Occurrence and efficacy of bisphenol A (BPA) treatment in selected municipal wastewater treatment plants, Bangkok, Thailand

2015 ◽  
Vol 72 (3) ◽  
pp. 463-471 ◽  
Author(s):  
Intira Pookpoosa ◽  
Ranjna Jindal ◽  
Daisy Morknoy ◽  
Kraichat Tantrakarnapa
Keyword(s):  
Wastewater Treatment ◽  
Bisphenol A ◽  
Activated Sludge ◽  
Removal Efficiency ◽  
Municipal Wastewater ◽  
Wastewater Treatment Plants ◽  
Nutrients Removal ◽  
Municipal Wastewater Treatment ◽  
Treatment Processes ◽  
Municipal Wastewater Treatment Plants

Investigations were carried out on the occurrence and fate of bisphenol A (BPA) in five wastewater treatment plants (WWTPs) in Bangkok, namely, Rattanakosin, Chong Non Si, Din Daeng (DD), Nong Khaem and Thungkru (TK) during three sampling events between October 2013 and February 2014. Based on the results, the influent and effluent BPA concentrations ranged between 128.5 ng/L and 606.0 ng/L; and 38.7 ng/L and 270.5 ng/L, respectively. The effluent BPA concentrations of most of the five WWTPs were lower than the influent levels. TK had the highest removal efficiency in October 2013 (80.4%) and December 2013 (90.7%) and the second highest in February 2014 (69.2%). DD had the highest removal efficiency in February 2014 (91.8%). The treatment processes employed at TK and DD were vertical loop reactor activated sludge process and activated sludge with nutrients removal, respectively. Thus, these processes seem to be good for BPA degradation.

PARAMETERS FOR DYNAMIC SIMULATION OF W ASTEW ATER TREATMENT PLANTS WITH HIGH-RATE AND LOW-RATE ACTIVATED SLUDGE TANKS

1994 ◽  
Vol 30 (4) ◽  
pp. 211-214 ◽  
Author(s):  
E. Brands ◽  
M. Liebeskind ◽  
M. Dohmann
Keyword(s):  
Wastewater Treatment ◽  
Activated Sludge ◽  
Dynamic Simulation ◽  
Municipal Wastewater ◽  
Wastewater Treatment Plants ◽  
High Rate ◽  
Yield Coefficient ◽  
Municipal Wastewater Treatment ◽  
Municipal Wastewater Treatment Plants ◽  
Low Rate

This study shows a comparison of important parameters for dynamic simulation concerning the highrate and low-rate activated sludge tanks of several municipal wastewater treatment plants. The parameters for the dynamic simulation of the single-stage process are quite well known, but parameters for the high-ratellow-rate activated sludge process are still missi ng, although a considerable number of wastewater treatment plants are designed and operated that way. At present any attempt to simulate their operation is restricted to the second stage due to missing data concerning growth rate, decay rate, yield coefficient and others.

Characterization of wastewater and activated sludge from European municipal wastewater treatment plants using the NUR test

1998 ◽  
Vol 38 (1) ◽  
pp. 303-310 ◽  
Author(s):  
V. Naidoo ◽  
V. Urbain ◽  
C. A. Buckley
Keyword(s):  
Wastewater Treatment ◽  
Activated Sludge ◽  
Municipal Wastewater ◽  
Wastewater Treatment Plants ◽  
Municipal Wastewater Treatment ◽  
Batch Tests ◽  
Denitrification Kinetics ◽  
Municipal Wastewater Treatment Plants

Denitrification kinetics and wastewater characterization of eight different plants in Europe are discussed. Denitrification batch tests revealed three distinct rates except in the cases of Plaisir, Rostock and Orense where 4 rates were observed. The latter three plants revealed atypical rapid initial rates which were between 7 and 21 mgN/gVSS.h. All denitrification kinetics under non-limiting carbon conditions revealed fast first rates which ranged between 3.0 and 7.3 mgN/gVSS.h. Acetate was used to simulate denitrification kinetics with readily biodegradable COD present. Two subsequent rates were observed. Rates 2 and 3 ranged between 2 and 3 mgN/gVSS.h, and 1 and 2 mgN/gVSS.h, respectively. The RBCOD fraction varied between 10 and 19%, except for one of the plants where the value determined was 7%.

Sign in / Sign up

Export Citation Format

Share Document