scholarly journals P- and S-wave seismic attenuation for deep natural gas exploration and development

2005 ◽  
Author(s):  
Joel Walls ◽  
Richard Uden ◽  
Scott Singleton ◽  
Rone Shu ◽  
Gary Mavko
Keyword(s):  
Natural Gas ◽  
Seismic Attenuation ◽  
S Wave ◽  
Exploration And Development

scholarly journals Novel Use of P- and S-Wave Seismic Attenuation for Deep Natural Gas Exploration and Development

2007 ◽  
Author(s):  
Joel Walls ◽  
M Taner ◽  
Richard Uden ◽  
Scott Singleton ◽  
Naum Derzhi ◽  
...  
Keyword(s):  
Natural Gas ◽  
Seismic Attenuation ◽  
S Wave ◽  
Exploration And Development

scholarly journals Simulation of seismic waves at the earth's crust (brittle–ductile transition) based on the Burgers model

Solid Earth ◽  
2014 ◽  
Vol 5 (2) ◽  
pp. 1001-1010 ◽  
Author(s):  
J. M. Carcione ◽  
F. Poletto ◽  
B. Farina ◽  
A. Craglietto
Keyword(s):  
Seismic Waves ◽  
In Situ Stress ◽  
Seismic Attenuation ◽  
Earth’S Crust ◽  
S Wave ◽  
Fourier Pseudospectral Method ◽  
Stress Criterion ◽  
Brittle Ductile Transition ◽  
Earth's Crust

Abstract. The earth's crust presents two dissimilar rheological behaviors depending on the in situ stress-temperature conditions. The upper, cooler part is brittle, while deeper zones are ductile. Seismic waves may reveal the presence of the transition but a proper characterization is required. We first obtain a stress–strain relation, including the effects of shear seismic attenuation and ductility due to shear deformations and plastic flow. The anelastic behavior is based on the Burgers mechanical model to describe the effects of seismic attenuation and steady-state creep flow. The shear Lamé constant of the brittle and ductile media depends on the in situ stress and temperature through the shear viscosity, which is obtained by the Arrhenius equation and the octahedral stress criterion. The P and S wave velocities decrease as depth and temperature increase due to the geothermal gradient, an effect which is more pronounced for shear waves. We then obtain the P−S and SH equations of motion recast in the velocity-stress formulation, including memory variables to avoid the computation of time convolutions. The equations correspond to isotropic anelastic and inhomogeneous media and are solved by a direct grid method based on the Runge–Kutta time stepping technique and the Fourier pseudospectral method. The algorithm is tested with success against known analytical solutions for different shear viscosities. A realistic example illustrates the computation of surface and reverse-VSP synthetic seismograms in the presence of an abrupt brittle–ductile transition.

scholarly journals Natural gas exploration and development in Changqing Oilfield and its prospect in the 13th Five-Year Plan

2016 ◽  
Vol 3 (4) ◽  
pp. 291-304 ◽  
Author(s):  
Hua Yang ◽  
Xinshe Liu ◽  
Daojun Huang ◽  
Yifei Lan ◽  
Shaofei Wang
Keyword(s):  
Natural Gas ◽  
Exploration And Development

scholarly journals Fractional Time Derivative Seismic Wave Equation Modeling for Natural Gas Hydrate

Energies ◽  
2020 ◽  
Vol 13 (22) ◽  
pp. 5901
Author(s):  
Yanfei Wang ◽  
Yaxin Ning ◽  
Yibo Wang
Keyword(s):  
Wave Equation ◽  
Natural Gas ◽  
Seismic Wave ◽  
Gas Hydrate ◽  
Wave Equations ◽  
Time Derivative ◽  
Seismic Attenuation ◽  
Equation Modeling ◽  
Natural Gas Hydrate ◽  
Fractional Time Derivative

