Test Method for Theoretical Maximum Specific Gravity and Density of Bituminous Paving Mixtures

2000 ◽  
Author(s):  
2021 ◽  
Vol 3 (2) ◽  
pp. 276-285
Author(s):  
Brigita Suzanna ◽  
Irwan Lie Keng Wong ◽  
Monika Datu Mirring Palinggi

The purpose of this research is to determine the physical properties of clay soil and to analyze the effect of adding coconut shell charcoal ash to the clay soil. The soil samples used in this study came from Tanralili District, Maros Regency, two sample points were taken and the variations in the levels of addition of coconut shell charcoal ash is 0%, 4%, 6%, 8%, 10%. The test method used refers to ASTM (American Society for Testing Materials). The tests carried out were testing the physical properties of the soil in the form of moisture content, specific gravity, Atterberg boundaries, filter analysis, and hydrometer analysis, then a compaction test was carried out to determine the maximum soil density. The results of the test obtained a moisture content value of 28.811%, a specific gravity of 2.58 g / cm3 so that it is classified as organic clay. As well as the plasticity index value of 9.926% with moderate plasticity from the 7% -17% interval. Then from the test results of soil compaction testing with the addition of coconut shell ash, the dry density (gdry) equal to 0.862, 0.886, 0.914, 0.943, 0.962, this means that the soil sample experienced an increase in dry density (gdry) of 11.60%. From the research results it can be concluded that the addition of coconut shell charcoal ash can increase the value of soil dry density so that it can be used to increase the value of the carrying capacity of clay soil.


Author(s):  
Prithvi S. Kandhal ◽  
Rajib B. Mallick ◽  
Mike Huner

Bulk specific gravity of the fine aggregate is used in hot-mix asphalt volumetric-mix design (including Superpave) to determine the amount of asphalt binder absorbed by the aggregate and the percentage of voids in the mineral aggregate. The current test method (AASHTO T84) uses a cone method to establish the saturated surface dry (SSD) condition of the sample, which is necessary to conduct the test. This method does not work satisfactorily for fine aggregates that are very angular and have rough surface texture and, therefore, do not slump readily when in SSD condition. A research project was undertaken to develop automated equipment and a method of establishing the SSD condition of the fine aggregate. The wet sample of the fine aggregate is placed in a rotating drum and subjected to a steady flow of warm air. The temperature gradient of the incoming and outgoing air and the relative humidity of the outgoing air are monitored to establish the SSD condition. Two prototype devices were constructed. The test results obtained with the second prototype device are encouraging and are reported. Further improvements to be made to the second prototype device to improve the repeatability and reproducibility of the test have been identified.


Sign in / Sign up

Export Citation Format

Share Document