Reduced Chemical Kinetic Mechanism for the Prediction of Ignition Delay Time and Laminar Flame Velocity of Natural Gas Combustion

Author(s):  
Yasuyuki Sakai ◽  
Yusuke Asano ◽  
Haruki Fujii ◽  
Akira Miyoshi
Author(s):  
Seung Eon Jang ◽  
Jin Park ◽  
Sang Hyeon Han ◽  
Hong Jip Kim ◽  
Ki Sung Jung ◽  
...  

Abstract In this study, the auto ignition with low limit temperature of syngas has been numerically investigated using a 2-D numerical analysis. Previous study showed that auto ignition was observed at above 860 K in co-flow jet experiments using syngas and dry air. However, the auto ignition at this low temperature range could not be predicted with existing chemical mechanisms. Inconsistency of the auto ignition temperature between the experimental and numerical results is thought to be due to the inaccuracy of the chemical kinetic mechanism. The prediction of ignition delay time and sensitivity analysis for each chemical kinetic mechanism were performed to verify the reasons of the inconsistency between the experimental and numerical results. The results which were calculated using the various mechanisms showed significantly differences in the ignition delay time. In this study, we intend to analyze the reason of discrepancy to predict the auto ignition with low pressure and low temperature region of syngas and to improve the chemical kinetic mechanism. A sensitive analysis has been done to investigate the reaction steps which affected the ignition delay time significantly, and the reaction rate of the selected reaction step was modified. Through the modified chemical kinetic mechanism, we could identify the auto ignition in the low temperature region from the 2-D numerical results. Then CEMA (Chemical Explosive Mode Analysis) was used to validate the 2-D numerical analysis with modified chemical kinetic mechanism. From the validation, the calculated λexp, EI, and PI showed reasonable results, so we expect that the modified chemical kinetic mechanism can be used in various low temperature region.


2021 ◽  
Author(s):  
Mark Edward Fuller ◽  
Philipp Morsch ◽  
Franklin Goldsmith ◽  
Karl Alexander Heufer

This article details new ignition delay time experiments carried out on blends of n-pentane and either NO or NO<sub>2</sub> in the rapid compression machine facility at RWTH Aachen University. Further, a new chemical kinetic mechanism is developed which is able to well-reproduce the experiments and significantly improve over recently published mechanisms. <br>This work has particular value for publication as it adopts a systematic, class-based approach to mechanism development for interactions with nitrogenated species. <br>


2021 ◽  
Author(s):  
Mark Edward Fuller ◽  
Philipp Morsch ◽  
Franklin Goldsmith ◽  
Karl Alexander Heufer

This article details new ignition delay time experiments carried out on blends of n-pentane and either NO or NO<sub>2</sub> in the rapid compression machine facility at RWTH Aachen University. Further, a new chemical kinetic mechanism is developed which is able to well-reproduce the experiments and significantly improve over recently published mechanisms. <br>This work has particular value for publication as it adopts a systematic, class-based approach to mechanism development for interactions with nitrogenated species. <br>


Author(s):  
Mazen A. Eldeeb ◽  
Malshana Wadugurunnehalage

Abstract In this work, a chemical kinetic modeling study of the high-temperature ignition and laminar flame behavior of Tetrahydrofuran (THF), a promising second-generation transportation biofuel, is presented. Stochastic Species Elimination (SSE) model reduction approach (Eldeeb and Akih-Kumgeh, Proceedings of ASME Power Conference 2018) is implemented to develop multiple skeletal versions of a detailed chemical kinetic model of THF (Fenard et al., Combustion and Flame, 2018) based on ignition delay time simulations at various pressures and temperature ranges. The detailed THF model contains 467 species and 2390 reactions. The developed skeletal versions are combined into an overall reduced model of THF, consisting of 193 species and 1151 reactions. Ignition delay time simulations are performed using detailed and reduced models, with varying levels of agreement observed at most conditions. Sensitivity analysis is then performed to identify the most important reactions responsible for the observed performance of the reduced model. Reaction rate parameter modification is performed for such reactions in order to improve the agreement of detailed and reduced model predictions with literature experimental ignition data. The work contributes toward improved understanding and modeling of the oxidation kinetics of potential transportation biofuels, especially cyclic ethers.


