Analysing integration issues of the microgrid system with utility grid network

2021 ◽  
Vol 22 (1) ◽  
pp. 113-127
Author(s):  
Mulualem Tesfaye ◽  
Baseem Khan ◽  
Om Prakash Mahela ◽  
Hassan Haes Alhelou ◽  
Neeraj Gupta ◽  
...  
Keyword(s):  
Renewable Energy ◽  
Distribution System ◽  
Reactive Power ◽  
Renewable Energy Sources ◽  
Operating Conditions ◽  
Control Mode ◽  
Voltage Source ◽  
Modulation Scheme ◽  
Main Challenge ◽  
Utility Grid

Abstract Generation of renewable energy sources and their interfacing to the main system has turn out to be most fascinating challenge. Renewable energy generation requires stable and reliable incorporation of energy to the low or medium voltage networks. This paper presents the microgrid modeling as an alternative and feasible power supply for Institute of Technology, Hawassa University, Ethiopia. This microgrid consists of a 60 kW photo voltaic (PV) and a 20 kW wind turbine (WT) system; that is linked to the electrical distribution system of the campus by a 3-phase pulse width modulation scheme based voltage source inverters (VSI) and supplying power to the university buildings. The main challenge in this work is related to the interconnection of microgrid with utility grid, using 3-phase VSI controller. The PV and WT of the microgrid are controlled in active and reactive power (PQ) control mode during grid connected operation and in voltage/frequency (V/F) control mode, when the microgrid is switched to the stand-alone operation. To demonstrate the feasibility of proposed microgrid model, MATLAB/Simulink software has been employed. The performance of fully functioning microgrid is analyzed and simulated for a number of operating conditions. Simulation results supported the usefulness of developed microgrid in both mode of operation.

scholarly journals Experimental Assessment of a Centralised Controller for High-RES Active Distribution Networks

Energies ◽  
2018 ◽  
Vol 11 (12) ◽  
pp. 3364 ◽  
Author(s):  
Francisco García-López ◽  
Manuel Barragán-Villarejo ◽  
Alejandro Marano-Marcolini ◽  
José Maza-Ortega ◽  
José Martínez-Ramos
Keyword(s):  
Renewable Energy ◽  
Distribution System ◽  
Reactive Power ◽  
Renewable Energy Sources ◽  
Distribution Networks ◽  
Energy Sources ◽  
Renewable Energy Resources ◽  
Real Time Control ◽  
Control Actions ◽  
Active Distribution Networks

This paper assesses the behaviour of active distribution networks with high penetration of renewable energy sources when the control is performed in a centralised manner. The control assets are the on-load tap changers of transformers at the primary substation, the reactive power injections of the renewable energy sources, and the active and reactive power exchanged between adjacent feeders when they are interconnected through a DC link. A scaled-down distribution network is used as the testbed to emulate the behaviour of an active distribution system with massive penetration of renewable energy resources. The laboratory testbed involves hardware devices, real-time control, and communication infrastructure. Several key performance indices are adopted to assess the effects of the different control actions on the system’s operation. The experimental results demonstrate that the combination of control actions enables the optimal integration of a massive penetration of renewable energy.

scholarly journals Hysteresis Controlled Based Power Quality Improvement in a Renewable Energy Source Connected to Utility grid with BESS Based STATCOM

2021 ◽  
Vol 7 (03) ◽  
pp. 250-255
Keyword(s):  
Renewable Energy ◽  
Digital Signal Processor ◽  
Distribution System ◽  
Distribution Systems ◽  
Fossil Fuels ◽  
Reactive Power ◽  
Neutral Current ◽  
Renewable Energy Sources ◽  
Power Converter ◽  
Energy Sources

This Paper presents a control strategy of the grid interconnected inverter Renewable Energy Sources (RES). This system can achieve the maximum benefits from these grid interconnected inverter when installed in 3-phase 4-wire distribution system. Increasing electrification of daily life causes growing electricity consumption and the rising number of sensitive or critical loads demand for high quality electricity. One of the main problems facing today is that related with the transmission and distribution of electricity. Due to the rapid increase in global energy consumption and the diminishing of fossil fuels, the customer demand for new generation capacities and efficient energy production, delivery and utilization keeps rising. Utilizing distributed generation, renewable energy and energy storage can potentially solve problems as energy shortage. With the increase in load demand, the Renewable Energy Sources (RES) are increasingly connected in the distribution systems which utilizes power electronic Converters/Inverters. The inverter can perform as a multi function device by incorporating active power filter functionality. The inverter can thus be utilized as: 1) power converter to inject power generated from RES to the grid, and 2) shunt APF to compensate current unbalance, load current harmonics, load reactive power demand and load neutral current. All of these functions may be accomplished either individually or simultaneously. This new control concept is demonstrated with extensive MATLAB/Simulink simulation studies and validated through digital signal processor-based laboratory experimental results.

scholarly journals Multifunctional Voltage Source Inverter for Renewable Energy Integration and Power Quality Conditioning

2014 ◽  
Vol 2014 ◽  
pp. 1-10 ◽  
Author(s):  
NingYi Dai ◽  
Chi-Seng Lam ◽  
WenChen Zhang
Keyword(s):  
Renewable Energy ◽  
Power Quality ◽  
Distribution System ◽  
Renewable Energy Sources ◽  
Capacitive Coupling ◽  
Inductive Coupling ◽  
Voltage Source ◽  
Energy Integration ◽  
Voltage Source Inverter ◽  
Renewable Energy Integration

