The Effect of Moisture on the Structural Stability of a Coal Cavity

1986 ◽  
Vol 108 (3) ◽  
pp. 246-253 ◽  
Author(s):  
H. R. Mortazavi ◽  
A. F. Emery ◽  
R. C. Corlett ◽  
W. R. Lockwood

The drying of coal and the associated thermal and moisture-induced stresses are examined with a numerical model to estimate the rate of surface regression in underground coal gasification. The model includes internal convection, diffusion, conduction and flow of liquid, vapor and gas. The structural failure is modeled by three different mechanisms based upon a strength reduction due to heating, drying, or crack formation. Using properties and boundary conditions appropriate to Western United States coal, the model predicts a regression rate which is in qualitative agreement with measured results. Using the model, it is possible to examine different thermal and failure modes and to gain an understanding of some of the mechanisms which may control the surface regression of coal during gasification. These results may be applicable to the formation of rubble during gasification and to internal cavity collapse.

1983 ◽  
Vol 105 (2) ◽  
pp. 145-155 ◽  
Author(s):  
T. L. Eddy ◽  
S. H. Schwartz

A mechanistic computer model is presented which predicts the 3-D cavity growth during the gasification phase of underground coal gasification. Developed for swelling bituminous coals, the model also obtains reasonable cavity width and length values for shrinking sub-bituminous coals. The model predicts cavity shape and burn-through times based on the coal properties, seam thickness, water reacting and the interwell distance. Employing a 2-D boundary layer model to determine the convective diffusion rate of oxygen to the reacting walls, it is found that natural convection diffusion must be included. The model includes flow in the injection region, the swirling, mixing effect in the cavity, and transitions from thick to thin seam geometry. Simulations of the Hanna II, Phase 2 and Pricetown I field tests, as well as a parametric study on Pittsburgh seam coal, are presented.


2014 ◽  
Vol 1 (1) ◽  
pp. 15-24 ◽  
Author(s):  
Dipankar Chatterjee ◽  
◽  
Satish Gupta ◽  
Chebolu Aravind ◽  
Rakesh Roshan

Author(s):  
Marian Wiatowski ◽  
Roksana Muzyka ◽  
Krzysztof Kapusta ◽  
Maciej Chrubasik

AbstractIn this study, the composition of tars collected during a six-day underground coal gasification (UCG) test at the experimental mine ‘Barbara’ in Poland in 2013 was examined. During the test, tar samples were taken every day from the liquid product separator and analysed by the methods used for testing properties of typical coke oven (coal) tar. The obtained results were compared with each other and with the data for coal tar. As gasification progressed, a decreasing trend in the water content and an increasing trend in the ash content were observed. The tars tested were characterized by large changes in the residue after coking and content of parts insoluble in toluene and by smaller fluctuations in the content of parts insoluble in quinoline. All tested samples were characterized by very high distillation losses, while for samples starting from the third day of gasification, a clear decrease in losses was visible. A chromatographic analysis showed that there were no major differences in composition between the tested tars and that none of the tar had a dominant component such as naphthalene in coal tar. The content of polycyclic aromatic hydrocarbons (PAHs) in UCG tars is several times lower than that in coal tar. No light monoaromatic hydrocarbons (benzene, toluene, ethylbenzene and xylenes—BTEX) were found in the analysed tars, which results from the fact that these compounds, due to their high volatility, did not separate from the process gas in the liquid product separator.


Sign in / Sign up

Export Citation Format

Share Document