phase ◽

Variable Inductor ◽

Basic Characteristics ◽

Core Variable

Download Full-text

Development of imaging plate for a TEM and its characteristics

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100152471 ◽

1989 ◽

Vol 47 ◽

pp. 100-101

Author(s):

N. Mori ◽

T. Oikawa ◽

Y. Harada ◽

J. Miyahara ◽

T. Matsuo

Keyword(s):

Dynamic Range ◽

Protective Layer ◽

High Sensitivity ◽

Imaging Plate ◽

Phosphor Layer ◽

Imaging Device ◽

X Ray Imaging ◽

New Type ◽

Basic Characteristics ◽

Reading System

The Imaging Plate (IP) is a new type imaging device, which was developed for diagnostic x ray imaging. We have reported that usage of the IP for a TEM has many merits; those are high sensitivity, wide dynamic range, and good linearity. However in the previous report the reading system was prototype drum-type-scanner, and IP was also experimentally made, which phosphor layer was 50μm thick with no protective layer. So special care was needed to handle them, and they were used only to make sure the basic characteristics. In this article we report the result of newly developed reading, printing system and high resolution IP for practical use. We mainly discuss the characteristics of the IP here. (Precise performance concerned with the reader and other system are reported in the other article.)Fig.1 shows the schematic cross section of the IP. The IP consists of three parts; protective layer, phosphor layer and support.

Download Full-text