Influence of boron content on hot cracking sensitivity of weld heat affected zone in incoloy 800.

Hot cracking susceptibility of fillers 52 and 82 in 800H and 825 nickel-base superalloys was discussed using the Spot Varestraint test. The fillers of 52 and 82 were added into nickel-base superalloys via a gas tungsten arc welding (GTAW).Experimental results showed that the hot cracking sensitivity of the nickel-base superalloys with filler at high temperature was lower than that without filler. The hot cracking sensitivity had a slight effect when the filler 82 was added. The total length of crack was increased, the liquid-solid (L-S) two-phase range is higher so that the hot cracking susceptibility will be raised. The morphologies of cracks included the intergranular crack in the molten pool, molten pool of solidification cracking, heat-affected zone of intergranular cracks, and transgranular crack in the heat-affected zone.

Download Full-text

Investigation of the influence of the parameters of the laser welding technological process on the chemical composition, structural-phase state and physicochemical properties of the material of the weld, heat-affected zone, pipe body and product

IOP Conference Series Materials Science and Engineering ◽

10.1088/1757-899x/939/1/012068 ◽

2020 ◽

Vol 939 ◽

pp. 012068

Author(s):

V V Savin ◽

L A Savina ◽

V A Chaika ◽

A S Martyushev ◽

S Z Lonchacov

Keyword(s):

Chemical Composition ◽

Laser Welding ◽

Physicochemical Properties ◽

Technological Process ◽

Heat Affected Zone ◽

Phase State ◽

Structural Phase ◽

Structural Phase State ◽

Weld Heat

Download Full-text

Properties of a thick-section narrow-gap gas tungsten arc weld of cast Haynes 282

Welding in the World ◽

10.1007/s40194-021-01077-4 ◽

2021 ◽

Author(s):

Michael Santella ◽

X. Frank Chen ◽

Philip Maziasz ◽

Jason Rausch ◽

Jonathan Salkin

Keyword(s):

Base Metal ◽

Heat Affected Zone ◽

Reference Data ◽

Filler Metal ◽

Stress Rupture ◽

Narrow Gap ◽

Weld Deposit ◽

Gas Tungsten Arc ◽

Gas Tungsten ◽

Weld Heat

AbstractA 50.8-mm-deep gas tungsten arc weld was made with matching filler metal in cast Haynes 282 alloy. The narrow-gap joint was filled with 104 weld beads. Visual and dye-penetrant inspection of cross-weld specimens indicated that the cast base metal contained numerous casting defects. No visible indications of physical defects were found in the weld deposit. The weld heat-affected zone was characterized by microcracking and localized recrystallization. The cause of the cracking could not be determined. Hardness testing showed that a softened region in the as-welded heat-affected zone was nearly eliminated by post-weld heat treatment. Tensile testing up to 816 °C showed that cross-weld specimen strengths ranged from 57 to 79% of the cast base metal tensile strength. The stress-rupture strengths of cross-weld specimens are within 20% of base metal reference data. Failures of both tensile and stress-rupture specimens occurred in the base metal.

Download Full-text