The evolution of stored energy during heating for specimens of deformed α-brass is quite different from that previously observed for pure metals; the stored energy is much larger and at least three stages of evolution exist. These have been studied for deformation in torsion and tension and the results correlated with measurements of electrical resistivity, density and hardness. The large release of energy in the first two stages is attributed mainly to the return of order destroyed by plastic deformation; the degree of disorder after heavy cold work is much greater than after quenching (part II). However, slight deformation (10% tension) increases the degree of order slightly. The first stage of energy release, below 120 °C, is probably due to rapid reordering assisted by vacancies created during deformation. The second stage represents the bulk of the reordering and some recovery involving rearrangement and annihilation of dislocations. The deformed specimens are probably strain-aged and thus recovery is accompanied by the dispersal of atmospheres of zinc which increases resistivity and decreases density, to some extent counteracting the effects of recovery. The balance of these three processes in stage 2 causes complex behaviour, the magnitude and even the sign of some changes in properties varies with the deformation. Reordering is complete before the beginning of the third stage of further recovery and recrystallization, in which dispersal of atmospheres is again important. Comparison of measurements of energy, resistivity and density suggests that the high concentration of stacking faults contributes to the resistivity. Anneal hardening is observed for the higher deformations and the maximum hardness coincides with the maximum degree of order.
The stored energy of cold work: Predictions from discrete dislocation plasticity