In order to utilize the energy from the renewable energy sources, power conversion system is necessary, in which the voltage source inverter (VSI) is usually the last stage for injecting power to the grid. It is an economical solution to add the function of power quality conditioning to the grid-connected VSI in the low-voltage distribution system. Two multifunctional VSIs are studied in this paper, that is, inductive-coupling VSI and capacitive-coupling VSI, which are named after the fundamental frequency impedance of their coupling branch. The operation voltages of the two VSIs are compared when they are used for renewable energy integration and power quality conditioning simultaneously. The operation voltage of the capacitive-coupling VSI can be set much lower than that of the inductive-coupling VSI when reactive power is for compensating inductive loads. Since a large portion of the loads in the distribution system are inductive, the capacitive-coupling VSI is further studied. The design and control method of the multifunctional capacitive-coupling VSI are proposed in this paper. Simulation and experimental results are provided to show its validity.

scholarly journals Experimental Assessment of a Centralised Controller for High-RES Active Distribution Networks

2018 ◽  
Author(s):  
Francisco de Paula García-López ◽  
Manuel Barragán-Villarejo ◽  
Alejandro Marano-Marcolini ◽  
José María Maza-Ortega ◽  
José Luis Martínez-Ramos
Keyword(s):  
Renewable Energy ◽  
Distribution System ◽  
Reactive Power ◽  
Renewable Energy Sources ◽  
Distribution Networks ◽  
Energy Sources ◽  
Renewable Energy Resources ◽  
Real Time Control ◽  
Control Actions ◽  
Active Distribution Networks

This paper assesses the behaviour of active distribution networks with high penetration of renewable energy sources when the control is performed in a centralised manner. The control assets are the on-load tap changers of transformers at the primary substation, the reactive power injections of the renewable energy sources and the active and reactive power exchanged between adjacent feeders when they are interconnected through a DC link. A scaled-down distribution network is used as testbed to emulate the behaviour of an active distribution system with massive penetration of renewable energy resources. The laboratory testbed involves hardware devices, real-time control, and communication infrastructure. Several key performance indices are adopted to assess the effects of the different control actions on the system operation. The experimental results demonstrate that the combination of control actions enables the optimal integration of a massive penetration of renewable energy.

An Optimal Solution for Eco-reliability Stochastic Modeling of Simultaneous Reconfiguration of Distribution Networks and Allocation of Renewable Energy Resources, Capacitors and D-facts

2020 ◽  
Vol 13 (4) ◽  
pp. 486-495
Author(s):  
Masoumeh Karimi ◽  
Mohammad R.J. Oskuee ◽  
Sajad N. Ravdanegh
Keyword(s):  
Renewable Energy ◽  
Stochastic Modeling ◽  
Distribution System ◽  
Reactive Power ◽  
Renewable Energy Sources ◽  
Market Price ◽  
Distribution Networks ◽  
Energy Resources ◽  
Renewable Energy Resources ◽  
Krill Herd

Objective: A new method based on stochastic modeling of simultaneous optimal reconfiguration of distribution networks and allocation of multiple Distribution STATic COMpensator and renewable energy resources as new developed technologies is suggested in this paper. Background: This problem involves vital uncertain parameters such as: intermittent nature of renewable energy sources, load forecasting and market price errors. Krill Herd Algorithm as a powerful optimization solution is applied to solve suggested problem. Methods: Several effective cost based consequences can be achieved by proposed technique like: DG units installation and operation costs, D-Statcom installation cost, capacitor costs, cost of purchased energy from the transmission network, active and reactive power losses cost, line upgrade cost and distribution system reconfiguration cost. Results: In addition, energy not supplied as a vital reliability index incorporated in the cost function aims to improve network’s reliability efficiently. Conclusion: IEEE 33 bus radial distribution system is used here to check the practicability of the proposed scheme.

scholarly journals Quasi-Z-Source Four-Leg Inverter with PV by using Model Predictive Control Scheme

2019 ◽  
pp. 73-82
Author(s):  
Konda Ramanaiah ◽  
P. Rajasekhar
Keyword(s):  
Renewable Energy ◽  
Model Predictive Control ◽  
Predictive Control ◽  
Renewable Energy Sources ◽  
Operating Conditions ◽  
Solar Irradiation ◽  
Voltage Source ◽  
Three Phase ◽  
Control Scheme ◽  
Wide Range

The Implementation of Quasi-Z-Source Four-Leg Inverter with PV by using Model Predictive Control Scheme is proposed in this paper. In order to reduce the drawbacks of traditional three phase voltage source inverter (VSI). Photovoltaic (PV) is a term which converts the light into electricity. This topology features a wide range of voltage gain which is suitable for applications in renewable energy-based power systems, where the output of the renewable energy sources varies widely with operating conditions such as wind speed, solar irradiation and temperature. To improve the capability of the controller, an MPC scheme is used which implements a discrete-time model of the system. The controller handles each phase current independently, which adds flexibility to the system. The performance of quasi z source three-phase four-leg VSI with PV by using model predictive control (MPC) was simulated using MATLAB Simulink under balanced and unbalanced load conditions as well as single-phase open-circuit fault condition.

Sign in / Sign up

Export Citation Format

Share Document