Assessment of the adhesion and corrosion resistance of PMMA-SiO2 coatings in synthetic seawater

MRS Advances ◽  
2021 ◽  
Author(s):  
M. S. Merino-Duran ◽  
M. Estévez ◽  
G. Carbajal-De la Torre ◽  
A. R. Hernández-Martínez ◽  
R. Esparza ◽  
...  
Keyword(s):  
Corrosion Resistance ◽  
Synthetic Seawater

Corrosion Resistance of a New Cu-Alloy (Low Ni) vis-à-vis Cu-10Ni Alloy in Sulfide Polluted Synthetic Seawater

2012 ◽  
Vol 585 ◽  
pp. 488-492
Author(s):  
Adeeba F. Khan ◽  
Awanikumar P. Patil ◽  
T. Subba Rao
Keyword(s):  
Corrosion Resistance ◽  
Electrochemical Impedance Spectroscopy ◽  
Impedance Spectroscopy ◽  
Electrochemical Impedance ◽  
Accelerated Corrosion ◽  
Synthetic Seawater ◽  
Cu Alloy

Cu-10Ni alloy suffers accelerated corrosion in sulfide polluted seawater. As an alternative, a new single phased, Cu-28%Zn-5%Ni-5%Mn-2%Fe alloy (hereby referred as CNZ-alloy) is developed and tested for the corrosion resistance in clean and sulfide polluted synthetic seawater. The CNZ-alloy showed better corrosion resistance than the standard Cu-10Ni alloy in both the test solutions i.e. clean and sulfide polluted synthetic seawater with . The results are discussed on the basis of polarization and electrochemical impedance spectroscopy. The better corrosion resistance of CNZ-alloy is attributed to the formation of protective ZnS and MnS2 films.

Microstructures of Ti-1.5 w/o Ni Alloys with Mo and A1 Additions

1975 ◽  
Vol 33 ◽  
pp. 54-55
Author(s):  
Anna C. Fraker
Keyword(s):  
Corrosion Resistance ◽  
Beneficial Effect ◽  
Crevice Corrosion ◽  
Local Corrosion ◽  
Precipitate Size ◽  
Ni Alloys

Small amounts of nickel are added to titanium to improve the crevice corrosion resistance but this results in an alloy which has sheet fabrication difficulties and is subject to the formation of large Ti2Ni precipitates. These large precipitates can serve as local corrosion sites; but in a smaller more widely dispersed form, they can have a beneficial effect on crevice corrosion resistance. The purpose of the present work is to show that the addition of a small amount of Mo to the Ti-1.5Ni alloy reduces the Ti2Ni precipitate size and produces a more elongated grained microstructure. It has recently been reported that small additions of Mo to Ti-0.8 to lw/o Ni alloys produce good crevice corrosion resistance and improved fabrication properties.

Sign in / Sign up

Export Citation Format

Share Document