2019 ◽  
Vol 16 (1) ◽  
pp. 36-42
Author(s):  
Hernando Alexander Yepes-Tumay ◽  
Arley Cardona-Vargas

The effect of ethane on combustion and natural gas autoignition was studied in the present paper. Two fuel mixture of natural gas with high ethane content were considered, 75% CH4 – 25% C2H6 (mixture 1), and 50% CH4 – 50% C2H6 (mixture 2). Natural gas combustion incidence was analyzed through the calculation of energy properties and the ignition delay time numerical calculations along with an ignition mode analysis. Specifically, the strong ignition limit was calculated to determine the effect of ethane on natural gas autoignition. According to the results, ignition delay time decreases for both mixtures in comparison with pure methane. The strong ignition limit shifts to lower temperatures when ethane is present in natural gas chemical composition.  


Author(s):  
Yuswan Muharam ◽  
◽  
Mirza Mahendra ◽  
Dinda Gayatri ◽  
Sutrasno Kartohardjono ◽  
...  

Author(s):  
O. Samimi Abianeh

A new skeletal chemical kinetic mechanism of ethanol reference fuel (including ethanol, iso-octane, n-heptane, and toluene combustion mechanisms) consisting of 62 species and 194 reactions is developed for oxidation and combustion of gasoline blend surrogate fuels. The skeletal ethanol chemical kinetic mechanism is added to the toluene reference fuel (TRF) mechanism (including iso-octane, n-heptane, and toluene combustion mechanisms) using reaction paths and semidecoupling model. The ignition delay and laminar flame speed of the new combustion mechanism were modeled by using several fuel surrogates at different pressures, temperatures, and equivalence ratios. The skeletal chemical kinetic mechanism ignition delay and laminar flame speed are validated by comparison to the available experimental data of the shock tube and plate burner. The results indicate that satisfactory agreement between predictions and experimental measurements are achieved.


2011 ◽  
Vol 39 (12) ◽  
pp. 3263-3268 ◽  
Author(s):  
Albina A. Tropina ◽  
James B. Michael ◽  
Mikhail N. Shneider ◽  
Richard B. Miles

2013 ◽  
Vol 699 ◽  
pp. 111-118
Author(s):  
Rui Shi ◽  
Chang Hui Wang ◽  
Yan Nan Chang

Based on GRI3.0, we study the main chemical kinetics process about reactions of singlet oxygen O2(a1Δg) and ozone O3 with methane-air combustion products, inherit and further develop research in chemical kinetics process with enhancement effects on methane-air mixed combustion by these two molecules. In addition, influence of these two molecules on ignition delay time and flame speed of laminar mixture are considered in our numerical simulation research. This study validates the calculation of this model which cotains these two active molecules by using experimental data of ignition delay time and the speed of laminar flame propagation. In CH4-air mixing laminar combustion under fuel-lean condition(ф=0.5), flame speed will be increased, and singlet oxygen with 10% of mole fraction increases it by 80.34%, while ozone with 10% mole fraction increase it by 127.96%. It mainly because active atoms and groups(O, H, OH, CH3, CH2O, CH3O, etc) will be increased a lot after adding active molecules in the initial stage, and chain reaction be reacted greatly, inducing shortening of reaction time and accelerating of flame speed. Under fuel rich(ф=1.5), accelerating of flame speed will be weakened slightly, singlet oxygen with 10% in molecular oxygen increase it by 48.93%, while ozone with 10% increase it by 70.25%.


Sign in / Sign up

Export Citation Format

Share Document