Simulation of the seismic wave propagation in natural gas hydrate (NGH) is of great importance. To finely portray the propagation of seismic wave in NGH, attenuation properties of the earth’s medium which causes reduced amplitude and dispersion need to be considered. The traditional viscoacoustic wave equations described by integer-order derivatives can only nearly describe the seismic attenuation. Differently, the fractional time derivative seismic wave-equation, which was rigorously derived from the Kjartansson’s constant-Q model, could be used to accurately describe the attenuation behavior in realistic media. We propose a new fractional finite-difference method, which is more accurate and faster with the short memory length. Numerical experiments are performed to show the feasibility of the proposed simulation scheme for NGH, which will be useful for next stage of seismic imaging of NGH.

scholarly journals Downhole distributed acoustic seismic profiling at Skytrain Ice Rise, West Antarctica

2021 ◽  
Author(s):  
Alex Brisbourne ◽  
Mike Kendall ◽  
Sofia Kufner ◽  
Thomas Hudson ◽  
Andrew Smith
Keyword(s):  
Wave Energy ◽  
Drilling Fluid ◽  
Ice Sheet ◽  
Seismic Profile ◽  
Seismic Attenuation ◽  
Weddell Sea ◽  
P Wave ◽  
West Antarctica ◽  
S Wave ◽  
Ice Flow

<p>Antarctic ice sheet history is imprinted in the structure and fabric of the ice column. At ice rises, the signature of ice flow history is preserved due to the low strain rates inherent at these independent ice flow centres. We present results from a distributed acoustic sensing (DAS) experiment at Skytrain Ice Rise in the Weddell Sea Sector of West Antarctica, aimed at delineating the englacial fabric to improve our understanding of ice sheet history in the region. This pilot experiment demonstrates the feasibility of an innovative technique to delineate ice rise structure. Both direct and reflected P- and S-wave energy, as well as surface wave energy, are observed using a range of source offsets, i.e., a walkaway vertical seismic profile (VSP), recorded using fibre optic cable. Significant noise, which results from the cable hanging untethered in the borehole, is modelled and suppressed at the processing stage. At greater depth, where the cable is suspended in drilling fluid, seismic interval velocities and attenuation are measured. Vertical P-wave velocities are high (V<sub>INT</sub> = 4029 ± 244 m s<sup>-1</sup>) and consistent with a strong vertical cluster fabric. Seismic attenuation is high (Q<sub>INT </sub>= 75 ± 12) and contrary to observations in ice sheets over this temperature range. The signal level is too low, and the noise level too high, to undertake analysis of englacial fabric variability. However, modelling of P- and S-wave traveltimes and amplitudes with a range of fabric geometries, combined with these measurements, demonstrates the capacity of the DAS method to discriminate englacial fabric distribution. From this pilot study we make a number of recommendations for future experiments aimed at quantifying englacial fabric to improve our understanding of recent ice sheet history.</p><p> </p>

scholarly journals Seismic Attenuation Anisotropy in the Southernmost Part of the Taupo Volcanic Zone, North Island, New Zealand

2022 ◽  
Author(s):  
◽  
Syuhada, Syuhada
Keyword(s):  
Frequency Dependence ◽  
Seismic Attenuation ◽  
Taupo Volcanic Zone ◽  
S Wave ◽  
Volcanic Zone ◽  
S Waves ◽  
Distance Range ◽  
Uncertainty Estimates ◽  
Q Model ◽  
Attenuation Anisotropy

