Effect of Basicity on the Microstructure of Sinter and Its Application Based on Deep Learning

The influence of the evolution rule of basicity (0.6∼2.4) on the mineral composition and microstructure of sinter is studied by using a polarizing microscope, and the comprehensive application analysis of the drum index, vertical sintering speed, and yield of sinter shows that, over the course of an increase in basicity (0.6∼1.0), the mineral structure changed from the original porphyritic-granular structure to a porphyritic structure. At the same time, there was no calcium ferrite phase in the bonding phase at a basicity of less than 1.0; therefore, the downward trend of the three indicators is obvious. When the basicity was further increased to approximately 1.6, the main structure of the mineral phase changed from a corrosion structure to an interweaving corrosion structure. Because of the existence of a porphyritic-granular structure, the structure of the mineral phase was extremely inhomogeneous and most complex near the basicity of 1.6; although a small amount of calcium ferrite displayed an acicular structure, the drum index appeared to show a very low value. With an increase in basicity to 2.0, the mineral phase structure was dominated by an interweaving corrosion structure with a uniform framework, and the content of calcium ferrite reached the highest value. Moreover, a clear acicular structure developed, and the drum index also increased to the highest value. At a basicity of more than 2.0, a mineral structure began to appear and the corrosion, porphyritic-granular structure, and the drum index also showed a slightly declining trend. Therefore, in the actual production process, basicity should be avoided as far as possible at around 1.0 and 1.6 and it should be controlled at around 2.0. At the same time, based on the mineral facies data set of this paper, the convolutional neural network is used to carry out a simple prediction model experiment on the basicity corresponding to the mineral facies photos, and the effect is quite good, which provides a new idea and method for the follow-up study of mineral facies.

Download Full-text

Electron Microscopy of Human Gallstones

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100065523 ◽

1971 ◽

Vol 29 ◽

pp. 296-297

Author(s):

C. Wolpers ◽

R. Blaschke

Keyword(s):

Electron Microscopy ◽

Room Temperature ◽

Bile Pigment ◽

X Ray Diffraction ◽

Triclinic Crystal System ◽

X Ray ◽

Follow Up Study ◽

Infra Red ◽

Main Components

Scanning microscopy was used to study the surface of human gallstones and the surface of fractures. The specimens were obtained by operation, washed with water, dried at room temperature and shadowcasted with carbon and aluminum. Most of the specimens belong to patients from a series of X-ray follow-up study, examined during the last twenty years. So it was possible to evaluate approximately the age of these gallstones and to get information on the intensity of growing and solving.Cholesterol, a group of bile pigment substances and different salts of calcium, are the main components of human gallstones. By X-ray diffraction technique, infra-red spectroscopy and by chemical analysis it was demonstrated that all three components can be found in any gallstone. In the presence of water cholesterol crystallizes in pane-like plates of the triclinic crystal system.

Download Full-text