Characterization of temporal variations and feedback timescales of exhaust gas recirculation gas properties using high-speed diode laser absorption spectroscopy for next-cycle control of cyclic variability

2018 ◽  
Vol 20 (8-9) ◽  
pp. 945-952
Author(s):  
Gurneesh S Jatana ◽  
Brian C Kaul

Dilute combustion offers efficiency gains in boosted gasoline direct injection engines both through knock-limit extension and thermodynamic advantages (i.e. the effect of γ on cycle efficiency), but is limited by cyclic variability at high dilution levels. Past studies have shown that the cycle-to-cycle dynamics are a combination of deterministic and stochastic effects. The deterministic causes of cyclic variations, which arise from feedback due to exhaust gas recirculation, imply the possibility of using active control strategies for dilution limit extension. While internal exhaust gas recirculation will largely provide a next-cycle effect (short-timescale feedback), the feedback of external exhaust gas recirculation will have an effect after a delay of several cycles (long timescale). Therefore, control strategies aiming to improve engine stability at dilution limit may have to account for both short- and long-timescale feedback pathways. This study shows the results of a study examining the extent to which variations in exhaust gas recirculation composition are preserved along the exhaust gas recirculation flow path and thus the relative importance and information content of the long-timescale feedback pathway. To characterize the filtering or retention of cycle-resolved feedback information, high-speed (1–5 kHz) CO2 concentration measurements were performed simultaneously at three different locations along the low-pressure external exhaust gas recirculation loop of a four-cylinder General Motors gasoline direct injection engine using a multiplexed two-color diode laser absorption spectroscopy sensor system during steady-state and transient engine operation at various exhaust gas recirculation levels. It was determined that cycle-resolved feedback propagates through internal residual gases but is filtered out by the low-pressure exhaust gas recirculation flow system and do not reach the intake manifold. Intermediate variations driven by flow rate and compositional changes are also distinguished and identified.

Author(s):  
James Sevik ◽  
Thomas Wallner ◽  
Michael Pamminger ◽  
Riccardo Scarcelli ◽  
Dan Singleton ◽  
...  

The efficiency improvement and emissions reduction potential of lean and exhaust gas recirculation (EGR)-dilute operation of spark-ignition gasoline engines is well understood and documented. However, dilute operation is generally limited by deteriorating combustion stability with increasing inert gas levels. The combustion stability decreases due to reduced mixture flame speeds resulting in significantly increased combustion initiation periods and burn durations. A study was designed and executed to evaluate the potential to extend lean and EGR-dilute limits using a low-energy transient plasma ignition system. The low-energy transient plasma was generated by nanosecond pulses and its performance compared to a conventional transistorized coil ignition (TCI) system operated on an automotive, gasoline direct-injection (GDI) single-cylinder research engine. The experimental assessment was focused on steady-state experiments at the part load condition of 1500 rpm 5.6 bar indicated mean effective pressure (IMEP), where dilution tolerance is particularly critical to improving efficiency and emission performance. Experimental results suggest that the energy delivery process of the low-energy transient plasma ignition system significantly improves part load dilution tolerance by reducing the early flame development period. Statistical analysis of relevant combustion metrics was performed in order to further investigate the effects of the advanced ignition system on combustion stability. Results confirm that at select operating conditions EGR tolerance and lean limit could be improved by as much as 20% (from 22.7 to 27.1% EGR) and nearly 10% (from λ = 1.55 to 1.7) with the low-energy transient plasma ignition system.


Machines ◽  
2021 ◽  
Vol 10 (1) ◽  
pp. 7
Author(s):  
Diming Lou ◽  
Guokang Lou ◽  
Bo Wang ◽  
Liang Fang ◽  
Yunhua Zhang

Exhaust gas recirculation (EGR) can improve the fuel economy of gasoline direct-injection (GDI) engines, but at the same time it will have a significant impact on emissions. In this paper, the effects of low-pressure exhaust gas recirculation (LP-EGR) and its rate on the main gaseous and particulate emission characteristic of a GDI engine were investigated. The results showed that the particle size distribution of the GDI engine presented bimodal peaks in nucleation and accumulation mode, and the nucleation mode particles comprised the vast majority of the total particles. The effect of LP-EGR on emissions depended on the engine conditions. At low and medium speed, the particle emissions increased with the increase in the EGR rate, while at high speed, a reduction in the particle emission was observed. When the engine operated in full load condition, an increase in the EGR rate reduced the particle number (PN) concentration significantly, but increased the particle mass (PM) concentration. In terms of the gaseous emission, the EGR could reduce as much as 80% of the NOx emission; however, the total hydrocarbons (THC) emission presented an increased trend, and the maximum increase reached 23.5%. At low and medium loads, the EGR could reduce the CO emission, but at high load, the CO emission worsened with the EGR.


Sign in / Sign up

Export Citation Format

Share Document