Condensation of Refrigerants in Horizontal, Spirally Grooved Microfin Tubes: Numerical Analysis of Heat Transfer in the Annular Flow Regime

1999 ◽  
Vol 122 (1) ◽  
pp. 80-91 ◽  
Author(s):  
S. Nozu ◽  
H. Honda
Keyword(s):  
Heat Transfer ◽  
Flow Regime ◽  
Thick Film ◽  
Annular Flow ◽  
Local Heat Transfer ◽  
Film Condensation ◽  
Observation Study ◽  
Absolute Deviation ◽  
Laminar Film Condensation ◽  
Microfin Tubes

A method is presented for estimating the condensation heat transfer coefficient in a horizontal, spirally grooved microfin tube. Based on the flow observation study performed by the authors, a laminar film condensation model in the annular flow regime is proposed. The model assumes that all the condensate flow occurs through the grooves. The condensate film is segmented into thin and thick film regions. In the thin film region formed on the fin surface, the condensate is assumed to be drained by the combined surface tension and vapor shear forces. In the thick film region formed in the groove, on the other hand, the condensate is assumed to be driven by the vapor shear force. The present and previous local heat transfer data including four fluids (CFC11, HCFC22, HCFC123, and HFC134a) and three microfin tubes are found to agree with the present predictions to a mean absolute deviation of 15.1 percent. [S0022-1481(00)01501-2]

scholarly journals Condensation inside smooth horizontal tubes: Part 1. Survey of the methods of heat-exchange prediction

2015 ◽  
Vol 19 (5) ◽  
pp. 1769-1789 ◽  
Author(s):  
Volodymyr Rifert ◽  
Volodymyr Sereda
Keyword(s):  
Heat Transfer ◽  
Heat Exchange ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Film Condensation ◽  
Experimental Investigations ◽  
Phase Flow ◽  
Transfer Coefficients ◽  
Heat Transfer Coefficients ◽  
Horizontal Tubes

Survey of the works on condensation inside smooth horizontal tubes published from 1955 to 2013 has been performed. Theoretical and experimental investigations, as well as more than 25 methods and correlations for heat transfer prediction are considered. It is shown that accuracy of this prediction depends on the accuracy of volumetric vapor content and pressure drop at the interphase. The necessity of new studies concerning both local heat transfer coefficients and film condensation along tube perimeter and length under annular, stratified and intermediate regimes of phase flow was substantiated. These characteristics being defined will allow determining more precisely the boundaries of the flow regimes and the methods of heat transfer prediction.

An Analytical Study of Laminar Film Condensation: Part 2—Single and Multiple Horizontal Tubes

1961 ◽  
Vol 83 (1) ◽  
pp. 55-60 ◽  
Author(s):  
Michael Ming Chen
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Horizontal Tube ◽  
Vertical Tube ◽  
Film Condensation ◽  
Transfer Coefficients ◽  
Inertia Effects ◽  
Horizontal Tubes ◽  
Laminar Film ◽  
Laminar Film Condensation

The boundary-layer equations for laminar film condensation are solved for (a) a single horizontal tube, and (b) a vertical bank of horizontal tubes. For the single-tube case, the inertia effects are included and the vapor is assumed to be stationary outside the vapor boundary layer. Velocity and temperature profiles are obtained for the case μvρv/μρ ≪ 1 and similarity is found to exist exactly near the top stagnation point, and approximately for the most part of the tube. Heat-transfer results computed with these similar profiles are presented and discussed. For the multiple-tube case, the analysis includes the effect of condensation between tubes, which is shown to be partly responsible for the high observed heat-transfer rate for vertical tube banks. The inertia effects are neglected due to the insufficiency of boundary-layer theory in this case. Heat-transfer coefficients are presented and compared with experiments. The theoretical results for both cases are also presented in approximate formulas for ease of application.

On the Application of Macro-Pipe Two-Phase Heat Transfer Correlations and Flow Regime Maps to Mini-Channels

2006 ◽  
Author(s):  
Avram Bar-Cohen ◽  
Ilai Sher ◽  
Emil Rahim
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Coefficient ◽  
Transfer Coefficient ◽  
Flow Regime ◽  
Annular Flow ◽  
Negative Slope ◽  
Two Phase ◽  
Heat Transfer Correlations ◽  
Two Phase Heat Transfer ◽  
Flow Regime Maps

The present study is aimed at evaluating the ability of conventional “macro-pipe” correlations and regime transitions to predict the two-phase thermofluid characteristics of mini-channel cold plates. Use is made of the Taitel-Dukler flow regime maps, seven classical heat transfer coefficient correlations and two dryout predictions. The vast majority of the mini-channel two-phase heat-transfer data, taken from the literature, is predicted to fall in the annular regime, in agreement with the reported observations. A characteristic heat transfer coefficient locus has been identified, with a positive slope following the transition from Intermittent to Annular flow and a negative slope following the onset of partial dryout at higher qualities. While the classical two-phase heat transfer correlations are generally capable of providing good agreement with the low-quality annular flow data the quality at which partial dryout occurs and the ensuing heat transfer rates are not predictable by the available macro-pipe correlations.

Some Reflections On Sparrow's Work On Similarity Solutions for Laminar Film Condensation On a Vertical Plate

2021 ◽  
Author(s):  
Vijay K. Dhir
Keyword(s):  
Heat Transfer ◽  
Vertical Plate ◽  
Generalized Solution ◽  
Similarity Solutions ◽  
Film Condensation ◽  
Gravitational Acceleration ◽  
Curved Surfaces ◽  
Laminar Film ◽  
Laminar Film Condensation ◽  
Variable Gravity

Abstract In this contribution in honor of Late Prof. E. M. Sparrow, we reflect on the pioneering work of Sparrow and Gregg on the development of similarity solutions for laminar film condensation on a vertical plate. Dhir and Lienhard using this work as a basis developed a generalized solution for isothermal curved surfaces on which gravitational acceleration varied along the surface and for variable gravity situations. Subsequently non-isothermal surfaces were also considered. These studies were publisher earlier in the J. Heat Transfer.

Sign in / Sign up

Export Citation Format

Share Document