Clinical Applications of a Finite-Element Model of the Human Middle Ear

2001 ◽  
Vol 30 (06) ◽  
pp. 340 ◽  
Author(s):  
Sam J. Daniel ◽  
W. Robert J. Funnell ◽  
Anthony G. Zeitouni ◽  
Melvin D. Schloss ◽  
Jamie Rappaport
2015 ◽  
Vol 66 (1) ◽  
pp. 16-27 ◽  
Author(s):  
Luis A. Vallejo Valdezate ◽  
Antonio Hidalgo Otamendi ◽  
Alberto Hernández ◽  
Fernando Lobo ◽  
Elisa Gil-Carcedo Sañudo ◽  
...  

Author(s):  
Dan Xu ◽  
Houguang Liu ◽  
Lei Zhou ◽  
Gang Cheng ◽  
Jianhua Yang ◽  
...  

Consisting of the actuator and coupling layer, a finite element model of the human middle ear was used to analyze the effect of the actuator and its coupling conditions on the performance of the eardrum-stimulated middle ear implants. This model which was based on the right ear of a healthy adult was built via microcomputed tomography imaging and the technique of reverse engineering. Based on this finite element model, the linear viscoelasticity of the human middle ear soft tissues and three-layer structure of the eardrum pars tensa which was orthotropic were considered. The validity of the model was verified by comparing the model calculated results with experimental data. After that, the influence of the three main design parameters of the actuator and two aspects of the coupling layer were investigated by the finite element model. The results show that (1) the manubrium tip is the optimal position for the actuator to stimulate; (2) the increased cross-section of the actuator would worsen its hearing compensation performance, especially in the low frequencies; (3) both the patients’ residual hearing and the actuator’s hearing compensation performance at high frequencies will be deteriorated with the increase in the actuator’s mass; and (4) a coupling layer with a small Young’s modulus and an area approximating 80% of the eardrum would reduce the stress of the eardrum effectively.


2010 ◽  
Vol 55 (1) ◽  
pp. 19-26 ◽  
Author(s):  
Marc Hoffstetter ◽  
Florian Schardt ◽  
Thomas Lenarz ◽  
Sabine Wacker ◽  
Erich Wintermantel

Micromachines ◽  
2019 ◽  
Vol 10 (11) ◽  
pp. 782 ◽  
Author(s):  
Liu ◽  
Zhao ◽  
Yang ◽  
Rao

To overcome the inherent deficiencies of hearing aids, implantable middle ear hearing devices (IMEHDs) have emerged as a new treatment for hearing loss. However, clinical results show that the IMEHD performance varies with its transducer’s stimulating site. To numerically analyze the influence of the piezoelectric transducer’s stimulating sites on its hearing compensation performance, we constructed a human ear finite element model and confirmed its validity. Based on this finite element model, the displacement stimulation, which simulates the piezoelectric transducer’s stimulation, was applied to the umbo, the incus long process, the incus body, the stapes, and the round window membrane, respectively. Then, the stimulating site’s effect of the piezoelectric transducer was analyzed by comparing the corresponding displacements of the basilar membrane. Besides, the stimulating site’s sensitivity to the direction of excitation was also studied. The result of the finite element analysis shows that stimulating the incus body is least efficient for the piezoelectric transducer. Meanwhile, stimulating the round window membrane or the stapes generates a higher basilar membrane displacement than stimulating the eardrum or the incus long process. However, the performance of these two ideal sites’ stimulation is sensitive to the changes in the excitation’s direction. Thus, the round window membrane and the stapes is the ideal stimulating sites for the piezoelectric transducer regarding the driving efficiency. The direction of the excitation should be guaranteed for these ideal sites.


Sign in / Sign up

Export Citation Format

Share Document