Blast-Furnace-Gas Cleaning for Iron and Ferromanganese Production

1960 ◽  
Vol 82 (1) ◽  
pp. 68-72 ◽  
Author(s):  
J. S. Mackay ◽  
J. F. Kearns

A process for removing the superfine smokes from ferromanganese blast-furnace gases having low investment and low operating cost is described. This method solves both the air and stream-pollution problems. The ferro blast-furnace gas is cleaned from 10 to 15 grains per cu ft to less than 0.01 grains per cu ft by a wet-washing procedure in a Pease Anthony venturi scrubber. The alkali cyanide stream-pollution problem is solved by the control of pH and complete recycle of the liquors so that the cyanide is stripped by the incoming gas and is subsequently burnt in the stoves or boilerhouse. The liquor is separated from solids in a Dorr thickener. The solids are removed in the underflow as a thick slurry which is either returned to the furnace or dumped in a pit in the ore yard. The overflow is pumped back to the venturi. The chemistry and physical equipment of the process are described.

JOM ◽  
1950 ◽  
Vol 2 (5) ◽  
pp. 746-750
Author(s):  
G. P. Burks

2016 ◽  
Vol 113 (3) ◽  
pp. 303 ◽  
Author(s):  
Sunil Kumar Tripathy ◽  
Soni Jaiswal ◽  
Y. Rama Murthy ◽  
Samik Nag

Author(s):  
Olena Hryhoriivna Levytska ◽  
Yulia Vladimirovna Voytenko ◽  
Anastasiia Oleksiivna Orishechok

The work presents estimated comparative assessment of emissions release in combustion products during work of high–power steam boilers with the use of traditional fuel – natural gas and alternative fuels – blast–furnace and coke–oven gases generated in the process of technological cycle at iron and steel and coke–chemical enterprises. Calculation algorithm is shown and formulas for assessment of carbon content in exhaust gases are defined, conclusions on ecological efficiency of gaseous fuels are given. The purpose of the work was to evaluate the emissions of harmful substances generated during the combustion of natural, blast furnace and coke oven gases, justification of the calculation of carbon content of a given chemical composition and determine the optimal environmental impact of analogues of natural gas. The comparative estimation of pollutant emissions into atmospheric air during combustion of natural, coke oven and blast furnace gases revealed: – high sulfur dioxide emissions from combustion of blast furnace and coke oven gases due to the presence of sulfur compounds in the composition of these gases; – relatively high emissions of nitrogen compounds for natural and coke oven gases and relatively low emissions for blast furnace gas; – сarbon emissions are high for all types of fuels which have been considered, most carbon dioxide gets into  the air when burning natural gas, least – when burning blast furnace gas; – significantly higher methane emissions are observed during the combustion of natural and coke oven gases, respectively, smaller – for blast–furnace gas combustion; – coke oven and natural gases are characterized by low mercury emissions. Comparative assessment of the calculated values of hazardous substances emissions in the combustion products in the process of combustion of natural, coke–oven and blast–furnace gases shows that even at lower working heat of combustion values the coke–oven and blast–furnace gases can compete with natural gas. For the first time, a comparative characterization of the emissions of harmful substances in the combustion of natural, coke oven and blast furnace gases is presented, and it is shown that the gases used in coke and metallurgical industries, which are used as analogues of natural, are logical to use, but require the installation of treatment systems. The paper defines a formula for calculating the carbon content in natural gas from the Urengoy–Uzhhorod gas pipeline. The provided calculations and the introduction of simplified formulas serve as an example for the calculation of emission factors and emissions in assessing the level of safety of existing equipment and can be used in the development of permit documents of enterprises that carry out emissions of harmful substances to the environment.


2021 ◽  
Vol 10 (1) ◽  
pp. 14-18
Author(s):  
Tjatur Udjianto ◽  
Teguh Sasono

Energi telah menjadi kebutuhan mendasar dan sebagai salah satu komponen biaya di dalam industri salah satunya pabrik baja terpadu. Salah satu upaya untuk untuk mengurangi biaya produksi tanpa mempengaruhi hasil atau kualitas produksi adalah dengan memanfaatkan gas buang yang dihasilkan dari proses yang terdapat di pabrik baja terpadu. Salah satu gas buang yang dihasilkan adalah blast furnace gas (BFG) yang dihasilkan dari proses di Blast Furnace Plant. Salah satu cara untuk menurunkan konsumsi energi Listrik Khususnya di Blast furnace plant adalah dengan diaplikasikannya Top-gas Recovery Turbine (TRT). TRT merupakan suatu sistem yang dapat membangkitkan energi listrik dengan memanfaatkan gas buang yang dihasilkan dari bagian atas (top) Blast furnace yang dialirkan melalui Gas cleaning plant untuk selanjutnya memutarkan turbin-generator. Dengan adanya sistem TRT ini, BFG dapat dimanfaatkan secara maksimal dan dapat menambah pasokan listrik sehingga bisa mengurangi biaya energi listrik. Berdasarkan hasil perhitungan kapasitas terpasang TRT adalah sebesar 18 MW. Energi listrik yang dihasilkan adalah sebesar 117.121,5 MWh. Estimasi jumlah penghematan biaya listrik adalah sebesar 120,12 milyar/tahun. Dengan adanya TRT pengurangan emisi CO2 dalam satu tahun adalah sebesar 84,064 ton- CO2.


Metallurgist ◽  
1990 ◽  
Vol 34 (1) ◽  
pp. 10-10
Author(s):  
R. B. Yusupov ◽  
P. V. Lekin ◽  
V. V. Shadrin ◽  
E. L. Negnebeda ◽  
N. K. Gaifullin ◽  
...  

2016 ◽  
Vol 1 (3) ◽  
pp. 53-59
Author(s):  
Venkateshkumar R ◽  
Kishor Kumar ◽  
Prakash B ◽  
Rahul R

Sign in / Sign up

Export Citation Format

Share Document