Three-Phase Grid-Interactive Solar PV-Battery Microgrid Control Based on Normalized Gradient Adaptive Regularization Factor Neural Filter

2020 ◽  
Vol 16 (4) ◽  
pp. 2301-2314 ◽  
Author(s):  
Shubhra Shubhra ◽  
Bhim Singh
Keyword(s):  
Solar Pv ◽  
Adaptive Regularization ◽  
Three Phase ◽  
Neural Filter ◽  
Normalized Gradient ◽  
Microgrid Control

scholarly journals Decoupled Control of Three Phase Grid Connected Solar PV System

2019 ◽  
Vol 9 (2) ◽  
pp. 4218-4222
Keyword(s):  
Solar Energy ◽  
Power Factor ◽  
Control Strategy ◽  
Reactive Power ◽  
Standard Test ◽  
Effective Control ◽  
Solar Pv ◽  
Pv System ◽  
Three Phase ◽  
Decoupled Control

A reliable grid connected Photovoltaic (PV) system require effective control schemes for efficient use of solar energy. This paper presents a three-phase grid tied PV system with decoupled real and reactive power control to achieve desired power factor with Maximum Power Point Tracking (MPPT) controller to get maximum solar energy. The synchronous reference frame (dq) control along with decoupling concept is used to control the DC-AC inverter output, while the Phase Locked Loop (PLL) synchronization technique is used to monitor and synchronize the voltage and current at the grid side. The DC-DC converter with Incremental Conductance (InC) based MPPT model is also designed in this paper due to better accuracy compared to Perturb & Observe (P&O) algorithm. The simulation is performed in MATLAB/SIMULINK and a 31.5 kW PV system is modelled to get 30 kW power with the help of MPPT at Standard Test Conditions (STC). Any power factor value between 0.85 lagging to 0.9 leading can be obtained by changingreference q current in this inverter control strategy. The simulation results show that the change of reactive powerdoes not affecttheactive power values of the system, which verifies the effectiveness of the decoupled control strategy of the inverter.

scholarly journals Maximum power point tracking of a solar PV array using single stage three phase inverter

2018 ◽  
Vol 7 (2.31) ◽  
pp. 97 ◽  
Author(s):  
M Jayakumar ◽  
V Vanitha ◽  
V Jaisuriya ◽  
M Karthikeyan ◽  
George Daniel ◽  
...  
Keyword(s):  
Solar Power ◽  
Maximum Power Point Tracking ◽  
Maximum Power ◽  
Solar Pv ◽  
Maximum Power Point ◽  
Pv Array ◽  
Point Tracking ◽  
Power Point Tracking ◽  
Three Phase ◽  
Power Point

Solar power is widely available around the globe but efficient transfer of solar power to the load becomes a challenging task. There are various methods in which the power transfer can be done, the following work proposes a method for efficient tracking of solar power.  MPPT [ maximum power point tracking] algorithm applied on three phase voltage source inverter connected to solar PV array with a three phase load. MPPT is applied on inverter rather than conventionally applying MPPT on DC-DC converter. Perturb and Observe method is applied in the MPPT algorithm to find the optimal modulation index for the inverter to transfer maximum power from the panel. Sine pulse width modulation technique is employed for controlling the switching pattern of the inverter. The algorithm is programmed for changing irradiation and temperature condition. The system does not oscillate about the MPP point as the algorithm set the system at MPP and does not vary till a variation in irradiation is sensed.  The proposed system can be installed at all places and will reduce the cost, size and losses compared to conventional system. 

Performance of Wind-Electric and Solar-PV Water Pumping Systems for Watering Livestock

1996 ◽  
Vol 118 (4) ◽  
pp. 212-216 ◽  
Author(s):  
B. D. Vick ◽  
R. N. Clark
Keyword(s):  
Single Phase ◽  
Induction Motors ◽  
Solar Pv ◽  
Centrifugal Pumps ◽  
Wind Regime ◽  
Radiation Level ◽  
Pv Systems ◽  
Surface Areas ◽  
Water Pumping ◽  
Three Phase

The water pumping performance of two wind-electric systems is compared to the water pumping performance of two solar-PV systems. The wind-electric systems were rated at 1.0 kW and 1.5 kW at a wind speed of about 12 m/s, and the rotor diameters were 2.75 m and 3.05 m, respectively. The solar-PV systems were rated at 0.1 kW and 0.9 kW at a radiation level of about 1000 W/m2, and the total solar panel surface areas were 1 and 17 m2, respectively. Both wind-electric systems powered three-phase 230 V a-c induction motors with centrifugal pumps. The smaller of the solar-PV systems powered a d-c motor with a diaphragm pump, and the larger one powered a single phase 230 V a-c induction motor with a centrifugal pump. Only a well pumping depth of 30 m was evaluated for both wind-electric and solar-PV water pumping systems. The 0.1 kW and the 0.9 kW solar water pumping systems can provide enough water for 25 and 75 cattle, respectively, if the incident solar radiation is similar to that of Bushland, TX. The 1.0 kW and 1.5 kW wind-electric water pumping systems can provide enough water for 300 and 400 cattle, respectively, if the wind regime is similar to that of Bushland, TX.

Sign in / Sign up

Export Citation Format

Share Document