scholarly journals Discussion: “The Influence of Free Stream Turbulence on the Local Heat Transfer From Cylinders” (Seban, R. A., 1960, ASME J. Heat Transfer, 82, pp. 101–107)

1960 ◽  
Vol 82 (2) ◽  
pp. 107-107 ◽  
Author(s):  
B. H. Sage
1972 ◽  
Vol 94 (1) ◽  
pp. 7-14 ◽  
Author(s):  
L. B. Newman ◽  
E. M. Sparrow ◽  
E. R. G. Eckert

Experiments involving both heat-transfer and turbulence-field measurements were performed to determine the influence of free-stream turbulence on the local heat transfer from a sphere situated in a forced-convection airflow. The research was facilitated by a miniature heat-flux sensor which could be positioned at any circumferential location on the equator of the sphere. Turbulence grids were employed to generate free-stream turbulence with intensities of up to 9.4 percent. The Reynolds-number range of the experiments was from 20,000 to 62,000. The results indicate that the local heat flux in the forward region of the sphere is uninfluenced by free-stream turbulence levels of up to about 5 percent. For higher turbulence levels, the heat-flux increases with the turbulence intensity, the greatest heat-flux augmentation found here being about 15 percent. Furthermore, at the higher turbulence intensities, there appears to be a departure from the half-power Reynolds-number dependence of the stagnation-point Nusselt number. Turbulent separation occurred at Reynolds numbers of 42,000 and 62,000 for a turbulence level of 9.4 percent, these values being well below the transition Reynolds number of 2 × 105 for a sphere situated in a low-turbulence flow.


1960 ◽  
Vol 82 (2) ◽  
pp. 101-107 ◽  
Author(s):  
R. A. Seban

Local heat-transfer coefficients and recovery factors are presented for three different cylinders in a two-dimensional subsonic air flow, with emphasis on the effect of screen-produced turbulence on these quantities. The increase in turbulent intensity so realized produced larger local heat-transfer coefficients, in a way dependent upon the location on the cylinders, through a direct increase in the heat transfer to the laminar boundary layer, through an earlier transition to turbulence, or through an alteration in the character of the separated flow. Alternatively, recovery factors were affected less, being invariant with respect to the turbulent intensity for attached boundary layer flow, but demonstrating large changes in those separated flow regions for which increased free stream turbulence produced substantial changes in the nature of the separated flow.


Author(s):  
Helge Ladisch ◽  
Achmed Schulz ◽  
Hans-Jo¨rg Bauer

Heat transfer measurements on a highly loaded low-pressure turbine airfoil with a separation bubble on the pressure surface are presented. The experiments were conducted in a linear cascade at various free-stream turbulence intensities (Tu1 = 1.6% to 10%) and Reynolds numbers of the inflow. The effect of both quantities on heat transfer, separation and laminar-turbulent transition is quantified. Particle-Image-Velocimetry has been performed to study the characteristics of the separation bubble. The results reveal a considerable influence of the boundary layer separation on the local heat transfer. The size of the separation region is strongly influenced by free-stream turbulence level and Reynolds number.


1978 ◽  
Vol 100 (1) ◽  
pp. 159-168 ◽  
Author(s):  
A. Brown ◽  
R. C. Burton

This paper describes a novel method for measuring the local heat-transfer distribution over a curved surface. The effect of free-stream turbulence intensity, ranging in value from 0.016 to 0.092, on local heat transfer is investigated for a range of Reynolds numbers from 2.0 × 105 to 7.7 × 105. The geometry of the rig was modified to consider three free-stream velocity distributions covering distributions currently in use on suction surfaces of turbine blades. The results are compared with other workers’ experimental results and with available prediction techniques for heat transfer in laminar and turbulent boundary layers. Special attention is paid to the region of boundary-layer transition.


1992 ◽  
Vol 114 (4) ◽  
pp. 827-833 ◽  
Author(s):  
P. K. Maciejewski ◽  
R. J. Moffat

The present research investigates boundary layer heat transfer with very high freestream turbulence, a problem of primary interest in the gas turbine industry where existing boundary layer correlations and codes underpredict local heat transfer rates on first-stage turbine blades and vanes by as much as a factor of three for some engine designs. The problem was studied experimentally by placing a constant-temperature heat transfer surface at various locations in the margin of a turbulent free jet and measuring both the surface heat transfer rate and the turbulence in the free stream. In this experiment, free-stream turbulent fluctuations 20 to 60 percent relative to the mean velocity augment heat transfer 1.8 to 4 times that which would be predicted locally using accepted correlations for turbulent boundary layers at the same Reynolds number.


Sign in / Sign up

Export Citation Format

Share Document