<p>We investigate the mechanisms of seismic anisotropy and attenuation (1/Q) beneath the southernmost part of the Taupo Volcanic Zone (TVZ) by computing variations in S-wave attenuation factors with the direction of wave polarization. We rotate pairs of horizontal components in steps of 22.5◦ from 0◦ to 67.5◦ and into the radial and transverse directions to search for the optimal separation of the attenuation curves and thereby determine an anisotropy symmetry system. The frequency dependence of Q for the rotated S-waves is estimated by means of the non-parametric generalized inversion technique (GIT) of Castro et al. (1990) using shallow earthquakes (< 40 km depth) recorded by GeoNet within 100 km of Mt. Ruapehu. To analyze the effects on computed attenuation properties of source locations, we divide our dataset into two groups: a “TVZ” group containing earthquakes within the TVZ in a distance range of 5–55 km and a “non-TVZ” group containing earthquakes outside the TVZ in a distance range of 5–50 km. To measure Q, we compute the spectral amplitude decay with distance in terms of empirical functions at 20 separate frequencies in the frequency bands 2–10 Hz and 2– 12 Hz for the TVZ and non-TVZ datasets respectively. We construct homogeneous and two-layer Q models for the TVZ dataset based on characteristic features of the attenuation function, while for outside TVZ we only analyse a homogeneous Q model. The homogeneous Q models obtained for the two datasets indicate that S-waves are more attenuated within the TVZ than outside. The homogeneous Q model for the TVZ dataset reveals that the S-wave is anisotropic at high frequencies ( f > 6 Hz) along N–S/E– W directions with the relation QSE ( f ) = (6.15±1.22) f (1.73±0.12) and QSN ( f ) = (4.14± 1.26) f (2.06±0.14), while the non-TVZ dataset shows a weak frequency dependence of attenuation anisotropy at low frequencies in NE–SW/SE–NW directions giving the power law function QSNE ( f ) = (50.93±1.18) f (0.20±0.10) and QSSE ( f ) = (22.60±1.10) f (0.53±0.06). Here, the uncertainty estimates are 95% confidence intervals. To investigate the variation of attenuation anisotropy with depth within the TVZ, we first calculate Q along propagation paths (< 25 km, which corresponds to a maximum turning point depth of 9 km ) and then using paths of 25–55 km length. Small attenuation anisotropy with low attenuation in the N–S direction for the upper crust of TVZ may be related to heterogenous structure as reported by previous studies. Attenuation anisotropy in the northwest direction yielding lower attenuation inferred for the deeper crust suggests the presence of connected melt aligned with the extension direction of TVZ .</p>

scholarly journals Simulation of seismic waves at the Earth crust (brittle-ductile transition) based on the Burgers model

2014 ◽  
Vol 6 (1) ◽  
pp. 1371-1400 ◽  
Author(s):  
J. M. Carcione ◽  
F. Poletto ◽  
B. Farina ◽  
A. Craglietto
Keyword(s):  
Seismic Waves ◽  
Grid Method ◽  
In Situ Stress ◽  
Seismic Attenuation ◽  
S Wave ◽  
Fourier Pseudospectral Method ◽  
Stress Criterion ◽  
Brittle Ductile Transition ◽  
The Earth

Abstract. The Earth crust presents two dissimilar rheological behaviours depending on the in-situ stress-temperature conditions. The upper, cooler, part is brittle while deeper zones are ductile. Seismic waves may reveal the presence of the transition but a proper characterization is required. We first obtain a stress–strain relation including the effects of shear seismic attenuation and ductility due to shear deformations and plastic flow. The anelastic behaviour is based on the Burgers mechanical model to describe the effects of seismic attenuation and steady-state creep flow. The shear Lamé constant of the brittle and ductile media depends on the in-situ stress and temperature through the shear viscosity, which is obtained by the Arrhenius equation and the octahedral stress criterion. The P- and S-wave velocities decrease as depth and temperature increase due to the geothermal gradient, an effect which is more pronounced for shear waves. We then obtain the P-S and SH equations of motion recast in the velocity-stress formulation, including memory variables to avoid the computation of time convolutions. The equations correspond to isotropic anelastic and inhomogeneous media and are solved by a direct grid method based on the Runge–Kutta time stepping technique and the Fourier pseudospectral method. The algorithm is tested with success against known analytical solutions for different shear viscosities. A realistic example illustrates the computation of surface and reverse-VSP synthetic seismograms in the presence of an abrupt brittle-ductile transition.

Sign in / Sign up

Export Citation Format

Share Document