Systematic measurement errors of local B-coils due to holes

2018 ◽  
Vol 1 (3) ◽  
pp. 8-14 ◽  
Author(s):  
Stan ZUREK
Metrologia ◽  
2021 ◽  
Author(s):  
Ralf D Geckeler ◽  
Matthias Schumann ◽  
Andreas Just ◽  
Michael Krause ◽  
Antti Lassila ◽  
...  

Abstract Autocollimators are versatile devices for angle metrology used in a wide range of applications in engineering and manufacturing. A modern electronic autocollimator generally features two measuring axes and can thus fully determine the surface normal of an optical surface relative to it in space. Until recently, however, the calibration capabilities of the national metrology institutes were limited to plane angles. Although it was possible to calibrate both measuring axes independently of each other, it was not feasible to determine their crosstalk if angular deflections were present in both axes simultaneously. To expand autocollimator calibrations from plane angles to spatial angles, PTB and VTT MIKES have created dedicated calibration devices which are based on different measurement principles and accomplish the task of measurand traceability in different ways. Comparing calibrations of a transfer standard makes it possible to detect systematic measurement errors of the two devices and to evaluate the validity of their uncertainty budgets. The importance of measurand traceability via calibration for a broad spectrum of autocollimator applications is one of the motivating factors behind the creation of both devices and for this comparison of the calibration capabilities of the two national metrology institutes. The latter is the focus of the work presented here.


2019 ◽  
Vol 68 (10) ◽  
pp. 3871-3882 ◽  
Author(s):  
Paolo Attilio Pegoraro ◽  
Kyle Brady ◽  
Paolo Castello ◽  
Carlo Muscas ◽  
Alexandra von Meier

Metrologia ◽  
2016 ◽  
Vol 53 (2) ◽  
pp. S74-S80 ◽  
Author(s):  
Carlo Carobbi ◽  
Francesca Pennecchi

2005 ◽  
Vol 5 (5) ◽  
pp. 8979-9001 ◽  
Author(s):  
C. Rödenbeck ◽  
T. J. Conway ◽  
R. Langenfelds

Abstract. Surface-atmosphere exchange fluxes of CO2, estimated by an interannual atmospheric transport inversion from atmospheric mixing ratio measurements, are affected by several sources of errors, one of which is experimental errors. Quantitative information about such measurement errors can be obtained from regular co-located measurements done by different laboratories or using different experimental techniques. The present quantitative assessment is based on intercomparison information from the CMDL and CSIRO atmospheric measurement programs. We show that the effects of systematic measurement errors on inversion results are very small compared to other errors in the flux estimation (as well as compared to signal variability). As a practical consequence, this assessment justifies the merging of data sets from different laboratories or different experimental techniques (flask and in-situ), if systematic differences (and their changes) are comparable to those considered here. This work also highlights the importance of regular intercomparison programs.


Sign in / Sign up

Export Citation Format

Share Document