A Superposition Analysis of the Turbulent Boundary Layer in an Adverse Pressure Gradient

1951 ◽  
Vol 18 (1) ◽  
pp. 95-100
Author(s):  
Donald Ross ◽  
J. M. Robertson
Keyword(s):  
Boundary Layer ◽  
Shear Stress ◽  
Wall Shear Stress ◽  
Turbulent Boundary Layer ◽  
Velocity Profile ◽  
Pressure Gradient ◽  
Adverse Pressure Gradient ◽  
Pressure Recovery ◽  
Stress Coefficient ◽  
Wall Shear

Abstract As an interim solution to the problem of the turbulent boundary layer in an adverse pressure gradient, a super-position method of analysis has been developed. In this method, the velocity profile is considered to be the result of two effects: the wall shear stress and the pressure recovery. These are superimposed, yielding an expression for the velocity profiles which approximate measured distributions. The theory also leads to a more reasonable expression for the wall shear-stress coefficient.

Supplementary Boundary-Layer Approximations for Turbulent Flow

1989 ◽  
Vol 111 (4) ◽  
pp. 420-427 ◽  
Author(s):  
L. C. Thomas ◽  
S. M. F. Hasani
Keyword(s):  
Boundary Layer ◽  
Shear Stress ◽  
Wall Shear Stress ◽  
Pressure Gradient ◽  
Adverse Pressure Gradient ◽  
Boundary Layer Flows ◽  
Mean Velocity ◽  
Wide Range ◽  
The Mean ◽  
Wall Shear

Approximations for total stress τ and mean velocity u are developed in this paper for transpired turbulent boundary layer flows. These supplementary boundary-layer approximations are tested for a wide range of near equilibrium flows and are incorporated into an inner law method for evaluating the mean wall shear stress τ0. The testing of the proposed approximations for τ and u indicates good agreement with well-documented data for moderate rates of blowing and suction and pressure gradient. These evaluations also reveal limitations in the familiar logarithmic law that has traditionally been used in the determination of wall shear stress for non-transpired boundary-layer flows. The calculations for τ0 obtained by the inner law method developed in this paper are found to be consistent with results obtained by the modern Reynolds stress method for a broad range of near equilibrium conditions. However, the use of the proposed inner law method in evaluating the mean wall shear stress for early classic near equilibrium flow brings to question the reliability of the results for τ0 reported for adverse pressure gradient flows in the 1968 Stanford Conference Proceedings.

Wall Shear Stress Inference From Two and Three-Dimensional Turbulent Boundary Layer Velocity Profiles

1973 ◽  
Vol 95 (1) ◽  
pp. 61-67 ◽  
Author(s):  
F. J. Pierce ◽  
B. B. Zimmerman
Keyword(s):  
Boundary Layer ◽  
Shear Stress ◽  
Wall Shear Stress ◽  
Turbulent Boundary Layer ◽  
Velocity Profile ◽  
Three Dimensional ◽  
Law Of The Wall ◽  
Layer Velocity ◽  
Wall Shear ◽  
Near Wall

A method is developed to infer a local wall shear stress from a two-dimensional turbulent boundary layer velocity profile using all near-wall data with the Spalding single formula law of the wall. The method is used to broaden the Clauser chart scheme by providing for the inclusion of data in the laminar sublayer and transition region, as well as the data in the fully turbulent near-wall flow region. For a skewed velocity profile typical of pressure driven three-dimensional turbulent boundary layer flows, the method is extended to infer a wall shear stress for a three-dimensional turbulent boundary layer. Either wall shear stress or shear velocity values are calculated for two different sets of three-dimensional experimental data, with good agreement found between calculated and experimental results.

scholarly journals A universal velocity profile for turbulent wall flows including adverse pressure gradient boundary layers

2021 ◽  
Vol 933 ◽  
Author(s):  
Matthew A. Subrahmanyam ◽  
Brian J. Cantwell ◽  
Juan J. Alonso
Keyword(s):  
Boundary Layer ◽  
Shear Stress ◽  
Turbulent Boundary Layer ◽  
Velocity Profile ◽  
Pressure Gradient ◽  
Channel Flow ◽  
Adverse Pressure Gradient ◽  
Turbulent Shear ◽  
Model Parameters ◽  
Mixing Length

A recently developed mixing length model of the turbulent shear stress in pipe flow is used to solve the streamwise momentum equation for fully developed channel flow. The solution for the velocity profile takes the form of an integral that is uniformly valid from the wall to the channel centreline at all Reynolds numbers from zero to infinity. The universal velocity profile accurately approximates channel flow direct numerical simulation (DNS) data taken from several sources. The universal velocity profile also provides a remarkably accurate fit to simulated and experimental flat plate turbulent boundary layer data including zero and adverse pressure gradient data. The mixing length model has five free parameters that are selected through an optimization process to provide an accurate fit to data in the range $R_\tau = 550$ to $R_\tau = 17\,207$ . Because the velocity profile is directly related to the Reynolds shear stress, certain statistical properties of the flow can be studied such as turbulent kinetic energy production. The examples presented here include numerically simulated channel flow data from $R_\tau = 550$ to $R_\tau =8016$ , zero pressure gradient (ZPG) boundary layer simulations from $R_\tau =1343$ to $R_\tau = 2571$ , zero pressure gradient turbulent boundary layer experimental data between $R_\tau = 2109$ and $R_\tau = 17\,207$ , and adverse pressure gradient boundary layer data in the range $R_\tau = 912$ to $R_\tau = 3587$ . An important finding is that the model parameters that characterize the near-wall flow do not depend on the pressure gradient. It is suggested that the new velocity profile provides a useful replacement for the classical wall-wake formulation.

Sign in / Sign up

Export Citation Format

Share Document